1993 BUICK SKYLARK Owners Manual

1. Put the restraint on the seat. Follow the instructions 4. Buckle the belt. Make sure the release button faces
for the child restraint. upward or outward,
so you'll be
able to unbuckle it
quickly if you ever need to.
z4 ,Secure the child in the child restraint as the
.. :instructiom say.
3. Pull out the vehicle's safety belt and run the lap part
through or around the restraint. The child restraint
instructions will show you how. Tilt the latch plate to
adjust the belt if needed.
See if the shoulder belt would
go in front of the
child's face or neck.
If so, put it behind the child
restraint.
48

5. To tighten the belt, pull up on the shoulder belt while
you push down on the child restraint.
To remove the child restraint, just unbuckle the vehicle's
safety belt and let it go back all the way. The safety belt
will move freely again and be ready to work for an adult
or larger child passenger.
49

Securing: a Child Restraint in the Center Y
Rear Seat Position
When you secure a child restraint in a center seating
position, you’ll be using the lap belt.
See the earlier section about
. I’ !,;F Ft the to$ strap if the child
restraint has one.
i .+*) +,“.#kg! ::.,.: . ” .: .< ,~~~~~~~~~,~~.‘:;,,$ I. l.. r.: ,* -~ ._
1. Make the. belt as long as possible by tilting the latch
plate
ad pulling it along-the belt.
2. Put the restraint on the seat. Follow the instructions
for the child restraint.
3. Secure the child in the child restraint as the
instructions say.

4. Run the vehicle’s safety belt through or around the
restraint. The child restraint instructions will show
you how.
5. Buckle the belt. Make sure the release button faces
upward or outward,
so you’ll be able to unbuckle it
quickly if you ever need to.
6. To tighten the belt, pull its free end while you push
down on the child restraint.
I 51

To use a child restraint here, you will need a special
Si infant/child seat attaching belt and the hardware that goes with it. See the earlier section about the top strap if \
the child restraint has one.
Your dealer can get these and install the hardware for
you. It’s
free. The special belt is GM Part Number
12340286. Your dealer can find the correct hardware in
the accessory section of the GM Parts Catalog.
I

Once the special hardware is installed, please follow the
instructions with it and these steps:
1. Unbuckle the automatic lap-shoulder belt by pushing
the button on the buckle.
2. Snap one hook of the infant/child seat attaching belt
near the
floor at the door side of the seat.
It will stay on the door, ready to be rebuckled for use
by adults or older children.
53

4. You can make the belt longer by tilting the buckle
and pulling it along the belt.
5.
6.
Put the restraint on the seat. Follow the instructions
for the child restraint.
Secure the child in the child restraint
as the
instructions
say.

7. Run the belt through or around the child restraint. 9. To make it tight, pull the belt while you push down
The child restraint instructions will show
you how. on
the child restraint. If the belt won’t stay tight,
8. Put the hook on tk free end through the slot in the
latch plate. switch
it end for end.
directions-to be sure it is secure.
55