Page 169 of 276
Cooling System 
When you decide  it’s safe to lift the 
hood,  here’s  what  you’ll see: 
(A) Coolant  recovery  tank 
(B) Radiator  pressure  cap 
(C) Electric engine  fan,  or fans  if you 
have  the 
3800 V6 engine. 
If  the  coolant  inside  the coolant 
recovery  tank is boiling,  don’t do 
anything  else until  it cools  down.  The  coolant 
level should  be  at  or  above 
the 
FULL HOT mark.  If it  isn’t,  you 
may  have a leak  in the  radiator  hoses, 
heater  hoses,  radiator,  water  pump  or 
somewhere  else in  the  cooling  system. 
ProCarManuals.com 
     
        
        Page 170 of 276
Problems on the Road 
1.. 
NOTICE: 
Engine damage from running your 
engine  without  coolant isn’t 
covered  by your warranty.  If 
there  seems  to be 
no leak, check  to 
see  if the  electric engine fan  is running. 
If  the  engine  is overheating,  the fan 
should  be running.  If it isn’t, your 
vehicle needs service. 
How to Add Coolant to the 
Coolant Recovery Tank 
If  you  haven’t  found a problem yet,  but 
the  coolant  level isn’t at  or  above  the 
FULL HOT mark, add a 50/50 mixture 
of 
clean water (preferably distilled) and 
a proper antifreeze  at  the coolant 
recovery  tank. (See 
Engine Coolant in 
the 
Index for more information  about 
the  proper coolant mix.) 
NOTICE: 
In cold  weather,  water  can  freeze 
and  crack  the engine,  radiator, 
heater  core and  other  parts.  Use the 
recommended coolant. 
ProCarManuals.com 
     
        
        Page 173 of 276
5. Put  the cap back  on  the  coolant 
recovery  tank, but leave  the  radiator 
pressure cap  off. 6. Start  the engine and let  it  run until  you 
can  feel the upper radiator hose  getting 
hot.  Watch  out for the  engine  fan(s). 
7. By this time  the coolant  level inside 
the  radiator  filler neck  may be lower. 
If the level is lower, add more of the 
proper  mix through  the filler  neck 
until  the level  reaches  the base  of the 
filler  neck. 
8. Then  replace  the  pressure  cap.  At any 
time  during  this  procedure if coolant 
begins  to 
flow out of the filler  neck, 
reinstall  the  pressure  cap.  Be sure  the 
arrows 
on the  pressure  cap line up 
like  this. 
171 
ProCarManuals.com 
     
        
        Page 183 of 276

Here you will  find  information  about 
the  care  of 
your Oldsmobile . This 
part  begins  with  service  and fuel 
information.  and  then  it  shows how 
to check  important  fluid  and 
lubricant  levels 
. There is  also 
technical  information  about 
your 
vehicle.  and  a section devoted to its 
appearance  care 
. 
Part 6 
Service & Appearance  Care 
Service ........................................................................\
............................................. 182 
Fuel 
........................................................................\
.................................................. 183 
Hood  Release ........................................................................\
................................... 186 
Engine Oil ........................................................................\
........................................ 190 
Air  Cleaner 
........................................................................\
...................................... 194 
Transaxle  Fluid 
........................................................................\
................................ 195 
Engine Coolant 
........................................................................\
................................ 197 
Power  Steering  Fluid 
........................................................................\
....................... 199 
Windshield Washer  Fluid 
........................................................................\
................ 200 
Brakes 
........................................................................\
.............................................. 201 
Battery 
........................................................................\
............................................. 203 
Bulb Replacement 
........................................................................\
........................... 203 
Windshield Wiper Blade Replacement 
................................................................... 205 
Loading  Your Vehicle 
........................................................................\
..................... 206 
Tires 
........................................................................\
................................................. 207 
Appearance  Care ........................................................................\
............................. 212 
Vehicle Identification Number  (VIN) 
.................................................................... 218 
Add-on  Electrical Equipment 
........................................................................\
........ 219 
Fuses & Circuit Breakers ........................................................................\
................ 219 
Capacities  and Specifications 
........................................................................\
......... 224 
Normal  Maintenance  Replacement Parts 
............................................................... 226 
Fluids 
& Lubricants ........................................................................\
........................ 227 
Replacement 
Bulbs ........................................................................\
.......................... 228 
181 
ProCarManuals.com 
     
        
        Page 190 of 276
Service &Appearance  Care 
3100 V6 Engine 
1. Engine  Coolant  Reservoir 
2. Power  Steering  Fluid  Reservoir 
3. Air  Cleaner 
4. Brake Fluid Reservoir 
5. Windshield  Washer  Fluid  Reservoi 
6. Battery  r 
7. Automatic 
Transaxle  Fluid  Dipstick 
8. Engine  Oil  Dipstick 
9. Engine  Oil  Fill Cap 
10. Radiator Cap 
ProCarManuals.com 
     
        
        Page 191 of 276
P 
3800 V6 Engine 
1. Engine Coolant Reservoir 
2. Power Steering  Fluid Reservoir 
3. Automatic  Transaxle  Fluid Dipstick 
4. Brake  Fluid  Reservoir 
5. Windshield Washer  Fluid Reservoir 
6. Battery 
7. Air Cleaner 
8. Engine Oil Dipstick 
9. Engine  Oil  Fill Cap 
10. Radiator Cap 
189 
ProCarManuals.com 
     
        
        Page 195 of 276

As shown in  the  chart,  SAE  5W-30  is 
best  for your vehicle. However,  you can 
use  SAE  1OW-30  if  it’s going 
to be 0°F 
(-18°C)  or above.  These numbers  on an 
oil  container  show 
its viscosity,  or 
thickness. 
Do not use other  viscosity oils, 
such as SAE  1OW-40  or SAE  20W-50. 
If  you  cannot  find oils  with  the  new 
“starburst”  symbol on the  front  of the 
container,  you should  look for and  use 
oils  containing  the following  three things: 
SH or SG 
“SH’ or “SG’ must be on  the oil container, 
either  by  itself  or combined  with  other 
quality  designations, such  as “SHKD,” 
“SH,SG,CD,” “SG/CD,”  etc.  These 
letters  show American Petroleum 
Institute  (API)  levels of quality. 
SAE 1OW-30 (3800 engine) 
SAE 5W-30 (3100  engine) 
Energy Conserving I1 
Oils  with  these  words on  the 
container  will help  you save fuel. 
These  three  things  are usually included 
in  a  doughnut  shaped  logo (symbol)  on 
most  containers. 
If you cannot  find oils 
with  the  “starburst”  symbol, 
you should 
look for oils  with the doughnut  shaped 
symbol,  containing  the  three  things 
noted  above.  If 
you  use oils  that  do  not  have 
either  the  “starburst”  symbol or an 
API  SH or 
SG designation,  you can 
cause  engine damage  not covered 
by  your  warranty. 
GM  Goodwrench@  oil (in  Canada,  GM 
Engine  Oil) meets all  the  requirements 
for your vehicle. 
Engine  Oil  Additives 
Don’t  add  anything  to your  oil. Your 
Oldsmobile dealer  is ready  to advise  if 
you  think  something  should  be  added. 
When to Change  Engine  Oil 
See if any  one of these  is true  for you: 
Most  trips are less  than  4  miles (6 ltm). 
It’s below  freezing  outside  and  most 
trips  are  less than 
10 miles (16 ltm). 
The  engine  is at  low speed most  of the 
time 
(as in door-to-door delivery,  or in 
stop-and-go  traffic). 
You tow a trailer  often. 
Most trips  are  through  dusty  places. 
If any one  of these  is true  for  your  vehicle, 
then  you need  to change your 
oil and 
filter every  3,000  miles (5 000 ltm) or 3 
months - whichever comes  first. 
If  none 
of them  is true,  change  the oil 
every 
7,500 miles  (12 500 ltm) or  12 
months  -whichever  comes first. 
Change  the filter  at  the  first oil change 
and  at every  other oil change  after that. 
Engine  Coolant  Heater  (Engine 
Block  Heater) 
An engine coolant  heater  can be a big 
help  if you have  to park  outside  in very 
cold  weather, 
0°F (-18°C)  or colder.  If 
your vehicle  has  this  option,  see 
Engine 
Coolant Heater in the Index. 193 
ProCarManuals.com 
     
        
        Page 199 of 276

How to Add Fluid 
Refer to  the  Maintenance  Schedule  to 
determine  what  kind of transaxle  fluid 
to  use.  See 
Recommended  Fluids and 
Lubricants 
in  the Index. 
If the  fluid  level  is  low, add only  enough 
of  the  proper  fluid to bring  the level  into 
the  cross-hatched  area 
on the dipstick. 
1. Pull  out  the  dipstick. 
2. Using a long-neck  funnel:  add 
enough  fluid at  the  dipstick hole  to 
bring  it to  the  proper level. 
It  doesn’t  take  much fluid, generally  less 
than  a  pint 
(OSL). Don’t  overfill. We 
recommend  you  use only  fluid  labeled 
DEXRONo-I11  or DEXRON@-IIE, 
because fluids with  that label  are made 
especially  for your automatic  transaxle. 
Damage  caused by fluid  other  than 
DEXRONo-I11  or DEXRONB-IIE  is  not 
covered  by your  new vehicle  warranty. 
After adding fluid, recheck  the fluid 
level  as described  under 
How to 
Check. 
obtained,  push  the dipstick back in  all 
the  way. 
When  the correct  fluid  level  is 
3100 V6: Adding  Automatic  Transaxle 
Fluid 
3800 V6: Adding  Automatic  Transaxle 
Fluid 
Engine Coolant 
The  following  explains your cooling 
system  and how  to add  coolant  when  it 
is 
low. If  you  have  a problem  with 
engine  overheating,  see 
Engine 
Overheating 
in  the Index. 
The proper  coolant for your Oldsmobile 
will: 
Give  freezing  protection  down to-34”F 
Give boiling  protection  up  to  262°F 
Protect against rust  and  corrosion. 
Help keep  the proper engine 
Let  the  warning  lights work as they 
What to Use 
Use a mixture  of one-half clean  water 
(preferably distilled)  and one-half 
antifreeze  that meets 
“GM Specification 
1825-M:” which won’t damage 
aluminum  parts. 
You can also use  a 
recycled  coolant conforming  to 
GM 
Specification  1825-M with  a complete 
coolant flush  and refill. 
If you use this 
mixture, 
you don’t  need to add  anything 
else. 
(-37°C). 
( 12SoC). 
temperature.  should. 
197 
ProCarManuals.com