07-04-28
C-6 Automatic Transmission
07-04-28
SNAP RING
REMOVAL INSTALLATION
FIG. 48 — Replacing Reverse-High Clutch Rear Bushing
D2035-A
Press Ram
Tool-T69L-7D044-A
D2036-A
FIG. 49—Installing Reverse-High
Clutch Front Bushing
D1898-A
FIG. 50—Checking Reverse-High
Clutch Snap Ring Clearance
ONE-WAY CLUTCH
Disassembly
1.
Remove the snap ring and rear
bushing from the rear of the low-
reverse clutch hub (Fig. 59).
2.
Remove the springs and rollers
from the spring retainer and lift the
spring retainer from the hub.
3.
Remove the remaining bushing
and snap ring from the hub.
Assembly
1.
Install a snap ring in the forward
snap ring groove of the low-reverse
clutch hub.
2.
Place the low-reverse clutch hub
on the bench with the forward end
down (Fig. 60).
3.
Place the forward clutch bushing
against the snap ring with the flat side
up.
Install the one-way clutch spring
retainer on top of the bushing. Be sure
to install the retainer in the hub so
that the springs load the rollers in a
counterclockwise direction when look-
ing down at the unit (Fig. 60).
4.
Install a spring and roller into
each of the spring retainer compart-
ments by slightly compressing each
spring and positioning the roller be-
tween the spring and the spring retain-
er (Fig. 60).
5.
Install the rear bushing on top of
the retainer with the flat side down.
6. Install the remaining snap ring
at the rear of the low-reverse clutch
hub to secure the assembly.
SERVO
Disassembly
1.
Apply air pressure to the port in
the servo cover to remove the piston
and rod.
2.
Remove the seals from the pis-
ton.
On Lincoln Continental and Conti-
nental Mark III models, replace the
complete piston and rod assembly if
the piston or piston sealing lips are
unserviceable or damaged.
3.
Remove the seal from the cover.
D1899-A
FIG. 51—Removing Forward
Clutch Pressure Plate Snap Ring
Assembly
1.
Dip the new seals in transmission
fluid.
2.
Install new seals on the cover
and servo piston. Fig. 61 shows the
correct servo piston and cover for the
transmission.
3.
Dip the piston in transmission
fluid and install it in the cover.
LOW-REVERSE CLUTCH
PISTON
Disassembly
1.
Remove the inner and the outer
seal from the reverse clutch piston.
Assembly
1.
Dip the two new seals in clean
transmission fluid.
2.
Install the seals on the piston.
OUTPUT SHAFT
Disassembly
1.
Remove the governor attaching
bolts and remove the governor.
2.
Remove the snap ring that se-
cures the governor distributor on the
output shaft (Fig. 62) and slide it off
the front of the shaft.
3.
Remove the seal rings from the
distributor.
Assembly
1.
Carefully install new seal rings
on the distributor.
2.
Working from the front end of
the output shaft, slide the governorprocarmanuals.com
