1993 BUICK REGAL engine

steering wheel will remain locked, just as it was before Starting Your Engine
you inserted the key.
turn the steering wheel. It doesn’t lock the steering number for your engine. You will find the
VIN at the top
in motion while the engine is
off ( example, if your car Identification Number” in the Index.) Follow the proper
is being pushed). steps to start the engine.
Engines start
differently. The 8th digit of your Vehicle
OFF:’ This position lets YOU turn Off the engine but Still
Identification Number (VIN) shows the code letter or
wheel like “Lock.” Use “Off’ if
YOU must have your car
left of your instrument panel. (See ‘‘Vehicle
RUN: This is the position for driving.
START: This position starts your engine. Move your shift lever to
“F”’ (Park)
or “N’ (Neutral).
Your engine won’t start in any other position
-- that’s a
safety feature. To restart when you’re already moving,
use
“N’ (Neutral) only.
Don’t try to shift t
moving. If you do,
transaxle. Shift to ... . -
67
ProCarManuals.com

To start your 3.1 Liter (Code T) engine:
1. Don’t push
the accelerator pedal before starting your
engine. In some other vehicles you might need to do
this, but because of your vehicle’s computer systems,
you don’t.
starts, let
go of the key. The idle speed will go down
as your engine gets warm.
2. Turn your ignition key to “Start.” When the engine
omng your Key In “Start” for longer tna
seconds at a time will cause your battery to
t
drained much sooner. And the excessive hear
3. If your engine won’t start (or starts but then stops), it
could be flooded with too much gasoline. Try
pushing your accelerator pedal all the
way to the
floor and holding it there
as you hold the key in
“Start” for about three seconds. If the vehicle starts
briefly but then stops again, do
the same thing, but
this time keep the pedal down for five
or six seconds.
This clears the extra gasoline from the engine.
[ electronics in your vehicle. If you add electrical
parts or accessories, you could change the way
the fuel injection system operates. Before adding
electrical equipment, check with your dealer.
1-
you don’t, your engine might not perforn
properly.
If you ever have to have your vehicle towed, see
the part
of this Manual that tells how to do it
without damaging your vehicle. See “Towing
Your Vehicle” in the Index.
4
-$,.-q*+&< ..,-. >%--:* ..“I)“:.. , .--..:<::.,: m.v;,,, ,‘‘Tmy, ““,u, .; ::x,.* ..,, L, W“ . , ~’‘&&‘, ’~=:.*>:** . .. l\l_ $p;Y-.T@ b
68
ProCarManuals.com

To start your 3.8 Liter (Code L) engine:
1. Don’t push the accelerator pedal before starting your
engine. In some other vehicles you might need
to do
this, but because of your vehicle’s computer systems,
you don’t.
2. Turn your ignition key to “Start.” When the engine
starts,
let go of the key, The idle speed will go down
as your engine gets warm.
3. If it doesn’t start right away, hold your key in “Start”
for about three seconds at
a time until your engine
starts. Wait about
15 seconds between each try to
help avoid draining your battery.
Holding your key in “Start” for longer than 15
seconds at a time will cause your battery to be
drained much sooner.
And the excessive heat
can damage your starter motor.
4. If your engine still won’t start (or starts but then
stops), it could be flooded with too much gasoline.
Try pushing your accelerator pedal all the way to the
floor and holding
it there as you hold the key in
“Start” for about three seconds.
If the vehicle starts
briefly but then stops again,
do the same thing, but
this time keep the pedal down for five or six seconds.
This clears the extra gasoline from the engine. After
waiting about
15 seconds, repeat the normal starting
procedure.
electronics in your vehicle. If you add electric
parts or accessories, you could change
the way
the fuel injection system operates. Before adding
electrical equipment, check with your dealer
‘I.
you don’t, your engine might not perform
properly.
If you ever
h h hicle towea,
the part
of this Manual that tells how to do it
without damaging your vehicle. See “To
Your Vehicle” in the Index, :, ’ .
69
ProCarManuals.com

Driving Through Deep Standing
Water
If you drive too quickly through deep puddles or
standing water, water can come in through your
engine’s
air intake and badly damage your
engine. If you can’t avoid deep puddles or
standing water, drive through them very slowly.
Engine Block Heater (Canada Only)
In very cold weather, 0 F (- 18 C) or colder, the engine
block heater can help. You’ll get easier starting and
better
fuel economy during engine warm-up.
To use the block heater:
1. Turn off the engine.
2. Open the hood and unwrap the electrical cord.
3. Plug it into a normal, grounded 110-volt outlet.
I
Plugging the cord into an ungrounded outlet
could cause an electrical shock.
Also, the wrong
kind of extension cord could overheat and cause
a fire. You could be seriously injured. Plug the
cord into
a properly grounded three-prong
IlO-volt outlet.
If the cord won’t reach, use a
heavy-duty three-prong extension cord rated for
at least
15 amps.
I
I
x; NOTICE:
k After you’ve used the block heater, be sure to
:; store the cord as it was before, to keep it away
i from moving engine parts. If you don’t, it could
:: be damaged. .’, :.,* :>”!;.:,.”~ i” < .:-;:.&,a2% && ?3$?%7 -
How long should you keep the block heater plugged in?
The answer depends
on the weather, the kind of oil you
have, and some other things. Instead
of trying to list
everything here, we ask that you contact a Buick dealer
in the area where you’ll be parking your vehicle. The
dealer can give
you the best advice for that particular
area.
70
ProCarManuals.com

Automatic Transaxle
1
1%.
There are several different positions for your shift lever.
P (Park)
This locks your front wheels. It’s the best position to
use when you start your engine because your vehicle
can’t move easily.
A CAUTION:
It is dangerous to get out of your vehicle if the%
shift lever is not fully in “P” (Park) with the
parking brake firmly set. Your vehicle can roll.
Don’t leave your vehicle when the engine
is
running unless you have to. If you have left tht
engine running, the vehicle can move suddenly.
You or others could be injured. To be sure your
vehicle won’t move, when you’re on fairly level
ground, always set your parking brake and move
the shift lever to “P” (Park).
See “Shifting Into “P” (Park)”
in tl Index. I1 ;
are parking on a hill, or if you’re puliing a traller,
also see“Parking on Hills” or “Towing a Trailer”
R (Reverse)
Use this gear to back up.
71
ProCarManuals.com

objects. Don’t shift out of ccPyy (Park) ----“N4 -- kutral) whil four engine i8 icing, I
NOTICE:
- When driving on hilly, winding roads
ProCarManuals.com

- When towing a trailer, so there.is less shifting
- When going down a steep hill between gears
’ 2 (Second Gear)
This position gives you more power but lower fuel
economy. You can use
2 on hills. It can help
control your speed as you go down steep mountain
roads, but then you would also want
to use your
brakes
off and on.
bb 97
miles (8 km), or at speeds over 55 mph (88 kmih),
or you can damage your transaxle. Use
‘@” or
“D” as much as possible.
Don’t shift into
“2” unless you are going slower
1 (First Gear)
This position gives you even,more power (but lower
fuel economy) than
“2.” You can use it on very steep
hills, or in deep snow
or mud. If the selector lever is
put’in
“1 ,” the transaxle won’t shift into first gear
until the vehicle
is going slowly enough.
Maximum engine speed
is limited when the transaxle is
in “D” (Drive) or
“N” (Neutral) to protect driveline
components from improper operation.
73
ProCarManuals.com

If YOU are on a hill: See “Parking on Hills” in the Index.
That section shows how to turn your front wheels.
If
you are towing. a trailer and are parking on any hill:
See
“ Towing a Trailer” in the Index. That section shows
what to do first to keep the trailer from moving.
Shifting Into 66 P 99 (P-k)
It can be dangerous to ger out of your vehicle if
the shift lever is not fully
in “P” (Park) with the
parking brake firmly set. Your vehicle can rol~
If you have left the engine running, the vehicl
can move suddenly. You or others could be
injured.
To be sure your vehicle won’t move,
when you’re on fairly level ground, use the
steps
that follow. If you are parking on a hill, or if
you’re pulling a trailer, also see “Parkinc 3n
Hills” 2r “Towing a Traile-” ’- the lrT’?x.
Steering Column Shift Lever
1. Hold the brake pedal down with your right foot and
set the parking brake.
2. Move the shift lever into “P77 (Park) position like
this:
0 Pull the lever toward you.
75
ProCarManuals.com