1994 CHEVROLET CAMARO wheel

Downloaded from www.Manualslib.com manuals search engine Replace the wheel nuts with the rounded
end
of the nuts toward the wheel. Tighten
each nut by hand until the wheel is held
against the
hub.
Lower the vehicle by rotating the wheel
wrench counterclockwise. Lower the jack
completely. Tighten the wheel nuts
firmly in a
criss-cross sequence as shown.
173..

Downloaded from www.Manualslib.com manuals search engine Problems on the Road
Don’t try to put a wheel cover on your
compact spare tire.
It won’t fit. Store the
wheel cover
in the rear area until you
have the flat tire repaired or replaced.
NOTICE:
Wheel covers won’t fit on your com-
pact spare. If you try to put a wheel
cover
on your compact spare, you
could damage the cover or the spare.
. . ,174

Downloaded from www.Manualslib.com manuals search engine Replace the jack, wheel wrench and
flat
tire using the storage instructions.
When
you replace the trim panel, be
sure
to tuck it under the weatherstrip.
1. Trim Panel
2. Bolt
3. Cover
4. Jack
5. Wing Nut
6. Adapter
7. Compact Spare Tire
8. Full-Size Tire
9. Carpet Flap
10. Tire Storage Bolt
175 .I I.

Downloaded from www.Manualslib.com manuals search engine Problems on the Road
Compact Spare Tire
Although the compact spare was fully
inflated when your vehicle was new, it
can lose air after a time. Check the inflation pressure regularly.
It should be
60 psi (420 Wa). After installing the
compact spare on your vehicle, you
should stop as soon as possible and make
sure your spare tire is correctly inflated.
The compact spare is made to perform
well at posted speed limits for distances
up to
3,000 miles (5 000 km). Of course,
it’s best to replace your spare with a
full-size tire as soon as you can. Your
spare will last longer and be in good
shape in case you need
it again.
NOTICE:
If the compact spare is used as a rear
tire, do not drive faster than
50 mph
(80 km/h). Damage to the rear axle
may occur if the compact spare is
driven faster than
50 mph (80 km/h).
This speed limitation does not apply
when the compact spare is used as a
front tire.
NOTICE:
Don’t take your compact spare
through an automatic car wash with
guide rails. The compact spare can
get caught on the rails. That can dam-
age the tire and wheel, and maybe
other parts of your vehicle.
Don’t use your compact spare on some
other vehicle.
And don’t mix your compact spare or
wheel with other wheels or tires. They
won’t fit. Keep your spare and its wheel
together.
NOTICE:
Tire chains won’t fit your compact
spare. Using them will damage your
vehicle and destroy the chains too.
Don’t use tire chains on your com-
pact spare.
. . .176

Downloaded from www.Manualslib.com manuals search engine If You’re Stuck: In
Sand, Mud, Ice or
Snow
What you don’t want to do when your
vehicle
is stuck is to spin your wheels.
The method known as “rocking” can help
you get out
when you’re stuck, but you
must use caution.
NOTICE:
Spinning your wheels can destroy
parts of your vehicle as well as the
tires.
If you spin the wheels too fast
while shifting your transmission
back and forth, you can destroy
your transmission.
Rocking your vehicle to get it out:
First, turn your steering wheel left and
right. That
will clear the area around
your front wheels.
If your vehicle has
ASR, you should turn the system off,
(See “ASR System”
in the Index.)
Then
shift back and forth between “R”
(Reverse) and a forward gear (or with a
manual transmission, between First or
Second gear and Reverse), spinning the
wheels as little as possible. Release the
accelerator pedal while you shift, and
press lightly on the accelerator pedal
when
the transmission is in gear. If that
doesn’t get you out after a
few tries, you
may need to be towed out.
If you do
need
to be towed out, see “Towing Your
Vehicle’’
in the Index.
177..

Downloaded from www.Manualslib.com manuals search engine To Check Brake Fluid:
You can check the brake fluid without
taking off the cap. Just look at the brake
fluid reservoir. The fluid level should be
above the plastic seam
in the reservoir.
If it isn’t, have your brake system
checked to see
if there is a leak.
After work is done on the brake hydraulic
system, make sure the level
is above the
plastic seam, near the base of the filler
neck.
What to Add:
When you do need brake fluid, use only
DOT-3 brake fluid
- such as Delco-
Supreme 1 l@ (GM Part No. 1052535).
Use new brake fluid from a sealed container
only, and always clean the brakt
fluid reservoir cap before removing it.
NOTICE:
0 Don’t let someone put in the
wrong kind
of fluid. For example,
just a few drops
of mineral-based
oil, such as engine oil, in your
brake system can damage brake
system parts
so badly that they’ll
have to be replaced.
0 Brake fluid can damage paint, so
be careful not to spill brake fluid
on your vehicle.
If you do, wash it
off immediately. See ”Appearance
Care”
in the Index.
Brake Wear
Unless you have the four-wheel disc
brake option, your Chevrolet has front
disc brakes and rear drum brakes.
Disc brake pads have built-in wear
indicators that make
a high-pitched
warning sound when the brake pads are
worn and new pads are needed. The
sound may come and go or be heard all
the time your vehicle is moving (except when
you are
pushing on the brake pedal
firmly).
A CAUTION:
The brake wear warning sound
means that sooner or later your
brakes won’t work well. That could
lead to an accident. When you hear
the brake wear warning sound, have
your vehicle serviced.
NOTICE:
Continuing to drive with worn-out
brake pads could result in costly
brake repair.
Some driving conditions or climates may
cause
a brake squeal when the brakes are
first applied or lightly applied. This does
not mean something is wrong
with your
brakes.
203. I

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
When to Check: Check your tires once a
month or more. Don’t forget your
compact spare tire. It should be at
60 psi
(420 kPa).
How to Check: Use a good quality
pocket-type gage to check tire pressure.
Simply looking at the tires will not tell
you the pressure, especially if you have
radial tires
- which may look properly
inflated even
if they’re underinflated.
If your tires have valve caps, be sure to
put them back on. They help prevent
leaks by keeping out dirt and moisture. Tire Inspection and Rotation
To make your tires last longer, have them
inspected and rotated at the mileages
recommended
in the Maintenance
Schedule. See “Scheduled Maintenance
Services” in the Index.
[f you don’t have P245/50ZR16 size tires
use the rotation pattern shown above for
your size tires.
4-
f you have P245/50ZR16 size tires, they
nust roll in
a certain direction for the best
werall performance. The direction is
hown by an arrow on both sidewalls.
3ecause these tires are directional, they
hould be rotated as shown
in the
:xample above. These tires should only
,e moved from front to rear and rear to
ront on the same side of the vehicle.
ifter the tires have been rotated, adjust
he front and rear inflation pressure as
.hown on
the Tire-Loading Information
abel. Make certain that all wheel nuts are
u-operly tightened. See “Wheel Nut
rorque” in the Index.
. . .216

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
Uniform Tire Quality Grading
The following information relates to the
system developed by the United States
National Highway Traffic Safety
Administration which grades tires by
treadwear, traction and temperature
performance. (This applies only to
vehicles sold
in the United States.)
Treadwear
The treadwear grade is a comparative
rating based
on the wear rate of the tire
when tested under controlled conditions
on a specified government test course.
Fa
example, a tire graded 150 would wear
one and a half
(1 1/2) times as well on the
government course as a tire graded
100.
The relative performance of tires depends
upon the actual conditions of their use,
however, and may depart significantly
from the norm due
to variations in driving
habits, service practices and differences in
road characteristics and climate.
Traction - A, B, C
The traction grades, from highest to
lowest are: A,
B, and C. They represent
the tire’s ability to stop
on wet pavement
as measured under controlled conditions
on specified government test surfaces
of
asphalt and concrete. A tire marked C
may have poor traction performance.
Warning: The traction grade assigned to
this tire is based on braking
(straight-ahead) traction tests and does
not include cornering (turning) traction.
Temperature - A, B, C
The temperature grades are A (the
highest),
B, and C, representing the tire’s
resistance to
the generation of heat and its
ability to dissipate heat when tested under
controlled conditions on a specified
indoor laboratory test wheel. Sustained high
temperature can cause the material
of the tire to degenerate and reduce tire
life, and excessive temperature can lead to
sudden tire failure. The grade
C
corresponds to a level of performance
which all passenger car tires must meet
under the Federal Motor Vehicle Safety
Standard
No. 109. Grades B and A
represent higher levels of performance on
the laboratory test wheel than the
minimum required by law.
Warning: The temperature grade for this
tire is established for a tire that is properly
inflated and not overloaded. Excessive speed, underinflation, or excessive
loading, either separately or in
combination, can cause heat buildup and
possible tire failure.
Those grades are molded on the sidewalls
of passenger car tires.
While the tires available as standard or
optional equipment on General Motors
vehicles may vary with respect to these
grades, all such tires meet General Motors
performance standards and have been
approved for use on General Motors
vehicles.
All passenger type (P Metric)
tires must conform to Federal safety
requirements
in addition to these grades.
. . .218