4. Press preset 1 and 4 buttons together. Hold them
until
“---” shows on the display (at least 5 seconds).
You are now ready to enter your secret code. If you
pause more than
15 seconds between steps you may
have to start over.
5. Press SET and “000” will appear on the display.
6. Press SEEK and hold it until the first digit of your
code appears.
two numbers agree with your code.
7. Rotate the TUNE knob right or left to make the next
8. Press the BAND knob and “OOO” will appear. Now
you are ready to enter the second three digits of the
code according to steps
6 and 7.
9. Press the BAND knob. The display will show “rEP”
for
5 seconds, and then“000” will appear indicating
that some steps are to be repeated for verification.
10. Repeat steps 6, 7, and 8.
11. Press the BAND knob. If the display shows “SEC”,
the verification process was successful and the system is
SECURE. If the display shows “---”, the
verification steps were not successful and the entire
sequence must be started again.
To Unlock The System After a Power Loss
When battery power is reapplied to a secured radio, the
radio won’t turn on and “LOC” will appear in the
display.
Enter your secret code
as follows. Pause no more than
15 seconds between steps.
0 Turn the ignition ON (radio off.)
0 Press the SET button. The display will show “000”.
0 Enter the six digits of the code following steps 6 thru
9 on the preceding page. The display will show the
number as entered.
Press the BAND knob and the time appears --
indicating that the disabling sequence was
successful. If the display indicates “SEC”,
the
number did not match and the unit is still secured.
156
ProCarManuals.com
Disabling The Theft System
Press preset buttons 1 and 4, for 5 seconds with the
ignition “On” and radio power “Off’. The display
will show “SEC”, indicating the unit is in the secure
mode.
Press the SET button. The display will show “000”.
Enter the first three digits of the code following step
6 and 7 of the preceding directions. The display will
show the numbers as entered.
Press the BAND knob. The radio will display “000”.
Enter the second three digits of the code. The display
Press the BAND knob. If the display shows “---” ,
will show the numbers as entered.
the disabling sequence was successful. (The numbers
matched the user-selected code
or the factory
back-up code) and the
unit is in the UNSECURED
mode. If the display shows “SEC”, the disabling
sequence was unsuccessful and the numbers did not
match either
of the codes and the unit will remain in
the SECURED mode.
Care of Your Cassette Tape Player
A tape player that is not cleaned regularly can cause
reduced sound quality, ruined cassettes, or a damaged
mechanism. Cassette tapes should be stored
in their
cases away from contaminants, direct sunlight, and
extreme heat.
If they aren’t, they may not operate
properly or cause failure
of the tape player.
157
ProCarManuals.com
