F2 CONTROL SYSTEM
CONTROL
SYSTEM
STRUCTURAL VIEW
OXL STOPLIGHT SWITCH CLUTCH SWITCH
INJECTOR
P/S PRESSURE
SWITCH
‘GEN SE877
DtSTRIBUTOR
/ PUMP
CONTROL UNll
CONTROL UNIT
CONNECTOR
P REStSTORlRELAY
FUEL tNJ RELAY (MAIN RELAY)
AIRFLOW METER
SOLENOID VALVE
I NEUTRAL SWITCH
(PRESSURE REGULATOR)
WATER THERMOSENSOR
93GOf2.729
F2 TURBOCHARGERCONTROLSYSTEM
1. Radiator
2. Insulators
3.
Air hose, and air pipe
4. Oxygen
sensur connector
5. Front exhaust pipe
6. Bracket
1 I 93GOF2-765
93GOF2-761
7. Water hoses
8. Oil pipe
9. Oil return pipe
10. Exhaust
manifold and turbocharger
Removal Note . . . . . . . . . . . . . . . . . . . . . . .._.-........_ below
Installation Note . . . . ..__-.............._...___.._. below
93GOF2-763
Removal Note
Exhaust manifold and turbocharger
1. Remove the exhaust manifold and the turbocharger as an
assembly .
2. Remove the turbocharger from the exhaust
manifold.
InstaIlation Note
Exhaust manifold and turbocharger
1. Remove all gaskets and sealant.
2. Install new gaskets.
3. Supply 25 cc (1.5 cu in) of oil through the oil passage of
the turbocharger.
4. Install the turbocharger to the exhaust manifold.
5. Install the turbocharger and the exhaust manifold assem-
bly to the engine and loosely tighten the nuts.
6. install the bracket and the front exhaust pipe, and tighten
the turbocharger mounting nuts.
AIR BYPASS VALVE
Removal I Installation
1. Remove the vacuum hose and the air hoses from the air
bypass valve.
2. Remove the air bypass valve.
3. Install in the reverse order of removal.
Inspection
1. C_onnect a vacuum pump to air bypass valve port @-
2. Verify that air flows from port @through port @ when 250
f 35 mmHg (9.8 * 1.4 inHg) vacuum
is applied to port
0 a .
