Page 85 of 358
To Set Cruise Control
1. Move the Cruise Control switch to
ON.
A
If you leave your Cruise
Control switch on when you're
not using Cruise, you might
hit a
button and go into Cruise when you
don't want
to. You could be startled
and even lose control. Keep the
Cruise Control switch
OFF until
you want to use it.
!m .I
%'
2. Get up to the speed you want.
3. Push in the set button at the end of the
lever and release it.
To Resume a Set Speed
Suppose you set your Cruise Control at
a desired speed and then you apply the
brake. This, of course, shuts off the
Cruise Control.
But you don't need to
reset it. Once you're going about 25 mph
(40 km/h) or more, you can move the
Cruise Control switch from
ON to
R/A (Resume/Accelerate) for about half
a second.
You'll go right back up to your chosen
speed and stay there.
ProCarManuals.com
Page 106 of 358

Features 8t Controls
f
I
I
. ’ 102
If the light stays on or comes on when
you’re driving, stop
as soon as possible
and turn the key off. Then start the engine
to reset the system. If the light still stays
on, or comes on again while you’re
driving, your Chevrolet needs service.
Unless the regular brake system warning
light is also on, you
will still have brakes,
but not anti-lock brakes. If the regular
brake system warning
light is also on, see
“Brake System Warning Light” earlier
in
this part. When your anti-lock system is working,
the message
LOW TRAC will appear on
your instrument cluster. This means that
slippery road conditions may exist. Adjust
your driving accordingly. The light
will
stay on for about four seconds after the
ABS stops working. The
LOW TRAC
light also comes on during engine starting
as
a bulb check.
Engine Coolant Temperature Gage
This gage shows the engine coolant
temperature.
If the gage pointer moves
into the red area, your engine is
too hot!
It means that your engine coolant has
overheated. If you have been operating
your vehicle under normal driving
conditions, you should
pull off the road,
stop your vehicle and
turn off the engine
as soon as possible.
HOT COOLANT CAN BURN YOU
BADLY!
In ”Problerns on the Road,” this manual
shows
what to do. See “Engine
Overheating”
in the Index.
ProCarManuals.com
Page 122 of 358

Comfort Controls & Audio Systems
Pushbuttons
The four pushbuttons let you return to
your favorite stations. You can preset
up
to 14 stations (7 AM and 7 FM).
To set the pushbuttons for up to eight
stations (four
AM and four FM), just:
1. Tune in the station.
2. Press SET. (“SET” will appear on the
display for about five seconds.)
3. Within five seconds, press one of the
four pushbuttons. Whenever you press
that button, the preset station
will
return.
Repeat these steps for each pushbutton. You
can preset three more stations on
each band by pressing
a pair of buttons
next to each other
at the same time. Just:
1. Tune in the station.
2. Press SET. (“SET” will appear on the
display for about five seconds.)
3. Within five seconds, press two
pushbuttons next to each other
at the
same time. Whenever you press
that
pair of buttons, the preset station will
return.
Repeat these steps for each pair of
pushbuttons.
Setting the Tone
Bass: Slide the BASS lever up to hear
more bass,
Treble: Slide the TREB lever up to hear
more treble.
If a station is weak and noisy, move
TREB down to reduce the noise.
ProCarManuals.com
Page 125 of 358
Deico/Bose AM/FM Stereo with
Compact Disc Player
To Play the Radio
Turn the upper knob to turn the system on
oi off.
Volume
Turn the upper knob to ad-just the volume.
AM-FM
Press the lower knob to get AM. FMI or
FM2.
Tune
Turn the lower knob to choose radio
stations.
Seek
Press SEEK 4 or to go to the next
lower
or higher station and stay there
Scan
Press SCAN to hear each station for a few
seconds. When you
want to stop
scanning. press
SCAN again or the upper
knob.
Pushbuttons
The five pushbuttons let you return to
your favorite stations.
To set the
pushbuttons for
up to 15 stations (5 AM,
5 FMI and 5 FM2), just:
1. Press the lower knob to choose AM,
2. Tune in the station.
3. Press SET. (“SET” will appear on the
display for about five seconds.)
4. Within five seconds, press one of the
pushbuttons. Whenever you press that
button, the preset station
will return.
Repeat these steps for each pushbutton.
FM
1 or FM2.
121
ProCarManuals.com
Page 246 of 358
Service & Appearance Care
When you replace your radiator pressure
cap. an
AC3 cap is recommended.
Thermostat
Engine coolant temperature is controlled
by a thermostat in the engine coolant
system. The thermostat stops the flow
of
coolant through the radiator until the
coolant reaches a preset temperature.
When you replace
your thermostat, an
AC@ thermostat is recommended.
3.4L L32 (Code S)
Power Steering Fluid
How to Check Power Steering Fluid:
Unscrew the cap and wipe the dipstick
with a clean rag. Replace the cap and
completely tighten
it. Then remove the
cap again and look at the fluid level
on
the dipstick.
ProCarManuals.com
Page 266 of 358

Service & Appearance Care
represent higher levels of performance on
the laboratory test wheel than the
minimum required by law.
Warning: The temperature grade for this
tire is established for a tire that is properly
inflated and not overloaded. Excessive
speed, underinflation, or excessive
loading, either separately or
in
combination, can cause heat buildup and
possible tire failure. Those grades
are molded on the sidewalls
of passenger car tires.
While the tires available as standard or
optional equipment on General Motors
vehicles may vary with respect to these
grades, all such tires meet General Motors
performance standards and have been
approved for use
on General Motors
vehicles.
All passenger type (P Metric)
tires must conform
to Federal safety
requirements
in addition to these grades.
Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned
and balanced carefully at the factory to
give you the longest tire life and best
overall performance.
In most cases, you will not need to have
your wheels aligned again. However,
if
you notice unusual tire wear or your
vehicle pulling one way or the other, the
alignment may need to be reset.
If you
notice your vehicle vibrating when
driving on a smooth road, your wheels
may need to be rebalanced.
... 262
ProCarManuals.com