Page 97 of 324
To Get Out of Cruise Control
There are two ways to turn off the Cruise Control:
To Erase Speed Memory
When you turn off the Cruise Control or the ignition,
your Cruise Control set speed memory is erased.
. ..
Move the Cruise
switch
to "'OFF.'' (The
"CRUISE' ligfit will
go aut.)
Cruise and Resume Lights
The CRUISE light tells you
when you have your cruise
control on.
The RESUME light comes
on when you push the
Resume/Accelerate button until you reach
yov set
speed again.
Page 98 of 324
Lights
'
1 0 Headlights
The LIGHTS switch controls these light systems:
Taillights
Parking Lights
0 License Lights
Sidemarker Lights
Instrument Panel Lights
0 Interior Courtesy Lights
Push the LIGHTS switch to turn the
headlights on or
off. Push the "P" (PARK) switch to turn the parking
lights
on or off.
Headlight ''On" Warning
If the light switch is left on you'll hear a warning tone
when you turn the ignition off and open the driver's
door.
\,
Panel and Interior Lights
The instrument panel light
brightness can be adjusted when the parking or
headlights are
on. Slide the
lever toward HI to make
them brighter; toward
LO to
dim them. Push the lever to
INT to
turn on the interior
lights.
96
Page 99 of 324
Twilight Sentinel
Twilight Sentinel turns your headlights
on and off by
sensing how dark it
is
outside.
To operate
it, leave the light switch off and move the
Twilight Sentinel control to any position but
OFF.
If you move the control. all the way to MAX, your lights
will remain on for three minutes after you turn
off your
engine.
If you move the control almost all the way in the
other direction, the lights will
go off quickly when you
turn off your engine. You can change this delay time
from only a few seconds to three minutes. Your
Twilight Sentinel and Daytime Running Lights
(Canada Only) work with the light sensor
on top of your
instrument panel. Don’t cover it up, if you
do it will read
“dark” and your lights will come on.
97
Page 100 of 324

-Headlights Reminder Light (Canada Only)
If your vehicle was first sold, when new, in Canada, this
light will go on at night to remind you to turn on the
headlights.
Daytime Running Lights (Canada Only)
The Canadian Federal Government has decided that
“Daytime Running Lights” (DRL) are a useful feature,
in that DRL can make your vehicle more visible to
pedestrians and other drivers during daylight hours.
DRL are required on new vehicles sold in Canada. Your
DRL work with a light sensor on
top of the
instrument panel. Don’t cover it up.
The low beam headlights will come
on at reduced
brightness in daylight when:
The ignition is on.
The headlight switch is off, and
The transaxle is not in “P” (Park).
At dusk, if the Twilight Sentinel feature is turned
on, the
exterior lights will come on automatically and the low
beams will change to
full brightness. At dawn, the
exterior lights will
go out and the low beams will
change to the reduced brightness of DRL (if the
headlight switch is
off). If the Twilight Sentinel is off, at
dusk a “HEADLIGHTS SUGGESTED” message will
appear on the instrument panel to remind you to turn. on
the headlights.
Of course, you may still turn on the headlights any time
you need to.
.
To idle your vehicle with the DRL off, shift the
transaxle into
T“ (Park). The DRL will stay off until
you shift out of “P”.(Park).
98
Page 101 of 324
Page 102 of 324

Automatic (Option) Settings
Your Buick may have the automatic inside mirror.
The automatic mirror adjusts for the glare of headlights
behind you.
It detects changes in light, and then adjusts
for day or night operatiol-~
During the day the mirror reflects all the light from
behind your car. At night, when the glare is too high, it
changes to the night mode. Then,
it reflects only part of
the light from behind you. When the mirror changes to
the night mode, it holds that position until glare is no
longer present.
MIN: The minimum setting is suggested when driving
where glare conditions change
often. '"in" works well
for city driving at night.
MAX: Maximum sensitivity is a good setting for
highway driving in light traffic. The mirror
starts to
darken in any glare, such as headlights a long way
behind your car.
OFF: The mirror will stay in the day mode.
Time Delay
The mirror delays before switching from the night back
to the day position.
This delay prevents rapid changing
of the mirror as you drive under lights and through
traffic.
Reverse Gear Day Mode
The reverse mode is another important feature of the
automatic mirror. When the shift lever is placed in
"R"
(Reverse), the mirror shifts to the day mode. This gives
you a bright image in the mirror as you back up.
I
100
Page 103 of 324
Cleaning Photocells
Use a cotton swab and glass cleaner to clean the two
photocells that make the mirror work.
Outside Mirrors
The electric mirror control is on the driver's door.
Move the switch to the right
(R) or left (L) to choose a
mirror. Press any
of the four buttons to move the mirror
in the direction desired.
Adjust each mirror
so you can just see the side of your
car and the area behind your car.
Heated Outside Rearview Mirror (Option)
The left outside mirror is heated when you turn on the
rear window defogger.
101
Page 104 of 324

Iur
COI
)m right side mirror
is convex.
nvex
mirror's surface is curved
the driver's seat. so you can see more
/!1 CAUTION:
If you aren't used to a convex mirror, you can
hit another vehicle.
A convex mirror can make
things (like other vehicles) look farther away
than they really are.
If you cut too sharply into
the right lane,
you could hit a vehicle on your
right. Check your inside mirror or glance over
your shoulder before changing lanes.
i
Astroroof (Option)
The control is on the roof bet1 leen the windshield and
the sunroof. With Retained
Ai lcessory Power, the
sunroof can be opened or cloq ;d during the
10 minute
period after you have turned our ignition
OFF. Or, the
ignition switch will have to b
in the RUN position.
The sunshade can be opened 1 !y grasping the handle at
the ffont
of the shade and slid ing it to the rear. It will
open automatically with the iding..glass panel. It must
be closed manually. I
To open the glass to an angled venting position, press
and hold the forward portion
1 rf the switch until it stops.
To close it, press and hold th$ rear Eortion of the switch
until it stops.
I"'%+ -. .
To open the sliding glass sund 2of completely, press and
hold the rear portion of the
svi itch. To close the sunroof,
press and hold the front portia
n of the switch until it
stops.
The sunroof cannot be operata
d manually if your car has
an electrical power failure.
I. '~."-,"l,~~ :. - ,
*;e -c
102 -