1984 NISSAN 300ZX light

REAR WINDOW DEFOGGER
Filament Check (Cont'd)
3 To locate burned out point, move probe to left
and right along filament to determine point
where
tester needle swings abruptly
/AI 1-1
SEL266
Filament Repair
REPAIR EQUIPMENT
1 Conductive silver composition
(Dupont No 4817 or equivalent)
2 Ruler, 30 cm (1 1 8 in) long
3 Drawingpen
4 Heatgun
5 Alcohol
6 Cloth
REPAIRING PROCEDURE
1 Wipe broken heat wire and its surrounding area
clean with
a cloth dampened in alcohol
2 Apply a small amount of conductive silver
composition to tip of drawing pen
Shake silver composition container before use.
3. Place ruler on glass along broken line. Deposit
conductive silver composition on break with
drawing pen Slightly overlap existing heat wire
on both sides [preferably 5 mm (020 in)] of
the break.
Funit Drawmg pen Ruler mm (In]
BE540
4 After repair has been completed, check re-
paired wire for continuity This check should
be conducted
10 minutes after silver composi-
tion
is deposited
Do not touch repaired area while test is being con-
ducted
r point
SEL0120
5 Apply a constant stream of hot air directly to
the repaired area for approximately
20 minutes
with
a heat gun A minimum distance of 3 cm
(1 2 in) should be kept between repaired area
and hot
air outlet If a heat gun is not available,
let the repaired area dry for 24 hours.
Repaired Point
Heat gun
SEL0130
EL-94

@3 Fuse block
TOEFI H
A S C D control unit
To door harness
L H White)
To door harness L H (Blue)
To door harness L H (SF models) To 0 (Blue) (CLL models)
To
@ (White)
To @ (Non-turbocharger models)
. Clutch switch (A S C D ) . Stop switch (A S C D ) Stop lamp switch
Step lamp L H
Kickdown switch (A/T models)
Lightlng switch
Wiper switch
Horn switch
Key
lamp
ul
Cigarette hghter
Ash tray lamp
Step lamp R H
To @I (Blue)
To 0 Wite)
Flasher unit
Ignition switch
AS C D switch
Headlamp switch
Intermittent wiper tune
control
Steermg lock swltch
An conditioner harness
Au conditioner harness Au conditioner harness To 0 (Non-turbocharger models) To 0 (Turbocharger models) @ To @I (Black)
To @ (Blue) To @ (White) @ Tune control unit
TO door harness R H (ST models)
To door harness R H (CL and GLL models)
To door harness
R H (GL and GLL models)
@ . To @I (Blue) (GLL models)
@ Voice warning unit
I@
@J
To E P I harness (Non-turbocharger models)
To E P I harness

,
TO TIME CON-
TROL UNIT
TO INST H LH (CHIME)
TO ENGINE
ROOM
H R H (UPHOLD RELAY)
TO ENGINE ROOM H L H IHEAO-
TO LIGHT SW TO LIGHT SW -
TO REAR
ro KEY sw
3OOM H R H A S C 0 RELAY1 To As sw (VACUUM ROOM H L H
PUMP RELAY)
(For time control system, headlamp system, AS C 0 and E F I system1

Diode
L & GLLxodelr
TO ENGINE ROOM
H R H (HORN RELAY]
HRH
ITHEFT
WARNING RELAY-11
TO ENGINE ROOM
TO THEFT WARNING
CONTROL UNIT
TO HORN SWJ
TO BACK DOOR SW TOTHEFT WARNING 3TlME CONTROL UNIT CONTROL UNIT
TO ENGINE ROOM H R H ro INST H R H :DOOR WARNING LAMPI sw TOEFI H
TO LIGHT SW TO ENGINE ROOM H R H (POWER
STEERING SWI
TO INJECTOR BLOWER IFAN MOTOR RELAY)
(For theft warning system & E F I systeml
ode 6&
F model9
Not used
TOEFI H
TO ENGINE ROOM
HRH (POWER
STEERING SWI
TO LIGHT SW
TO FUSE
TO REAR
DEFOGGERRELAY
(For E F I system1 ode
TO TIME CONTROL
TO INST H
L H
TO ENGINE ROOM H
TO KEY SW UNIT
TO ENGINE ROOM H L H
(HEADLAMP MOTOR) (CHIME]
TO LIGHT SW
TO LIGHT SW IUPHOLD RELAY)
TO STEP LAMP TO DOOR SW R H
TO TIME
CONTROL UNIT
[For headlemp system & time control system)
Itode @
TO BACK DOOR ,LOCK SW
TO DOOR SW L H
TO DOOR SW R H
TO DOOR H LH
TO DOOR H
RH
TO VOICE WARNING UNIT AN0
TllEFT WARNING COhTROL UNIT
TO THEFT
WARNING
rCONTROL UNIT
TO BACK
DOOR SW
TO
DOOR SWRH
TO INST H R H (DOOR WARN-
ING LAMP)
TO TIME CONTROL UNIT
(Far voice warning system & theft warning system)
(Far theft warning system & tlme control system)
Turbocharger models
Nan turbocharger models
2+2 seater
2 seater
Door muror defogger swtch
A/T indicator lamp
RcmGlc
con1;a: miiiDi 8...itCh
0 D switch (AIT models)
Headlamp
cleaner switch
Shock absorber switch (Turbocharger models)
Body ground
Diode Diode
(Sf modcls)
Diode (GL and GLL models)
Diode (2+2 seater)
Theft warning control unit Seat belt switch R H (GLL models)
0, Sensor control amp (GLL models)
Parking brake switch
Radio amphfier
(GLL models)
Seal
bell switch L H (SF models) Seat belt switch L H (GL models) lo power seat harness (GLL models)
Body ground
(GLL models)
Didoe
(GL and GLL models)
Body ground (GLL models)
Body ground
(GLL models)
I