1994 GMC SIERRA stop start

Parking Lots
If you park in a lot where someone will be watching your vehicle, it’s best
to lock it up and take your keys. But what
if you have to leave your ignition
key? What if you have to leave something valuable
in your vehicle?
0 Put your valuables in a storage area or console.
0 Lock the console.
Lock all the doors except the driver’s.
0 Then take the door key with you.
New Vehide “Break-In”
NOTICE:
Your modern vehicle doesn’t need an elaborate “break-in.” But
it will perform better in the long run if you follow these
guidelines:
Keep your speed at 55 mph (88 km/h) or less for the first
500 miles- (804 km).
Don’t drive at any one speed - fast or slow - for the first
500 miles (804 km). Don’t make full-throttle starts.
0 Avoid making hard stops for the first 200 miles (322 km) or
so. During this time your new brake linings aren’t yet broken
in. Hard stops with new linings can mean premature wear and
earlier replacement. Follow
this “breaking-in” guideline
every time you get new brake linings.
New Vehicle “Break-In” - 3500 HD Model
If you have a 3500 HD model, your parking brake requires a special
break-in procedure. See “Parking Brake” in the Index.
ProCarManuals.com

Automatic Transmission:
Move your shift lever to “P’ (Park) or “N” (Neutral). Your engine won’t
start
in any other position - that’s a safety feature. To restart when you’re
already moving, use
“N” (Neutral) only.
NOTICE:
Don’t try to shift to “P” (Park) if your vehicle is moving. If you
do, you could damage the transmission. Shift to “P” (Park) only
when your vehicle
is stopped.
Hold the clutch pedal to the tloor, then shift your gear selector to neutral
while starting
the engine. Your vehicle won’t start if the clutch pedal is not
all the way down
- that’s a safety feature.
To start your 4.3 Liter (Code 2) V6 or 5.0L (Code H) V8 engine:
1. Without pushing the accelerator pedal, turn your ignition key to “Start.”
When
the engine starts, let go of the key. The idle speed will go down
as your engine gets warm.
NOTICE:
Holding your key in “Start” for longer than 15 seconds at a time
will cause your battery to be drained much sooner. And the excessive heat can damage your starter motor.
2. If it doesn’t start right away, hold your key in “Start.” If it doesn’t start
in three seconds, push the accelerator pedal about one-quarter of the
way down for
12 more seconds, or until it starts.
3. If your engine still won’t start (or starts but then stops), it could be
flooded
with too much gasoline. Try this:
Wait
15 seconds to let the starter motor cool down. Then push your
accelerator pedal all the way to
the tloor. Hold it there. Then, hold the
key in “Start” for no more than ten seconds. This clears the extra
gasoline from the engine.
If
the engine still doesn’t start, wait another 15 seconds and do it all
again.
When
the engine starts, let go of the key and the accelerator pedal.
2- 13
ProCarManuals.com

NOTICE:
Your engine is designed to work with the electronics in your
vehicle.
If you add electrical parts or accessories, you could
change the
way the fuel injection system operates. Before adding
electrical equipment, check with your dealer.
If you don’t, your
engine might not perform properly.
If you ever have to have your vehicle towed, see the part of this
manual that tells how to do it without damaging your vehicle.
See “Towing Your Vehicle” in the Index.
To start your 5.7 Liter (Code K) or 7.4 Liter (Code N) V8 engine:
1. Without pushing the accelerator pedal, turn your ignition key t\
o “Start.”
When the engine starts, let go of the key. The idle speed will go down
as your engine gets warm.
NOTICE:
I
Holding your key in “Start” for longer than 15 seconds at a time
will cause your battery to be drained much sooner. And the
excessive heat can damage your starter motor.
2. If it doesn’t start right away, hold your key in “Start.” If it doesn’t start
in three seconds, push the accelerator pedal about one-quarter
of the
way down for 12 more seconds, or until it starts.
3. If your engine still won’t start (or starts but then stops), \
it could be
flooded with too much gasoline. Try this:
Wait
15 seconds to let the starter motor cool down. Then push your
accelerator pedal all the way to the floor. Hold it there. Then hold the
key in “Start” for no more than ten seconds. This
clears the extra
gasoline from the engine. If the engine still doesn’t start, wait another
15 seconds and do Step
3 again.
Hot Engine Restart (Vehicles With 5.7L LO5 Engine and Over 8500 lbs.
GVWR): If your engine is already hot and then stalls, turn your ignition
key to
OFF. Then, turn your key to RUN, and wait about 20 seconds
before you restart your engine.
When the engine starts, let go of the key and the accelerator pedal.
If your engine is already hot and then stalls, turn your ignition\
key to
OFF.
Then turn your key to “Run” and wait 20 seconds before you restart your
engine. When the engine starts, let go of the key and the accelerator pedal.
2-14
ProCarManuals.com

Starting Your Diesel Englne
Your diesel engine starts differently than a gasoline engine.
1. Automatic Transmission:
Move your shift lever to “P” (Park) or “N” (Neutral). Your engine
won’t start in any other position
- that’s a safety feature. To restart
when you’re already moving, use “N” (Neutral) only.
NOTICE:
Don’t try to shift to “P” (Park) if your vehicle is moving. If you
do, you could damage the transmission. Shift to
“P” (Park) only
when your vehicle is stopped.
2. Manual Transmission:
Move your shift lever to neutral and hold the clutch pedal to the floor
while starting the engine. Your vehicle won’t start if the clutch pedal is
not
all the way down - that’s a safety feature.
Turn your ignition key to
RUN. Don’t turn it to “Start.”
With
the ignition in RUN, the “GLOW PLUGS” light will come on. If
the engine is already warm, this light may not come on. That’s normal.
During starting, your “GLOW PLUGS” light may
go on and off a few
times. This is normal. This means that part
of your engine is being
warmed
up for better starting. When the light goes off, your engine is
ready to start. Do not start the engine with this light on.
NOTICE:
If the “GLOW PLUGS” light stays on, it means that your
vehicle could have one
of several problems, so you should have it
serviced right
away.
3. If this light does not come on, or the instant the light goes off, turn your
ignition key to “Start.” When the engine starts,
let go of the key.
NOTICE:
Holding your key in “Start” for longer than 15 seconds at a time
will cause your battery to be drained much sooner. And the
excessive heat can damage your starter motor.
2-16
ProCarManuals.com

If the light comes on and then goes off and you know your batteries are
charged, but your engine still
won’t start, your vehicle needs service.
If the light does not come on when
the engine is cold, your vehicle needs
service.
If your batteries don’t have enough charge to start your engine, see
“Battery”
in the Index.
Be sure you have the right oil for your engine, and that you’ve changed the
oil at the proper times.
If you use the wrong oil, your engine may be harder
to start.
If
the engine starts, runs a short time, then stops, your vehicle needs service.
1 A CAUTION:
Do not use gasoline or starting “aids,” such as ether, in the air
intake.
They could damage your engine. There could also be a
fire, which could cause serious personal injury.
Engine Coolant Heater (Engine Block Heater)
In very cold weather, 0°F (-I 8°C) or colder, the engine coolant heater can
help. You’ll get easier starting and better fuel economy during engine
warm-up. Usually, the coolant heater should be plugged
in a minimum of
four hours prior to starting your vehicle.
2-19
ProCarManuals.com

0 R (Reverse)
Use this gear to back up.
NOTICE:
Shifting into “R” (Reverse) while your vehicle is moving
forward could damage your transmission. Shift to
“R” (Reverse)
only after your vehicle is stopped.
To rock your vehicle back and forth to get out of snow, ice or sand
without damaging your transmission, see
“If Your Stuck: In Sand, Mud,
Ice or Snow”
in the Index.
N (Neutral)
In this position, your engine doesn’t connect with the wheels. To restart
when you’re already
moving, use “N” (Neutral) only. Also, use “N”
(Neutral) when your vehicle is being towed.
NOTICE:
Damage to your transmission caused by shifting out of “P”
(Park) or “N” (Neutral) with the engine racing isn’t covered by
your warranty.
2-22
ProCarManuals.com

@ (Automatic Overdrive)
This position is for normal driving. If you need more power for
passing, and you’re:
- Going less than about 35 mph (56 km/h), push your accelerator
pedal about halfway down.
- Going about 35 mph (56 kdh) or more, push the accelerator all
the way down.
You’ll shift down to the next gear and have more power.
@ should not be used when towing a trailer, carrying a heavy load,
driving
on steep hills, or for off road driving. Select “D”(third gear)
when operating the vehicle under any
of these conditions.
D (Third Gear)
This is like @, but you never go into Overdrive. You should use “D”
when towing a trailer, carrying a heavy load, driving on steep hills, or
for off-road driving.
2 (Second Gear)
This position gives you more power but lower fuel economy. You can
use
“2” on hills. It can help control your speed as you go down steep
mountain roads, but then you would
also want to use your brakes off
and
on. If you manually select “2”, the transmission will drive in
second gear. You may use this feature for reducing torque to the rear
wheels when
you are trying to start your vehicle from a stop on
slippery road surfaces.
1 (First Gear)
This position gives you even more power (but lower fuel economy)
than
“2.” You can use it on very steep hills, or in deep snow or mud. If
the selector lever is put in “1 ,” the transmission won’t shift into first
gear
until the vehicle is going slowly enough.
b
NOTICE:
If your rear wheels can’t rotate, don’t try to drive. This might
happen if you were stuck in very deep sand or mud or were up
against
a solid object. You could damage your transmission.
Also,
if you stop when going uphill, don’t hold your vehicle there
with only the accelerator pedal. This could overheat and damage
the transmission. Use your brakes
or shift into “P” (Park) to
hold your vehicle in position on a hill.
2-23
ProCarManuals.com

I
Five-Speed Manual Transmission
(With Low Gear)
This is your shift
pattern. Here’s how to
operate your
transmission:
L (Low Gear) is
intended only for
heavy loads and is not
recommended for
normal driving.
0 L (Low Gear) - Press the clutch pedal and shift into “L”. Then,
slowly let up on the clutch pedal as
you press the accelerator pedal.
Shift into
“L” only when the vehicle speed is below 5 mph (8 kdh). Tf
you try to shift into “L” at excessive vehicle speeds, the shift lever will
not move into the “L” position until vehicle speed is reduced.
0 1 (First Gear) - Press the clutch pedal and shift into “1.” Then,
slowly let up
on the clutch pedal as you press the accelerator pedal.
You can shift into “1” when you’re going less than 20 mph (32 km/h).
If you’ve come
to a complete stop and it’s hard to shift into “1,” put the
shift lever in “N” (Neutral) and let up on the clutch. Press the clutch
pedal back down. Then shift into
“I .” If you try to shift into “1” at
excessive vehicle speeds,
the shift lever will not move into the “1”
position until vehicle speed is reduced.
0 2 (Second Gear) - Press the clutch pedal as you let up on the
accelerator pedal and shift into “2.” Then, slowly let up on the clutch
pedal as
you press the accelerator pedal.
0 Higher Gears - Shift into the higher forward gears the same way you
do for
“2.” Slowly let up on the clutch pedal as you press the
accelerator pedal.
To Stop - Let up on the accelerator pedal and press the brake pedal.
Just before the vehicle stops, press the clutch pedal and the brake pedal,
and shift
to “N” (Neutral).
0 N (Neutral) - Use this position when you start or idle your engine.
R (Reverse) - To back up, first press down the clutch pedal. Wait
3-5 seconds for the internal parts to stop spinning and then, shift into
“R.” Let up on the clutch pedal slowly while pressing the accelerator
pedal.
2-24
ProCarManuals.com