
Downloaded from www.Manualslib.com manuals search engine Before you put the key In, your ignition will be in the “LOCK” position.
This position locks your ignition, steering
wheel and transaxle. It’s an
anti-theft feature.
The other positions let
you perform these functions:
ACC: Accessory lets you use things like the radio and the windshield
wipers when the engine is off. To get into “ACC”, push
in the key and turn
it toward you. Your steering wheel
will remain locked, just as it was-
before you inserted the key.
OFF: This position lets you turn off the engine but still turn the steering
wheel. It doesn’t lock the steering wheel like “Lock.” Use “Off”
if you
must have your car in motion while the engine is off (for example, if your
car is being pushed).
RUN This is the position for driving.
STARR This starts your engine.
NOTICE:
If your key seems stuck in “Lock” and you can’t turn it, be sure it
is
all the way in. If it is, then turn the steering wheel left and
right while you turn the key hard. But turn the key only with your
hand. Using
a tool to force it could break the key or the ignition
switch. If none of this works, then your vehicle needs service.
STARTING YOUR ENGINE
Move your shift lever to “P” (Park) or “N” (Neutral). Your engine won’t
start in any other position
-- that’s a safety feature. To restart when you’re
already moving, use
“N” (Neutral) only.
.-
,.
NOTICE: -
Don’t try to shift to “P” (Park) if your Cadillac is moving. If you
I
do, you could damage the transaxle. Shift to “P” (Park) only
when your vehicle
is stopped.
84

Downloaded from www.Manualslib.com manuals search engine r
r
!-
r
r
lr
If a bulb is burned out, ~~p~a~~~,~~.~~~.h~~~~a~~~~-an ,?wide$. If the green
arrows don’t
go on at all when you signal-a turn, check the fuse (see
“Fuses” in the Index) and for burned-out bulbs.
Operation of Lights
Although your vehicle’s lighting system (headlights, parking \
lights, fog
lamps, side marker lights and taillights) meets all applicable federal
lighting requirements, certain states and provinces may apply their
own
lighting regulations that may require special attention before you operate
these lights.
For example, some jurisdictions may require that you operate your lower
beam lights with fog lamps at all times, or that headlights be turned on
whenever you must use your windshield wipers. In addition, most
jurisdictions prohibit driving solely with parking lights, especially at dawn
or dusk. It is recommended that you check with your
own state or
provincial highway authoritfi for applicable lighting regulations.
Headlight High-Low Beam
To change the
headlights from low
‘beam to high or high to
low,
pull the turn signal
lever all the way toward
you. Then release it.
When the high beams
are on, this blue light
on the instrument
panel also will be on.
Flash-To-Pass Feature
This lets you use your high beam headlights to signal a driver in front of
you that you want to pass. It works even if your headlights are off.
To use it, pull the multifunction lever toward you. When you do:
105

Downloaded from www.Manualslib.com manuals search engine If your headliEhts are off: Your high beam headlights will turn on. They’ll
stay on as long as you hold the lever there. Release the lever to turn
them
off.
If your headliEhts are on. but on low beam: The system works normally.
Just pull the lever. Your headlights
will shift to high beam and stay there.
To return to low beam, just pull the lever toward you.
If vour headlights are
on. and on high beam: Your headlights will switch
to low beam. To get back to high beam, pull the lever toward you.
Windshield Wipers
1.0-
1.0- I
WIPER: To control the wipers, turn the band on the multifunction lever.
MIST: Turn the band away from you and then release it for a single wipe
cycle. For more cycles, hold the band on MIST longer.
7
LO or HI: Turn the band toward you to either LO (low speed) or to HI
(high speed), depending on the wiper speed you want.
DELAY: With this you can set the wiper speed for a long or short delay
between wipes. Move the band to
ON for long delays and the closer you
get to
LO the shorter the delay.
OFF: To turn the wipers off, turn the band to OFE
106

Downloaded from www.Manualslib.com manuals search engine F1 I 4
r i
r
r
r
r
-
Heavy snow or ice can overload your wiper motor. A circuit breaker will
stop the motor until it cools. Clear away snow or ice to prevent an
overload.
Windshield Washer
To wash your
windshield push and hold the paddle
labeled PUSH.
Once
you feel you have
enough washer fluid
on the windshield
release the paddle.
The wipers will
continue to clear the
windshield, then either
stop or return to your
preset speed.
When the washer fluid reaches a low level,
“LOW WASHER FLUID”
will be displayed in the Driver Information Center.
107
L
r

Downloaded from www.Manualslib.com manuals search engine WPER BLADE REPLACEMENT
. Position the windshield wipers on the windshield in the “mid” wipe
position.
To do this, turn the ignition key to ‘‘Accessory” and turn the
wipers on. Then with the door open, turn the ignition key to
“Off. F I L
I- t.
r
Do the same with the passenger side wiper blade assembly.
To install the wiper blade align the wiper arm pin with the hole on the 7 1 wiper blade assembly and snap it into place.
I
Y
283

Downloaded from www.Manualslib.com manuals search engine Fi
r
r 1
i
I
r !
r
r
..NOTICE:
..
..
. '' Don't add anything electrical-to your Cadillacunless you check
with your dealer fiist.Some. electrical equipment can damage
your vehicle and the damage wouldn't be covered by your
.warranty. Some-add-an electrical equipmentam keepdmr
.ceinponents
.from worwng as they should.
Your vehicle hasan. air bag system;. Before attempting to ,add.anything ;, -
electrical to your Cadillac, see "Servicing Yaur Air Big Equipped
Cadillac"
in the Index.
'I:
Retained Accessory :Power
When you stop:your Cadillac and. turn the key to Off, you .can. use -these
accessories far.lO.more.minutes:
.Radio
:. .'Power .Windows
Astroroof
Windshield Wipers
.,
If you .open a:.do.or, everything will go off. And, after- 10mhutes
everything will go
off, also.
:If you want power for another .lO minutes, just turn the key.to Run and
.then back to:Off.
..
The wiring circuitsin your vehicle are protected from short circuits by a
combination:of
.Mini Fuses, Circuit Breakers, and Maxi Fuses:'This
greatly reduces.the chance
of fires caused by electricd.problems.
If you have a problem ,owthe road and don't have a:spare fuse, you can
"borrow"me
of the same value. Select a feature that you can get along
without that isthe same.value you need
-- like .the radio or cigarette
" lighter -- and use its fuse. Re sure .tu use :a fuse with the same amperage
-rating number onit (ie.
104 204 etc.),Repl-ace it .as soon as you can.
311

Downloaded from www.Manualslib.com manuals search engine Wheel Alignment And Tire Balance
Wheel Replacement
.............
Why Safety Belts Work ...........
Window Express Down, Driver's Side
Windows, Power
.................
Windshield Cleaning The
.................
Washer .......................
Washer Fluid ..................
Wipers .......................
Wipers: If They Stop ...........
Winter Driving ...................
Working On Your Vehicle .........
Worn Tires ......................
Wrecker Towing ..................
Wheel Nut Torque ...............
Why Wear Safety Belts? ..........
Wiper Blade Replacement ......
.................. 296
.................. 237
.................. 296
................... 15
................... 13
..................
..................
..................
..................
..................
..................
..................
..................
..................
..................
..................
..................
101
101
304
107
268 106
283
317
196
241
293
217
I1 Ill I I1 II Ill I I Ill Ill11ll
H-3128
16