1993 CADILLAC DEVILLE reset

Downloaded from www.Manualslib.com manuals search engine Fwc- ta Center
cl
Press and hold the
Range and Fuel Used
buttons to display the
oil life percentage.
You’ll
see how much oil life you have left, as a percentage. So if you see
“94” for example, that means that the way you’re driving your vehicle,
94%
of your current oil life is still left.
The
“CHANGE OIL SOON” light will come on for a few seconds as a
bulb check when you start your engine. The light will also come on for
20
seconds following engine start-up when either the oil life percentage is
less the
10% or 7,500 miles (12500 km) have been driven. The system
probably will say to change the oil between
3000 miles (5000 km) and
7500 miles (12500 km), but it may even say to change it before 3000 miles
under severe conditions. It all depends on your driving patterns.
(If it
doesn’t,
or if it doesn’t even light up, then something is wrong. You will
need to have it serviced.)
There
are two things the system won’t do: It can’t sense heavy dust in the
places where you drive.
If you drive in a dusty area, you should change
your oil every
3000 miles (5000 km) or 3 months (whichever comes first),
unless the “CHANGE
OIL SOON” light comes on sooner.
It doesn’t check how much oil you have
so you will still have to check for
that.
To check it, see the Index under “Engine Oil.”
When You’ve Changed the Oil
When new oil is put in, you’ll need to reset your system. To do that, press
and hold the “Range” and “Reset” buttons between
5 and 60 seconds.
-
L. c

Downloaded from www.Manualslib.com manuals search engine Once the buttons are released the “CHANGE OIL SOON” light will
flash 4 times to indicate it has reset to
100.
If the “CHANGE OIL SOON” light comes on and stays on for 5 seconds,
it did not reset. You’ll need to reset the system again.
SPEED SENSITIVE SUSPENSION
(SSS SYSTEM)
The Speed Sensitive Suspension System (SSS) automatically controls the
firmness of your Cadillac’s ride. The vehicle is controlled by an actuator
in each of the four struts to increase ride firmness depending on vehicle
speed and other driving conditions. There are three dampening modes:
COMFORT, NORMAL, and
FIRM. As the vehicle speed increases, the
firmness of the suspension increases. The system is in COMFORT for
speeds less than
28 mph, NORMAL for speeds between 28 and 65 mph,
and FIRM for speeds greater than
65 mph. The system also stiffens
damping during hard acceleration, braking and cornering ,for increased
control.
The SSS controller is a computer used to control and monitor the system.
The computer receives speed, acceleration and determines optimum
mode strut valving (or suspension stiffness) for your current operating
conditions. The computer also receives feedback from the struts to
determine proper system operation.
If the computer receives an incorrect
feedback from the system, an error code
will be set in memory and a
“SERVICE
SSS” light will come on and stay on until the problem is
corrected.
If this light should appear, have your vehicle serviced at your
earliest convenience.
SPEED SENSITm STEERING
This system varies the amount of steering effort proportionate to your
vehicle speed. Steering is easier at a lower speed for increased
maneuverability and parking ease. As your vehicle speed increases, the
steering effort is also increased proportionately. At highway speeds the
amount
of steering effort is greatly increased to provide a manual like
steering
feel for maximum control and enhanced vehicle stability.
135

Downloaded from www.Manualslib.com manuals search engine The Delco43ose Gold Series Compact Disc Music
System
1
To Play the Radio
The “Power” button turns the radio on and off.
The Volume (or Vol) button adjusts the volume up or down. (Press the
center to get
a preset level.)
am-fm Button
Push this to get AM or FM. (The lighted display shows your selection.)
Seek
Push the Seek button to go to the next station and stay there. Push again
and it will find the next station, and
so on.
Scan
Push to hear each station for a few seconds. Push it again when you hear
something
you like and want to stay there.
154

Downloaded from www.Manualslib.com manuals search engine Tune
This button tunes while the button is held. Also, push A and then v at the
same time to tune up quickly. Push
v and then A at the same time to tune
down quickly.
Push Buttons
The five push buttons
let you return to
favorite stations. They
are also used when you
play a disc.
To set the push buttons for up to ten favorite stations
(5 AM and 5 FM),
just
0 Tune in the station
Push SET
0 Within 5 seconds, push one of the push buttons. Whenever you push
that button, the preset station will return.
Rcl (Recall)
Press to go between time and frequency on the display.
You’ll get stereo by just tuning to any
AM or FM station broadcasting in
stereo.
(“ST” will show on the display).
am-st (Am Stereo)
Push the “am-st” button if you don’t want AM Stereo, as when the station
is weak or noisy.
(“ST” will go off the display.)

Downloaded from www.Manualslib.com manuals search engine - Pushbuttons
The five pushbuttons let you return to favorite stations. You can set the
pushbuttons for up to ten favorite stations
(5 AM and 5 FM). Just:
Tune in the station you want to listen to.
Press the SET pushbutton. (NOTE: The display will show SET for
Within the 5 seconds, push one of the five pushbuttons. SET will
-
about 5 seconds.)
disappear from the display with the station set.
-_
0 Whenever you press that button, the preset station will return.
Clock
To set the clock, just:
0 Press the SET button.
0 Within 5 seconds, press and hold SCAN until the correct hour appears
0 Press and hold SEEK A or until the correct minute appears on the
.~
-.
on the display.
display.
- To Adjust The Tone
Use the levers next to the display to set the bass, midrange, and treble
until you get the sound you want. The
60 and 250 levers adjust the bass;
We suggest you start with the center lever
(E) in the midpoint position.
Then move the others up or down until you get the amount
of bass and
treble you like.
-- 1K is midrange; and 3.5K and 10K control the treble.
c_
To Play a Cassette (Export Only)
Your tape player is built to work best with tapes that are 30 to 45 minutes
long on each side. Tapes longer than that are
so thin they may not work
well in this player.
With the radio on, press a tape into the slot marked
AUTO REVERSE
(tape side goes in first).
161

Downloaded from www.Manualslib.com manuals search engine SAE 1OW-30
As shown in the viscosity chart, SAE 1OW-30 is best for your vehicle.
However, you can use
SAE 5W-30 if it’s going to be colder than 60°F
(16°C) before your next oil change. When it’s very cold, below
O°F
(-18”C), you should use SAE 5W-30.
These numbers
on an oil container show its viscosity, or thickness. Do not
use other viscosity oils such as SAE 1OW-40 or SAE
20W-50.
Energy Conserving I1
Oils with these words on the container will help you save fuel.
This doughnut-shaped logo (symbol) is used on most
oil containers to
help you select the correct
oil.
You should look for this on the oil container, and use only those oils that
display the logo.
GM Goodwrench@
oil (in Canada, GM Engine Oil) meets all the
requirements for your vehicle.
Engine Oil Additives: Don’t add anything to your oil. Your Cadillac
dealer is ready to advise if you think something should be added.
When to Change Engine Oil: Your vehicle is equipped with an Engine Oil
Life Index (EOLI) feature. Oil change intervals are determined by the
EOLI and will usually fall at, or between, the two recommended
alternative intervals of 3,000 miles
(5,000 kilometers) and 7,500 miles
(12,500 kilometers), but could be shorter than 3,000 miles (5,000
kilometers) under some very severe driving conditions shown in Schedule
I. The system will also indicate the need for an oil change if 7,500 miles
(12,500 kilometers) has been driven.
Engine oil life remaining is displayed through the Fuel Data center and as
a
“CHANGE OIL SOON” light. The Fuel Data center display includes a
number between
0 and 100. This is the percentage of oil life
REMAINING based on driving conditions and mileage driven since the
last time the oil life indicator was reset.
The EOLI will not detect excessively dusty conditions or engine
malfunctions which may effect the
oil. If you drive in dusty areas, change
the engine
oil after every 3,000 miles (5,000 kilometers) or 3 months
(whichever comes first), unless instructed to
do so sooner by the EOLI.
c-
LC
c-
.- -
c-
.L
.,
272

Downloaded from www.Manualslib.com manuals search engine How To Reset the Oil Life Indicator: After the oil has been changed,
press and hold the
“RANGE” and “RESET” buttons between 5 and 60
seconds. Once the buttons are released the “CHANGE OIL SOON”
light will flash 4 times to indicate it has reset to 100. If the “CHANGE
OIL SOON” light comes on for 5 seconds it did not reset. You will need
to reset the system again. The percentage
of oil life remaining may be
checked at any time by pressing the
“RANGE” and “FUEL USED” on
the Fuel Data center.
Engine Block Heater: An engine block heater can be a big help if you
have to park outside
in very cold weather, O°F (-18OC) or colder. If your
vehicle has this option, see “Engine Block Heater” in the Index.
What to Do with Used Oil:
’
A CAUTION:
Used engine oil contains things that have caused skin cancer in
laboratory animals. Don’t let used oil stay
on your skin for very
long. Clean your skin and nails with soap and water, or a good
hand cleaner. Wash or properly throw away clothing or rags
containing used engine oil.
Used oil can be a real threat to the environment. If you change your own
oil, be sure to drain all free-flowing oil from the filter before disposal.
Don’t ever dispose
of oil by pouring it on the ground, into sewers, or into
streams or bodies
of water. Instead, recycle it by taking it to a place that
collects used oil.
If you have a problem properly disposing of your used
oil, ask your dealer, a service station or
a local recycling center for help.

Downloaded from www.Manualslib.com manuals search engine Add coolant mix at the recovery tank, but be careful not to spill it.
-
A CAUTION:
You can be burned if you spill coolant on hot engine parts.
Coolant contains ethylene glycol, and it
will burn if the engine
parts are hot enougl- spill coolant on
a hot e-yine.
RADUTOR PRESSURE CAP
I-
_I
must be tightly Installed to prevent coolant loss and possible
engine
damage from overheating. Be sure the arrows on the c
line up with the overflow tube on the radiator filler neck .L
When you replace your radiator pressure cap, an ACS cap is
recommended.
THERMOSTAT
Engine coolant temperature is controlled by a thermostat in the engine
coolant system. The thermostat stops the
flow of coolant through the
radiator until the coolant reaches a preset temperature.
When you replace your thermostat, an
AC@ thermostat is recommended.
c
Lr