MAIN TE N AN CE R EM IN DER L IG HT R ESET P R O CED URES
1988 J e ep C hero ke e
1988-92 MAINTENANCE
Chrysler Motors Maintenance Reminder Lights
Jeep; Cherokee, Comanche, Wagoneer (1988-90), Wrangler
EMISSION MAINTENANCE INDICATOR LIGHT (1988-90)
Vehicles are equipped with an emission maintenance indicator
light on instrument cluster. This light will come on one time at 82,
500 miles to alert driver that emission service is required. At this
time, oxygen sensor and PCV valve must be replaced and all other
emission components should be inspected and serviced or replaced as
necessary.
Indicator timer is located under dash, near accelerator pedal
or to right of steering column. Timer cannot be reset. To turn off
light, timer must be replaced or disconnected. Since timer and sensor
are interdependent, if timer should fail prematurely, oxygen sensor
should be replaced at same time to preserve correct replacement
interval.
To replace timer on Cherokee, Comanche and Wagoneer models,
remove cruise control module (if equipped). Remove timer mounting
screws. Disconnect electrical connector. On Wrangler models, remove
timer mounting screws. Disconnect electrical connector. On all models,
install remaining components.
EMISSION MAINTENANCE INDICATOR LIGHT (1991-92)
Vehicles are equipped with an emission maintenance indicator
light on instrument cluster. This light will come on one time at 82,
500 miles to alert driver that emission service is required. At this
time, oxygen sensor must be replaced and all other emission components
should be inspected and serviced or replaced as necessary. Chrysler's
Diagnostic Readout Box (DRB-II) tester is required to reset the
emission maintenance indicator light.
Reset Procedure
Using DRB-II tester, access SELECT SYSTEMS. Select
appropriate engine. Select with or without A/C. Select FUEL &
IGNITION. Select ADJUSTMENTS. Select RESET EMR LIGHT. Reset EMR light.
When DRB-II is finished resetting light, DRB-II display will read EMR
LIGHT IS RESET.
