1994 CHEVROLET CAMARO oil dipstick

Downloaded from www.Manualslib.com manuals search engine On the V8 engine you’ll see this:
1. Coolant recovery tank
2. Radiator pressure cap
3. Electric engine fans
A CAUTION:
An electric fan under the hood can
start up even when the engine is not
running and can injure
you. Keep
hands, clothing and tools
away from
any underhood electric fan.
II
If the coolant inside the coolant recovery
tank is boiling, don’t do anything else
until it cools down.
When
it is cool, remove the coolant
recovery tank cap and look at
the dipstick.
The coolant level should be at or above
“FULL COLD.” If it isn’t, you may have
a leak
in the radiator hoses, heater hoses,
radiator,
water pump or somewhere else
in the cooling system.
A CAUTION:
Heater and radiator hoses, and other
engine parts, can be very hot. Don’t
touch them. If you do, you can be
burned.
Don’t
run the engine if there is a
leak. If you run the engine, it could
lose all coolant. That could
cause an
engine fire, and you could be burned.
Get any leak fixed before you drive
the vehicle.
NOTICE:
Engine damage from running your
engine without coolant isn’t covered
by your warranty. I
If there seems to be no leak, check to see
if the electric engine fan is running. If the
engine
is overheating, the fan should be
running.
If it isn’t, your vehicle needs
service.
159. I

Downloaded from www.Manualslib.com manuals search engine When you open the hood you'll see:
1. Battery
2. Engine Coolant Reservoir
3. Engine Oil Dipstick
4. Automatic Transmission Dipstick
5. Air Cleaner (if equipped)
3.4L L32 (Code S
6. Oil Fill Cap
7. Brake Fluid Reservoir
8. Power Steering Reservoir
9. Windshield Washer Reservoir
10. Engine Fan
11. Clutch Fluid Reservoir (if equipped)
L
185 ...

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
5.7L LT1 (Code P)
Vhen you open the hood you’ll see:
1. Battery
2. Engine Coolant Reservoir
3. Engine Oil Dipstick
4. Automatic Transmission Dipstick
5. Air Cleaner
(if equipped)
6. Oil Fill Cap
7. Brake Fluid Reservoir
8. Power Steering Reservoir
9. Windshield Washer Reservoir
10. Engine Fans
11. Clutch Fluid Reservoir (if equipped) Before
closing the hood, be sure all the
filler
caps are on.
Then just pull the hood down and close
it firmly.
. . .186

Downloaded from www.Manualslib.com manuals search engine LOW OIL
Engine Oil
If the “LOW OIL” light on the instrument
panel comes on,
it means you need to
check your engine oil level right away.
For more information, see “Low Oil
Light” in the Index. You should check
your engine oil level regularly; this
is an
added reminder.
3.4L L32 (Code S)
It’s a good idea to check your engine oil
every time you get fuel. In order to get an
accurate reading, the oil must be warm
and the vehicle must be
on level ground.
5.7L LTl (Code P)
rurn off the engine and give the oil a few
ninutes to drain
back into the oil pan. If
rrou don’t, the
oil dipstick might not show
he actual level.
187 ...

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
”,
d
4
To Check Engine Oil
(3.4L L32 (Code S) Engine)
Pull out the dipstick and clean it with a
paper towel or cloth, then push it back in
all the way. Remove it again, keeping the
tip lower, and check the level.
IC
To Check Engine Oil
(5.7L LTl (Code P) Engine)
Pull out the dipstick slightly. Pinch the
end
of the dipstick tube as you remove
the dipstick to wipe the oil from it. Then
push it all the way back in. Now remove
it without pinching the tube, keeping the
tip lower.
3.4L L32 (Code S)
When to Add Oil:
f the oil is at or below the “ADD” line,
hen you’ll need to add some oil. But you
nust use the right kind. This section
:xplains what kind
of oil to use. For
:rankcase capacity, see “Capacities and
ipecifications” in the Index.
. . .I88

Downloaded from www.Manualslib.com manuals search engine NOTICE:
Don’t add too much oil. If your engine
has
so much oil that the oil level gets
above the cross-hatched area that shows the proper operating range, your engine
could be damaged.
5.7L LT1 (Code P)
lust fill it enough to put the level some-
where
in the proper operating range. Push
:he dipstick all the
way back in when you’re
:hrough.
What Kind of Oil to Use:
Beginning midyear 1993, oils of the
proper quality for your vehicle will be
identified with
this new “starburst”
symbol. The “starburst” symbol
indicates that the
oil has been certified
by the American Petroleum Institute
(API), and
is preferred for use in your
gasoline engine.
You should look for this on the front of
the
oil container, and use only oils that
display this new symbol.
You should also use the proper
viscosity
oil for your vehicle, as shown
in the following chart.
189.. .

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
Automatic Transmission FIuid
When to Check and Change:
A good time to check your automatic
transmission fluid level is when the
engine oil is changed. Refer to the
Maintenance Schedule to determine when
to change your fluid. See “Scheduled
Maintenance Services” in the Index.
How to Check:
Because this operation can be a little
difficult, you may choose to have this
done at a Chevrolet dealership Service
Department.
If
you do it yourself, be sure to follow all
the instructions here, or
you could get a
false reading on the dipstick.
NOTICE:
Too much or too little fluid can dam-
age your transmission.
Too much can
mean that some of the fluid could
come out and fall on hot engine parts
or exhaust system, starting a fire. Be
sure to get an accurate reading if you
check your transmission fluid.
. . ,194
Wait at least 30 minutes before checking
the transmission fluid level
if you have
been driving:
When outside temperatures are above
90°F (32°C).
0 At high speed for quite a while.
0 In heavy traffic - especially in hot
weather.
While pulling a trailer.
To get the right reading, the fluid should
be at normal operating temperature,
which is 180°F to
200°F (82°C to 93°C).
To check transmission fluid hot: Get
the vehicle warmed up
by driving
about
15 miles (24 km) when outside
temperatures are above 50°F (10°C). If
it’s colder than
50°F (lO”C), drive the
vehicle
in “D” (Third Gear) until the
engine temperature gage moves and then
remains steady for ten minutes. Then
follow the hot check procedures.
To check transmission fluid cold: A cold
check is made after the vehicle has been
sitting for eight hours or more with the
engine off and is used only as a reference.
Let the engine run at idle for five minutes
if outside temperatures are 50°F
( 10°C)
or more. If it’s colder than 50°F (lO”C),
you may have to idle the engine longer. Should the fluid level
be
low during a
cold check, you must perform a hot check
before adding fluid This will give you a
more accurate reading
of the fluid level.
To check the fluid hot or cold:
Park your vehicle on a level place.
With the parking brake applied, place
With your foot on the brake pedal,
the shift lever
in
“P’ (Park).
move the shift lever through each gear
range, pausing for about three seconds in each range. Then, position the shift
lever in
“F’” (Park).
minutes or more.
Let the engine run at idle for three

Downloaded from www.Manualslib.com manuals search engine Service Station Information
Hood Release
See Page 184
Engine Oil Dipstick and- Fill Cap
(3.4L L32 (Code S) Engine)
See Page 188
Engine Oil Dipstick and /
Fill Cap
(5.7L LTl (Code P) Engine)
See Page 188
Cold Tire Pressure
See Tire-Loading Information label on the
inside of
the rear edge of the driver’s door.
See Page 212

Fuel
Capacity 15.5 U.S. Gal. (58.7 L).
Use unleaded gas only, 87 octane or
higher for the 3.4L L32 (Code
S) engine,
9 1 octane or higher for the 5.7L LT 1
(Code P) engine. See Page 181 See Page 201
\Battery
The
Delco Freedom@ battery needs
no water.
See Page 204
Cooling System Reservoir
Check coolant at the coolant recovery tank
by using the dipstick. Add coolant at the
coolant recovery tank. The fluid should be
at or a little above the “FULL HOT” mark
on the dipstick when the engine
is warm.
If the engine is cool, the level should be at
”FULL COLD” on the dipstick.
See Page 199
‘Spare Tire Pressure
Compact Spare: 60 psi (420 kPa).
See Page 176