1988 JEEP CHEROKEE relay
[x] Cancel search: relayPage 1252 of 1378
connections for
tight and clean
connections
Ignition switch faulty Adjust or replace
or misadjusted ignition switch as
necessary
\
\
\
\
\
\
\
Starter Cranks Battery weak or Charge or replace
Engine Slowly defective battery as necessary
Engine overheated See ENGINE COOLING
SYSTEM article
Engine oil too heavy Check that proper
viscosity oil
is used
Poor battery-to-starter Check that all
connections between
battery and starter are
clean and tight
Current draw too low or See Bench Tests in
too high STARTER article
Bent armature, loose pole See STARTER article
shoes screws or worn
bearings
Burned solenoid contacts Replace solenoid
Faulty starter Replace starter
\
\
\
\
\
\
\
Starter Engages Engine timing too far See Ignition Timing in
Engine Only advanced TUNE-UP article
Momentarily
Overrunning clutch not Replace overrunning
engaging properly clutch. See STARTER
article
Broken starter clutch See STARTER article
Broken teeth on engine Replace flywheel and
flywheel check starter pinion
gear for damage
Weak drive assembly See STARTER article
thrust spring
Weak hold-in coil See Bench Tests in
STARTER article
\
\
\
\
\
\
\
Starter Drive Defective point assembly See Testing in STARTER
Will Not Engage article
Poor point assembly ground See Testing in STARTER
article
Defective pull-in coil Replace starter
solenoid
\
\
\
\
\
\
\
Starter Relay Dead battery Charge or replace
Page 1253 of 1378
Does Not Close battery as necessary
Faulty wiring Check all wiring and
connections leading to
relay
Neutral safety switch Replace neutral safety
faulty switch
Starter relay faulty Replace starter relay
\
\
\
\
\
\
\
Starter Drive Starter motor loose on Tighten starter
Will Not mountings attach bolts
Disengage
Worn drive end bushing See STARTER article
Damaged engine flywheel Replace flywheel and
teeth starter pinion gear for
damage
Drive yolk return spring Replace return spring
broken or missing
Faulty ignition switch Replace ignition switch
Insufficient clearance Replace starter
between winding leads to solenoid
solenoid terminal and main
contact in solenoid
Starter clutch not Replace starter clutch
disengaging
Ignition starter switch Replace ignition switch
contacts sticking
\
\
\
\
\
\
\
Starter Relay Faulty solenoid switch, Check all wiring
Operates but switch connections or between relay and
Solenoid Does Not solenoid or replace
relay or solenoid as
necessary
Broken lead or loose Repair wire or wire
soldered connections connections as
necessary
\
\
\
\
\
\
\
Solenoid Plunger Weak battery Charge or replace
Vibrates When battery as necessary
Switch is Engaged
Solenoid contacts Clean contacts or
corroded replace solenoid
Faulty wiring Check all wiring
leading to solenoid
Broken connections inside Repair connections or
switch cover replace solenoid
Open hold-in wire Replace solenoid
\
\
\
\
\
\
\
Low Current Draw Worn brushes or weak Replace brushes or
brush springs as
necessary
Page 1361 of 1378
WIR IN G D IA G RAM S YM BO LS
1988 J e ep C hero ke e
WIRING DIAGRAMS
How To Use The Wiring Diagrams
WIRING DIAGRAMS
INTRODUCTION
The wiring diagrams and technical service bulletins,
containing wiring diagram changes, are obtained from the domestic and
import manufacturers. These are checked for accuracy and are all
redrawn into a consistent format for easy use.
All diagrams are arranged with the front of the vehicle at
the left side of the first page and the rear of the vehicle at the
right side of the last page. Accessories are shown near the end of the
diagram.
Components are shown in their approximate location on the
vehicle. Due to the constantly increasing number of components on
vehicles today, it is impossible to show exact locations.
In the past, when cars were simpler, diagrams were simpler.
All components were connected by wires, and diagrams seldom exceeded 4
pages in length. Today some wiring diagrams require more than 16
pages. It would be impractical to expect a service technician to trace
a wire from page 1 across every page to page 16.
Removing some of the wiring maze reduces eyestrain and time
wasted searching across several pages. Today, the majority of diagrams
now follow a much improved format, which permits space for internal
switch details and connector shapes.
Any wires that don't connect directly to their components are
identified on the diagram to indicate where they go. There is a legend
on the first page of each diagram, detailing component location. It
refers you to sub-systems, using grid NUMBERS at the top and bottom of
the page and grid LETTERS on each side. This grid system works in a
manner similar to that of a road map.
HOW TO USE THE WIRING DIAGRAMS
1) On the first page of the diagram, you will find a listing
of major electrical components or systems. Locate the specific
component or system you wish to trace. A grid number and letter will
follow the component's name.
2) Use the grid NUMBERS (arranged horizontally across the top\
and bottom of each page) to find the page of the wiring diagram that
contains the component you're seeking. When you reach this page, use
the grid LETTERS on the side of the page to determine the component's
vertical location.
3) Locate the circuit you need to service. The internals are
shown for switches and relays to assist you in understanding how the
circuit operates.
NOTE: In some of the newer wiring diagram articles in this
product, there is a Legend for the wiring diagrams that has
been created to make locating components easier. For these
articles, there will be a COMPONENT LOCATION MENU title in
the article main menu. These articles will also have the
original legend available on the first graphic.
Page 1364 of 1378
![JEEP CHEROKEE 1988 Service Repair Manual Voilet ................. VIO ................... VI
White .................. WHT ................... WT
Yellow ................. YEL ................... YL
\](/manual-img/16/57037/w960_57037-1363.png "JEEP CHEROKEE 1988 Service Repair Manual Voilet ................. VIO ................... VI
White .................. WHT ................... WT
Yellow ................. YEL ................... YL
\")
Voilet ................. VIO ................... VI
White .................. WHT ................... WT
Yellow ................. YEL ................... YL
\
\
\
\
\
\
WIRING DIAGRAM SYMBOL IDENTIFICATION
NOTE: Standard wiring symbols are used on diagrams. The list below
will help clarify any symbols that are not easily understood
at a glance. Most components are labeled "Motor", "Switch" or
"Relay" in addition to being drawn with the standard symbol.
WIRING DIAGRAM SYMBOLS
Views of the symbols used in the WIRING DIAGRAM articles are
in the following graphics. See Figs. 3 through 25.
Fig. 3: Circuit Breaker
Fig. 4: Coil (Internal)
Fig. 5: Connector
Fig. 6: Diode (In-Line)
Fig. 7: Diode (Internal)
Page 1369 of 1378
WIR IN G D IA G RAM S
1988 J e ep C hero ke e
1988 Wiring Diagrams
Jeep
Cherokee & Wagoneer
IDENTIFICATION
COMPONENT LOCATION MENU
COMPONENT LOCATIONS TABLE \
\
\
\
\
\
\
Component Figure No. (Location)
A/C & Htr Systems ............................... 5 (A-D 16-19)
Alternator ............................................ 1 (C 3)
Audio Alarm Module ................................... 7 (D 27)
Back-Up Lt Sw (M/T) .................................. 4 (D 12)
Battery ............................................... 1 (A 2)
Beam Sel Sw .......................................... 6 (E 23)
Brake Warning Sw ..................................... 6 (C 20)
Clock ................................................ 7 (E 27)
Clutch Switch ........................................ 4 (E 15)
Courtesy Lights ................................... 7 (C 24-26)
Cruise Ctrl Sys ................................... 4 (E 12-15)
Diag Conn D1 (2.5L) ................................... 3 (B 9)
Diag Conn D1 (4.0L) ................................... 2 (B 4)
Diag Conn D2 (2.5L) .................................. 3 (B 11)
Diag Conn D2 (4.0L) ................................... 2 (B 7)
DIR Hazard Sw ................................... 6 (D-E 20-21)
Door Switches ........................................ 7 (C 27)
Elect Ctrl Unit (2.5L) ............................. 3 (A 9-10)
Elect Ctrl Unit (4.0L) .............................. 2 (A 4-7)
Engine Compartment Lt ................................. 1 (C 1)
Fog Light Relay ....................................... 1 (D 2)
Fog Light Sw ...................................... 6 (E 21-22)
Fuel Pump Rly (2.5L) .................................. 3 (C 9)
Fuel Pump Rly (4.0L) ................................ 2 (E 5-6)
Fuel Tank Unit ....................................... 6 (B 20)
Fus Links ........................................... 1 (B 2-3)
Fuse Block ...................................... 4 (B-D 12-15)
4WD Switch ..................................... 6 (C 20, D 21)
Gear Sel Sw .......................................... 5 (C 16)
Glove Box Light ...................................... 7 (C 25)
Headlight Delay Module ............................... 6 (E 23)
Headlight Switch .................................. 6 (D 22-23)
Horn Relay ............................................ 1 (C 2)
Ignition Ctrl Mod (2.5L) ............................ 3 (B-C 8)
Ignition Ctrl Module (4.0L) ........................... 2 (E 4)
Ignition Key Warn Sw ................................. 7 (D 26)
Ignition Switch ................................... 4 (A 12-15)
Illum Lights .................................... 7 (C-D 24-25)
Instrument Cluster .............................. 6 (A-C 22-23)
Keyless Entry Module .............................. 7 (B 24-25)
Latch Rly (B+) (4.0L) ............................... 2 (B-C 4)
Power Antenna Rly .................................. 7 (D-E 27)
Power/Comfort Sw ..................................... 5 (D 19)
Power Door Lock Sys ............................. 7 (A-C 24-27)
Power Mirror Sw ................................. 7 (D-E 24-25)
Power Seat Sw ................................... 8 (A-B 28-29)
Page 1370 of 1378
Power Window Sys ................................ 7 (A-C 24-27)
Radiator Fan Rly (4.0L) ............................. 1 (C 1-2)
Radiator Fan Diode Assy ............................... 1 (C 3)
Radiator Temp Switch .................................. 1 (C 3)
Rear Defogger Unit ................................ 8 (D 28-29)
Rear Wiper/Washer Unit .......................... 8 (B-C 29-30)
Resistor Pack ........................................ 6 (E 21)
Rt Fnt Door Lock/Window Switch .................... 7 (B 26-27)
Starter Solenoid .................................... 1 (A 2-3)
Starter Solenoid Relay ................................ 1 (A 2)
Stop Light Switch .................................... 4 (E 15)
Trailer Towing Harness (Cherokee) ................. 8 (E 28-31)
Trailer Towing Harness (Wagoneer) ................. 8 (A 28-31)
Trans Ctrl Unit ................................. 5 (D-E 16-19)
Upshift Sw (2.5L) .................................... 6 (C 21)
Vanity Lights ........................................ 7 (C 24)
Washer Fluid Level Sw ................................ 3 (D 11)
Wiper/Washer System .............................. 3 (D-E 8-11)
\
\
\
\
\
\
\
WIRING DIAGRAMS