19-10STEERING - Service Adjustment Procedures c Power Steering> r13A029213A0293 r 1 i SERVICE ADJUSTMENT PROCEDURES STEERING WHEEL FREE PLAY CHECKNlSFABH 1. With engine running (hydraulic operation), set front wheels straight ahead.2. Measure the play on steering wheel circumference before wheels start to move when slightly moving steering wheel in both directions. Limit: 30 mm (1.2 in.13. When the play exceeds the limit, check for play on steering shaft connection and steering linkage. Correct or replace. 4.If the free play still exceeds the limit value set steering wheel straight ahead with engine stopped. Load 5 N (1 lb.1 towardssteering wheel circumference and check play. Standard value (steering wheel play with engine stopped): 11 mm I.43 in.) If the play exceeds the standard value, remove steering gearbox and check total pinion torque. STEERING ANGLE CHECKN19FDBJ1. Set front wheels on turning radius gauge and measure steering angle.Standard values: Turbo Inner wheel 31”30’+2”Outer wheel 27”OOOther models Inner wheel 35”00’_+2”Outer wheel 2990’ 2. When not within the standard value, it is probably a toe problem. Adjust toe (refer to GROUP 2-Service Adjustment Procedures) and recheck.TIE ROD END BALL JOINT VARIATION CHECK (SHAFT DIRECTION)N19FVA8The inspection procedure for the tie rod end ball joint variation is the same as for the manual steering system. (Refer to P. 19-7.) TIE ROD END BALL JOINT STARTING TORQUE CHECKNlSFEBDThe inspection procedure for the tie rod end ball joint starting torque is the same as for the manual steering system. (Refer to P.19-8.)
