1993 BUICK REGAL radiator

Vehicle Symbols
These are some of the symbols you will find on your vehicle.
For example,
these symbols
are used on an
original battery:
POSSIBLE A
CAUTION
INJURY
PROTECT EYES BY
SHIELDING
CAUSTIC
BURNS AVOID
SPARKS
OR
FLAMES
SPARK
OR ,\I/,
COULD FLAME
EXPLODE BATTERY
These symbols
are important
for you and
your passengers
whenever your
vehicle
is
driven:
DOOR LOCK
UNLOCK
e
e
BELTS 4
POWER
WINDOW
These symbols
have
to do with
your lights:
SIGNALS e @
TURN
HIGH BEAM
OR = =o
FOG LAMPS $0
These symbols
are on some
of
your controls:
WINDSHIELD ' ' ' 0- 0-
WASHER
WINDSHIELD WASHER
WINDOW
DEFOGGER
VENTILATING FAN
HEADLAMP
-
WIPER
WASHER
Q
These symbols
are
used on
warning and
indicator lights:
COOLANT F-
TEMP --
ENGINE
CHARGING
I-1
BATTERY SYSTEM
BRAKE
(0)
RADIATOR 0
COOLANT
FUEL
ENGINE OIL w,
PRESSURE
TEMP
OIL &b
ANTILOCK (a)
BRAKE
Here are some
other symbols
you may see:
FUSE
RADIO
VOLUME
CONDITIONING
AIR 43
HATCHBACK TRUNK
RELEASE
t LIGHTER
HORN
SPEAKER
12
ProCarManuals.com

Windshield Washer
At the top of the multifunction lever there’s a paddle
with the word
“PUSH” on it. To spray washer fluid on
the windshield, push
the paddle. Unless they are already
turned
on, the wipers will operate at low speed for
several sweeps,
then turn off.
A LHuTIO“
I 0 Driving without wa
dangerous.
A bad mud splash can blocl-
your vision. You could hit another vehicle
or go off thc )ad- Check VOUI I=rsher fluid
level often.
m In freezing weL..der, don‘t use your
until the windshield is warmed. Ot
the washer fluid
can form ice on th
windshield, blocking yovr vieinn
L
follow the man
adding water
Don’t mix water with ready-to-use was
fluid. Water can cause the solution to
freeze and damage your washer fluid t
and other parts of the washer system. Also,
water doesn’t clean as well as washer
when
it’s very cold. This allows for
Fill your washer fluid tank only 314 f
expansion, which could dama
it is completely full.
0 Don’t use radiator antifreeze in you
windshield washer.
It can da me v
washer system and paint.
85
ProCarManuals.com

If you get the overheat warning with no sign of steam,
try this for
a minute or so:
1.
2.
3.
Turn off your air conditioner.
Turn on
your heater to full hot
speed and open the window as
Try to keep your engine under
where the engine runs slower). at
the highest fan
necessary.
load (in a drive gear
If you no longer have the overheat warning,
you can
drive. Just to be safe, drive slower
for about ten minutes.
If the warning doesn‘t corne back on, you can drive
normally.
If the warning continues, pull over, stop, and park
your
vehicle right away.
If there’s still
no sign of steam, you can idle the engine
for two
or three minutes while you’re parked, to see if
the warning stops. But then, if you still have the
warning,
TURN OFF THE ENGINE AND GET
EVERYONE
OUT OF THE VEHICLE until it cools
down.
You may decide not to lift the hood but to get service
help right
away.
m .... ... ..
h 1
When you decide it’s safe to lift the hood, here’s what
you’ll
see:
0 Coolant recovery tank
0 Radiator pressure cap
0 Electric engine fan
ProCarManuals.com

tder the hood can =&drt up even
is not running and can injure
--, clothing and tools away frnm
I nlcwtric fan-
~ ~~~~ ---
If the coolant inside the coolant recovery tank is boiling,
don’t do anything else until it
cools down. The
coolant level should be at or above the
“COLD”. If
it isn’t, you may have a leak in the radiator hoses, heater
hoses, radiator, water pump or somewhere else
in the
cooling system.
9
Heater and radiator hoses, and other englne
parts, can be very hot.
do, you can be burned.
Don’t run the engine
if there is a leak. If you r,,,
the engine, it could lose all coolant. That could
cause an engine fire, and you could be burned
my leak fixed before you drive +he vehicl,.
I U
If there seems to be no leak, check to see if the electric
engine fan
is running. If the engine is overheating, the
fan should be running.
If it isn’t, your vehicle needs
service.
194
ProCarManuals.com

How to Add Coolant to the Coolant
Recovery Tank
If you haven’t found a problem yet, but the coolant leveI
isn’t at or above “COLD” add a 50/50 mixture of clean
- water (preferably distilled) and a proper antifreeze at
the coolant recovery tank. (See “Engine Coolant’’
in the
Index for more information about
the proper coolant
mix.)
can bedangerous. Plain water, or some othe
liquid like alcohol, can boil before the prope
coolant mix will. Your vehicle’s coolant warn
system
is set for the proper coolant mix. Wit
plain water or the wrong mix, your engine could
get too hot but you wouldn’t get the overheal
warning. Your engine could catch fire and you or
others could be burned. Use a
50/50 mix of clean
water and a proper antifreeze
m-u mw-.
In cold weath wate :an frc anc
engine, radiator, heater core and other- parts. Use
the recommended coolanl
ProCarManuals.com

Youlean be burned if you spill coolant on hot
engine parts. Coolant contains ethylene glycol
-d it wiil burn if the engine parts are hot
ough. Don't spill
coolant -on a hot engine.
,- '
.Steam and scalding liquids- from a hot 'bootin!,
system can btow o.ut and burn you badly. They
are under pressure,..and.
if you turn the. radiatr-
pre,ssure cap
- even a little - they can come brl
cooling system, including the, radiator pressye
When the coolant in the coolant recovery tank is at or cap, is hot. Wait for the cooling system'and
above "COLD," start your vehicle. radiator pressure cap to cool if:you-ever have to
If the overheat warning continues, there's one more -turn the pressure cap.
thing you can try. You can add the proper coolant mix 3
directly to the radiator, but be sure the cooling system is
cool before you do it.
- at high speed. Never turn,the cap'when the+;:.::
-, .I
I
196
ProCarManuals.com

x 8
ir
..-,
How to Add Coolant to the Radiator
7 1. You can remove the
radiator pressure
cap when
the
cooling system,
including the
radiator pressure
cap and upper
radiator hose, is
no
longer hot.
Turn the pressure cap slowly to the left until it first
stops. (Don't press down while turning the pressure
If you heal- a hiss, wait for that to stop. A hiss means
there
is still some pressure left.
cap.)
197
ProCarManuals.com

3. Fill the radiator
with the proper
mix,
up to the base
of the filler neck.
If you see a stream of coolant coming from an air
bleed
valve, close the valve. Otherwise, close the
valve(s) after the radiator is filled.
4. Rinse or wipe any spilled coolant nom the engine
and compartment.
5. Then fill the coolant recovery tank to "COLD."
6. Put the cap back on the coolant recovery tank, but
leave the radiator pressure
cap off.
ProCarManuals.com