Page 17 of 406
Downloaded from www.Manualslib.com manuals search engine These symbols have to do with your lights:
n
I
TURN SIGNALS
MASTER LIGHTING
SWITCH PARKING
LIGHTS
A $0 *. 1
1 FOG LAMPS I
HAZARD WARNING
FLASHER
~~
LIGHTS OR HIGH BEAM
These symbols are on some of your controls:
Q
WINDSHIELD WIPER & WASHER WINDSHIELD
WASHER WINDSHIELD
DEFROSTER
REAR WINDOW
DEFOGGER
- .~
HEADLAMP
WASHER WIPER
I VENTILATING FAN
Page 111 of 406
Downloaded from www.Manualslib.com manuals search engine U
When using concentrated washer fluid, foll
manufacturer’s instruction
Don’t mix water with ready
tank and other parts
of the washer sy
as well as washer fluid.
u
L.J.
c1
U
Headlight Washers (Export On&)
11 you have this feature, when your headlamps are on, you will wash your -
headlamps while washing your windshield. Just press the PUSH paddle
on the multifunction lever.
CRUISE CONTROL
With Cruise Control, you can maintain a speed of about 25 mph (40
km/h) or more without keeping your foot on the accelerator. This can
really help on long trips. Cruise Control does
not work at speeds below
about
25 mph (40 km/h).
When you apply your brakes, the Cruise Control shuts
off. L
98
Page 121 of 406
Downloaded from www.Manualslib.com manuals search engine Lump Monitors
5- %
The front lamp
monitors show that
your headlamps, high
beam and turn signals
are working.
The rear lamp
monitors show that the
taillights and brake
lights
are working.
108
Page 301 of 406
Downloaded from www.Manualslib.com manuals search engine With the vehicle in a, turn the Electronic Climate Control to “Auto”
Turn your engine off.
and let the engine idle for 3 minutes or more.
Now your computer is programmed.
HLOGEN BULBS
I
A CAUTION
I
Halogen bulbs have pressurized gas inside and can burst if you I
drop or scratch the bulb. You or others could be injured. Take
special care when handling and disposing of halogen bulbs.
I
r
r
Lamp Housings = Exterior c
U
Your Cadillac’s lamp housings are designed with small vents so moisture
will be removed when the lights are on, or after driving for
a short time.
Halogen Headlight Bulb Replacement
The following procedure tells you how to remove the halogen headlamp
bulb. Follow either the Domestic or Export illustrations that best
describes your vehicle. c_
Page 302 of 406
Downloaded from www.Manualslib.com manuals search engine f
. ..
:.) ..
Domestic or Export - Remove the two headlamp housing assembly
fasteners.
Domestic or Export - Gently lift the headlamp housing assembly and pull
- it forward to gain access to the bulb and socket housing.
Page 303 of 406
Downloaded from www.Manualslib.com manuals search engine f c.
-1 "
t
Domestic - Turn the housing socket 1/4 turn counterclockwise and
remove it from the headlamp housing.
A
Export - Remove the wiring harness plug.
Page 304 of 406
Downloaded from www.Manualslib.com manuals search engine -
ST-
Export - Remove the rubber grommet.
L
Domestic - Remove the wiring harness from the bulb socket.
Connect the wiring harness to the new bulb socket and install into
headlamp assembly.
Page 305 of 406
Downloaded from www.Manualslib.com manuals search engine Export - Remove the retaining spring and raise it up, out of the way.
Export - Reinstall new bulb into headlamp housing assembly, reinstall
rubber grommet and wiring harness.
292
_-