1994 CHEVROLET S10 weight

Downloaded from www.Manualslib.com manuals search engine Payload
The iyload Capacity is shown on the Certificatioflire label. This is the
maximum load capacity that your vehicle can carry. Be sure to \
include the
weight of the people inside as part of your load.
If you added any
accessories or equipment after your vehicle left the factory, remember to
subtract the weight of these things from the payload. Your dealer can help
you with this.
Trailering Package
If your vehicle comes with the Trailenng Package, mere is also a load rating
which includes the weight of the vehicle
and the trailer it tows. This rating
is called the Gross Combination Weight Rating (GCWR).
When you weigh your trailer, be sure to include the weight of everything
you put
in it. And, remember to figure the weight of the people inside as
part of your load.
Your dealer can help you determine your
GCWR.
Add-on Equipment
When you carry removable items, you may need to put a limit \
on how many
people you carry inside your vehicle. Be sure to weigh your v\
ehicle before you buy and install the new equipment.
NOTICE:
Your warranty doesn’t cover parrs or components that fail
because of overloading.

Downloaded from www.Manualslib.com manuals search engine Truck-Camper Loading Information
Open your glove box and look for this label:
This label will tell you
if your vehicle can carry a slide-in camper, how
much
of a load your vehicle can carry, and how to spread out your load the
right way.
Also, it will help you match the right slide-in camper to your
vehicle.
When you carry
a slide-in camper, the total cargo load of your vehicle is the
weight
of the camper, plus
everything else added to the camper after it left the factory;
everything in the camper; and
all the people inside.
The Cargo Weight Rating (CWR) is the maximum weight of the load your
vehicle can carry. It doesn’t include the weight of the people inside. But,
vou can figure about
150 pounds for each seat.
I ne total cargo load must not be more than your vehicle’s CWR.

Downloaded from www.Manualslib.com manuals search engine Truck Loading Information
1. Recommended location for cargo center of gravity for cargo weight
Refer to Truck Camper Loading Information label in the glove box for
rating.
“A”and
“B” dimensions.
Use rear edge of load floor for measurement purposes
Example of Proper Truck and Camper Match
1. Camper center of gravity
2. Recommended center of gravity location zone
The camper’.s center of gravity should fall within the center of gravity zone
for your vehicle’s cargo load.

Downloaded from www.Manualslib.com manuals search engine You must weigh any accessories, trailer hitches or other equipment you a\
dd
to your vehicle. Then, subtract this extra weight from the CWR\
. This extra weight may shorten the center of gravity zone for your vehicle. Your dealer
can help you with this.
If your slide-in camper and its load weigh less than the CWR, the center of
gravity zone
for your vehicle may be larger.
Your dealer can help you make a good vehicle-camper match. He’ll also
help you determine your CWR.
After you’ve loaded your vehicle and camper, drive to a wei\
gh station and weigh on the front and rear wheels separately. This will tell you the loads on
your axles. The loads on the front and rear axles shouldn’t be more than
either
of the GAWRs. The total of the axle loads should not be more than
the GVWR.
Open your driver’s door and look at the door lock pillar for the
CertificationD‘ire label to find out your GAWR and GVWR.
11 you ve gone over ; Jr weight ratings, move or take out some things until
all the weights fall below the ratings. Of course, you should always tie down
any loose items when you load your vehicle or camper.
When you install and load your slide-in camper, check the manu\
facturer’s instructions.
If you want more information on curb weights, cargo weights, cargo weight
rating and the correct center of gravity zone for your vehicle, your dealer
can help you. Just ask for a copy of “Consumer Information, Truck
-
Camper Loading.”
Trailer Recommendations
You must subtract your hitch loads from the CWR for your vehicle. Weigh
your vehicle with your trailer attached,
so that you won’t go over the
GVWR or the GAWR.
You’ll get the best performance if you spread out the weight of your load
the right way, and if you choose the correct hitch and trailer brakes.
For more information, see “Trailer Towing’’ in the Index.
Pickup Conversion To Chassis Cab
General Motors is aware that some vehicle owners may consider having the
pickup
box removed and a commercial or recreational body installed.
However, we recommend that conversions of this type not be done to this
pickup. Owners should be aware that, as manufactured, there are differences
between a chassis cab and a pickup with the box removed which\
may affect vehicle safety.
For further information, contact the GM Zone Office for your
area. (See the “Warranty and Owner Assistance” booklet fo\
r Zone Office.)
6 --50

Downloaded from www.Manualslib.com manuals search engine USAGE FLULD/LUIBRICANT
Column Shift, Transfer Chassis lubricant meeting requirements of
Case Shift Lever, Propeller NLGI Grade 2, Catagory LB or GC-LB
Shaft
Slip Splines and (GM Part No. 1052497).
Universal Joints.
Clutch Linkage. Pushrod to Chassis lubricant meeting requirements of
clutch fork joint. NLGI Grade 2, Catagory LB
or GC-LB
(GM Part No. 1052497).
Hood Latch Assembly:
a, Pivots and spring anchor
b. Release Pawl
Front Wheel Bearings a. Engine oil (GM Part No. 1050109).
b. Chassis lubricant meeting requirements of
GM-6031-M (GM Part No. 1052497).
Wheel bearing lubricant meeting
requirements
of NLG Grade 2, Catagory GC
or GC-LB (GM Part No. 1051344).
Constant Velocity
Universal Joint
Automatic Transmission Shift Linkage, Floor Shift
Linkage, Hood and Door
Hinges, Body Door Hinge
Pins, Folding Seat, Fuel Door Hinge
Key Lock Cylinders
Chassis Lubrication
Windshield Washer Solvent
Weatherstrip Chassis lubricant meeting requirements
of
NLG Grade 2, Catagory LB or
GC-LB (GM
Part No. 1052497).
Engine oil (GM Part No. 1050109).
GM Multi-Purpose Lubricant (GM Part No. 12345 120) or a synthetic light weight engine
oil
(SAE 5W-30).
Chassis lubricant meeting requirements of
NLG Grade
2, Catagory LB or GC-LB (GM
Part No. 1052497).
GM Optikleen
TM washer solvent (GM Part
No. 1051515) or equivalent.
Silicone grease (GM Part No. 1052863) or
equivalent.
Tailgate Handle Pivot Multi-purpose lubricant meeting
Points, Hinges, Latch Bolt, requirements of GM Part No. 9985164.
and Linkage
Gas Line
Weather Strips Gas Line De-Icer (GM Part No. 10515 16).
Spray-A-Squeek (GM
Part
No. 1052277).