Page 165 of 276

When you call,  tell the  towing service: 
That  your vehicle  cannot be towed 
from  the  front  with  sling-type 
equipment. 
drive. 
vehicle. 
lever. damaged. 
That  your vehicle  has  front-wheel 
The make,  model,  and year  of your 
Whether  you can still  move  the shift 
If there W~S an  accident,  what  was 
When  the towing service  arrives, let the 
tow  operator  know  that this manual 
contains  detailed towing  instructions 
and  illustrations.  The  operator  may 
want  to  see them. 
I should  be clamped  in  a straight-ahead 
When  your vehicle 
is being towed,  have 
the  ignition  key 
off. The  steering  wheel designed for towing service. 
Do not 
use 
the  vehicle’s steering column  lock  for 
this.  The transaxle  should  be in Neutral 
and  the  parking brake released. 
Don’t  have your vehicle towed  on  the 
front  wheels, unless 
you must.  If the 
vehicle  must be towed  on  the  front 
wheels,  don’t go more  than 
35 mph (56 
l
or  your  transaxle  will  be damaged. 
If these 
limits must  be exceeded,  then the front 
wheels have  to be  supported  on  a  dolly. 
1 63 
ProCarManuals.com 
     
        
        Page 166 of 276

Problems on the Road 
164 
Towing  from the Front-Vehicle 
Hook-up 
Before  hooking  up to a tow truck, be  sure 
to  read  all the  information  on 
Towing 
Your Vehicle earlier in this  section. 
Do not tow with  sling-type equipment or 
fascia damage  will occur.  Use  wheel-lift 
or  car carrier  equipment.  Additional 
ramping  may be required for car carrier 
equipment.  Use safety  chains  and  wheel 
straps. 
NOTICE: 
Towing a  vehicle over rough 
surfaces could damage a vehicle. 
Damage  can occur  from  vehicle  to 
ground  or vehicle  to wheel-lift 
equipment.  To help avoid damage, 
install a towing  dolly and raise 
vehicle until  adequate clearance 
is 
obtained between  the ground 
and/or  wheel-lift  equipment. 
Do  not  attach  winch cables or 
J- 
hooks to suspension  components 
when using car carrier  equipment. 
Always  use T-hooks  inserted in the 
T-hook  slots. 
1. Attach T-hook  chains  on  both  sides 
in  the  slotted  holes in the bottom  of 
the  frame  rails, about 
2 feet behind 
the  front  wheels. 
2. Attach a separate  safety chain around 
the  outboard  end  of each  control  arm. 
ProCarManuals.com 
     
        
        Page 167 of 276
Towing from  fhe  Rear-Vehicle 
HOOk-Up 
Before hooking  up  to a  tow  truck,  be 
sure  to read  all the  information 
on 
Towing Your Vehicle earlier  in  this 
section. 
1. Attach  T-hook  chains  on  both  sides 
in  the  slotted holes  in the  frame rails 
just  ahead 
of the  rear  wheels. 
I 
2. Position  the lower  sling  crossbar 
directly  under the rear  bumper.  No 
4x4 wood beam  is needed. 
3. Attach a separate  safety chain around 
the  end  of each axle inboard 
of the 
spring. 
4. Be  certain your  vehicle is towed no 
faster  than 
35 rnph (56 ltm/h)  and  no 
farther  than 
50 miles (80 ltm) to 
avoid damage  to your  transaxle. 
Engine  Overheating 
You  will  find  a coolant  temperature 
gage  on your  Oldsmobile's  instrument 
panel. See  the 
Index under Coolant 
Temperature  Gage. 
1 
165 
ProCarManuals.com 
     
        
        Page 168 of 276

Problems on the Road 
If  Steam Is Coming  From Your 
Engine 
NOTICE: 
If your engine  catches fire because 
you  keep  driving  with no coolant, 
your  vehicle  can be  badly  damaged. 
The  costly  repairs would  not be 
covered  by your  warranty. 
If No Steam  Is Coming  From Your 
€ngine 
If you get the  overheat warning  but see 
or  hear  no  steam,  the  problem may not 
be  too  serious.  Sometimes the engine 
can  get a little  too hot when  you: 
Climb a long hill on a  hot  day. 
Stop after high speed driving. 
Idle  for  long  periods in traffic. 
Tow  a trailer. 
If  you  get  the overheat warning with 
no 
sign  of steam, try this  for a minute  or so: 
1. Turn off your air conditioner. 
2. Turn  on your  heater  to full hot at the 
highest fan speed 
and open  the 
window  as necessary. 
3. Try to keep your engine  under load 
(in  a drive  gear where  the engine 
runs  slower). 
If you no longer have  the overheat 
warning,  you can drive.  Just  to  be safe, 
drive slower  for about  ten  minutes.  If 
the  warning  doesn't  come back 
on, you 
can drive normally. 
If the  warning  continues,  pull over, 
stop,  and park your  vehicle right away. 
If there's still no sign  of  steam, you can 
idle the engine  for two  or  three  minutes 
while  you're  parked,  to  see if the 
warning  stops. But then, 
if you  still 
have  the  warning,  TURN 
OFF THE 
ENGINE AND GET  EVERYONE  OUT 
OF THE VEHICLE  until it  cools  down. 
You may decide not  to lift  the  hood  but 
to  get  service help right away. 
ProCarManuals.com 
     
        
        Page 174 of 276

Problems on the Road 
1 72 
Ifa Tire  Goes Flat 
It’s  unusual for a  tire  to  “blow out” 
while  you’re  driving,  especially  if 
you 
maintain your tires properly.  If air  goes 
out  of a  tire,  it’s much  more likely  to 
leak  out slowly.  But 
if you should  ever 
have  a  “blowout,”  here  are  a  few tips 
about  what to expect  and  what  to  do: 
If a  front  tire  fails, the flat  tire will 
create  a  drag that pulls  the vehicle 
toward  that  side.  Take  your foot 
off the 
accelerator  pedal and grip  the steering 
wheel  firmly.  Steer 
to maintain  lane 
position,  then  gently brake to a  stop 
well 
out of the  traffic  lane. 
A rear  blowout,  particularly on a  curve, 
acts  much  like a skid  and may  require 
the  same  correction  you’d use in a  skid. 
In any  rear  blowout,  remove your foot 
from  the accelerator pedal.  Get the 
vehicle  under  control  by steering  the 
way 
you want  the  vehicle to go. It  may 
be  very  bumpy  and noisy, but you  can 
still  steer.  Gently  brake to a stop,  well 
off  the  road  if possible. 
If a tire  goes  flat,  the  next  section  shows 
how  to 
use your  jacking  equipment  to 
change  a  flat tire  safely. 
Air Inflator 
Your  vehicle  may  have an air  inflator 
for  use  in  bringing  tires  up to  the proper 
pressure. 
To learn  about  it,  see  the 
Index under Air Inflator System. 
Changing a Flat Tire 
If  a  tire  goes flat, avoid  further  tire  and 
wheel  damage  by driving  slowly  to  a 
level  place.  Turn  on your hazard 
warning  flashers. 
ProCarManuals.com 
     
        
        Page 179 of 276
14. Replace the wheel  nuts  with  the 
rounded  end  of the  nuts  toward  the 
wheel.  Tighten  each  nut by hand  until 
the  wheel  is held against  the  hub. 
I 
15. Lower the vehicle  by attaching  the 
folding wrench  to  the jack and 
rotating  the  wrench 
counterclockwise.  Lower the jack 
completely. 
I 
16. Tighten  the wheel  nuts firmly  in  a 
crisscross  sequence  as  shown. 
Stop somewhere  as soon as you  can and 
have  the  nuts  tightened  with a  torque 
wrench.  The  torque  setting  should  be 
100 pound-feet (140 Nmm). 
177 
ProCarManuals.com 
     
        
        Page 181 of 276

I NOTICE: 
Don’t take your compact  spare 
through  an automatic  car wash 
with  guide  rails. The compact  spare 
can  get caught  on  the rails. That 
can  damage  the  tire  and  wheel, and 
maybe  other  parts  of your  vehicle. 
~ 
Don’t  use  your compact  spare on some 
other  vehicle. 
And  don‘t  mix your compact  spare  or 
wheel with  other wheels  or  tires.  They 
won’t  fit.  Keep your spare  and  its whec 
together. 
NOTICE: 
Tire  chains  won’t  fit your compact 
spare.  Using them will damage your 
vehicle  and destroy  the chains  too. 
Don’t  use tire  chains  on your 
compact  spare. 
IfYou%e Stuck: In Sand, 
Mud, Ice or Snow 
What you don’t want to  do  when your 
vehicle  is stuck  is to  spin  your wheels. 
The  method known  as  “rocking” can 
help 
you get  out  when  you’re  stuck,  but 
you  must  use  caution. 
I NOTICE: 
Spinning your wheels can destroy 
parts 
of your vehicle  as well  as the 
tires.  If you  spin  the wheels  too fast 
while shifting your  transaxle back 
and  forth,  you can destroy your 
transaxle. 
Rocking Yowr Vehicle  to  Get  it  Out: 
First,  turn your steering wheel  left and 
right.  That will clear  the area  around 
your  front  wheels. 
If you have  the 
optional  traction  control  system, you 
should  turn it  off.  (See 
Traction CorztroZ 
System in the Index.) Then  shift back 
and  forth between 
R (Reverse) and a 
forward  gear,  spinning  the  wheels as 
little  as possible.  Release the accelerator 
pedal  while  you  shift, and press  lightly 
on  the  accelerator pedal when  the 
transaxle  is in  gear.  If that  doesn’t  get 
you  out after  a few  tries,  you  may  need 
to  be towed  out. If you  do need  to be 
towed  out, see 
Towing Your Vehicle in 
the 
Index. 
1 79 
ProCarManuals.com 
     
        
        Page 192 of 276
Service  &Appearance  Care 
190 
Underhood  Light 
Your underhood  light  will  go  on when 
you  open  the  hood. 
Engine Oil 
It’s  a  good idea to check your engine  oil 
every  time you  get  fuel. In order to get 
an  accurate  reading, the oil must  be 
warm  and  the  vehicle must be on  level 
ground. 
Turn  off the  engine  and give  the oil a 
few  minutes  to drain  back into  the  oil 
pan. 
If you  don’t,  the  oil dipstick  might 
not  show  the actual  level. 
To Check  Engine  Oil 
Pull out the dipstick and clean  it with  a 
paper towel  or cloth,  then  push  it back 
in all  the  way.  Remove it again, keeping 
the  tip  lower, and check  the level. 
3100 V6: Checking  Engine  Oil 
3800 V6: Checking  Engine Oil 
ProCarManuals.com