Page 113 of 403
Downloaded from www.Manualslib.com manuals search engine Turn Signal and Lane Change Indicator Lever
The turn signal has two
upward
(for right) and
two downward (for
left) positions. These
positions
allow you to
signal a turn or a lane
change.
Page 114 of 403

Downloaded from www.Manualslib.com manuals search engine L
As you signal a turn or a lane change, if the arrows don't flash but just stay
on a signal bulb may be burned out and othcr drivers won't see your turn
signal.
If a bulb is burned out, replace it to help avoid an accident. If the green
arrows don't
go on at all when you signal a turn. check the fuss (see
''FL~s~s" in the Index) and for t&ned-out bulbs.
Wiper Activated Headlamps
'This featurc activates the headlamps and parking lamps after the
windshield wipers have been in use- for approxinlatelJ7 23 seconds.
The wipcr activated headlamps will deactivatc if vou turn off the twilight
sentinel or if the windshield wipers have been tuined off for a period of
one or two scconds.
Heudlarnp High-Low Beurn
To change the
headlamps
from low
beam to high or high to
low, pull the turn signal
lever
all the way toward
you. Then release it.
When thc high beams
are on, this blue light
on the instrunlent
pallel will also be on.
2-4 1
Page 115 of 403
Downloaded from www.Manualslib.com manuals search engine Flash-To-Pass Feature CI
This lets you use your high beam headlamps to signal a driver ill front of
you that you want to pass. It works even if your I~eadlamps are off.
X> use it, pull the multifunction lever toward you. When you do:
If vour headlamps are off. your high beam headlamps will turn 011.
Tiey'll stay on as long as you hold the lever there. Release the lever to
turn them off.
If vour headlamps are on high beam, they will switch to low beam. To
gc't back to high beam pull the lever toward you.
Windshield Wipers
1
..
I
WIPER: To control thc wipers turn the band on the multifunction lever.
NIIST: Turn the band atwy from you and then release it for a single wipe
cycle. For more cycles
hold the b;md on MIST longer.
LO or HI: Turn the band toward you to cither LO (low speed) or to HI
(high L speed), dcpending L. on the wiper spced you want.
3
Page 116 of 403
Downloaded from www.Manualslib.com manuals search engine DELAE With this vou can set the wiper spccd for a long or short delay
bctwcen wipes. M6vc thc band to t11c DELAY position. The closcr you
move it to LO the shorter the delay.
Windshield Washer
3-43
Page 117 of 403
Downloaded from www.Manualslib.com manuals search engine NOTICE:
When using concentrated washer fluid, follow the
manufacturer's instructions for adding water.
Don't mix water with ready-to-use washer iluid. Water can
cause the solution to freeze and damage your washer fluid
tank and other parts of the washer system.
Also, water
doesn't clean as
well as washer fluid.
Fill your washer fluid tank only 3/4 full when it's very cold.
This allows
for expansion, which could damage the tank if it
is completely
full.
Don't use radiator antifreeze in your windshield washer. It
can damage your washer system and paint.
4
c
Page 118 of 403
Downloaded from www.Manualslib.com manuals search engine CRUISE CONTROL
Page 119 of 403
Downloaded from www.Manualslib.com manuals search engine To Set Cruise Control
.............
.......................... .. ..... ....... ......... ......
.". .... ... .. , ................ . ,. . ..
1. Move the cruise control switch to ON.
c
Page 120 of 403
Downloaded from www.Manualslib.com manuals search engine F
r
r
r
r
P
P
r i
2. Get up to the speed you want.
3. Press the button at
the end of the lever
and release it.
4. The CRUISE
ENGAGED
message will display
on the Driver
Information Center
for
a few seconds
indicating
the cruise
is working.
% $0
5. Take your foot off the accelerator pedal.
2-41