TROUBLE-SHOOTING AND DIAGNOSES
Inspection of O.D. Control
OK operates normally
Running test1
AIT is defective
(Case 0)
END OK
@ Check if 0 D is not released when power shift switch
@ Check if 0 D is not released in full throttle condition
is turned on
NG witch OK
N.G +
( Is power shift switch normal,) I ,
0. K
Check if 0 D cancel sole-
noid connector
is properly
connected and functions
normally
Replace solenoid
I
/Check if control unit connector
IS properly connected
Check
if connector is soaked
with water
I (Inspection-2)
NG OK
INSPECTION POINTS
Qlecking method Inspection
No Item to be checked
'I 0 D solenoid Turn on key and set 0 D switch to "0 D release" position to see
if 0 D solenoid clicks I I
Inspect following items given in flow chart on pages AT-75 and 76
Shift switches (1-2, 2-3 and 34)
Input signals 21
0 Vehicle speed sensor
0 Lowtemperature sensor
0 Full throttle contact switch
Kickdown switch
AT-79
