ENGINE - Timinn Belt11-27
r bol
I01 NO07
10. REMOVAL OF ENGINE SUPPORT BRACKETRemove the engine support bracket in the numbered
sequence shown in the illustration.
Spraying lubricant, slowly remove the bolt (reamer bolt)
indicated by the arrow.
CautionKeep in mind that the reamer bolt is sometimes heat
seized on the engine support bracket.
Timing mark
mshaftrocket01 N009:
d Soft jawSoft jaw
OlL104E
Set hole
n
12. REMOVAL OF TIMING BELT(1) Align the timing marks.
(2) Make a mark on the back of the timing belt indicating
the direction of rotation so it may be reassembled in the
same direction if it is to be reused.
(3) Loosen the center bolt on the tensioner pulley to
remove the timing belt.
Caution
Water or oil on the belt shorten its life drastically, sothe removed timing belt, sprocket, and tensioner
must be free from oil and water. These parts should
not be washed. Replace parts if seriously contamin-
ated.
If there is oil or water on each part check. the front
case oil seals, camshaft oil seal and water pump for
leaks.SERVICE POINTS OF INSTALLATION
MllKDDB
13. INSTALLATION OF AUTO TENSIONER
(‘I) If the auto tensioner rod is in its fully extended position,
reset it as follows.@ Keep the auto tensioner level
and: in that position,
clamp it in the vise with soft jaws.@ Push in the rod little by little with the vise until the
set hole @ in the rod is aligned with that @ in the
cylinder.
CautionPush in the rod slowly to prevent the push rod
from being damaged.@ Insert a wire [I
.4 mm (.055 in.) in diameter] into the
set
ho&.@ Unclamp the auto tensioner from the vise.
(2) Install the auto tensioner.
CautionLeave the wire installed in the auto tensioner.
1 TSB Revision
42-2BODY - SDecifications
SPECIFICATIONS
GENERAL SPECIFICATIONS
M42CA. -
Items
Hood
Type
Specifications
Rear hinged, front
opening type (with gas damper)
Door
Construction
Regulator system
Locking system
Liftgate
Type
Front-hinged, sashless
Wire type
Pin-fork type
Inner-hinged, with gas damper
Glass installation method
Windshield glassAdhesive type
Quarter window glassAdhesive type
Liftgate window glassAdhesive type
Glass thicknessmm (in.)
Windshield glass5.3 (.21)
Liftgate window glass3.5 (.I41
Door glass5.0 f.20)
Quarter window glass3.5 (.14)
Power window motor
TypePermanent magnet type (Built-in circuit breaker)
Revolutions under no load
rpm75 or more
Revolutions under load
vm
At 1 Nm (.72 ft.lbs.145-75
At 2 Nm (1.45 ft.lbs.)50-80
Bound current A
34 or less
Direction of rotationClockwise and counter-clockwise
Power window main switch
TypeAutomatic reset type
Rated load currentA
Lock switch
10Power window switch
10
Power window sub switch
TypeAutomatic reset type
Rated load currentA10
Power window relay
Maximum contact current
A20
Rated coil current
AMax. 0.2
Voltage drop between terminals
V0.2 or less
(At 12 V and the rated load current)TSB Revision
