2024 MAZDA CX90 lights

CAUTION
Handle the cameras appropriately. If the cameras are handled incorrectly, images
may not be displayed normally.
Refer to Cameras on page 5-137.
 Do not use the 360° view monitor in th e following locations or conditions.
 Bumpy roads
 The vehicle is on a road incline.
 Icy or snow-covered roads
 Tire chains or a temporary spare tire is installed.
 The doors are not fully closed.
 The outside mirrors are retracted.
 If the doors are not completely closed, images and guide lines may not be
displayed correctly.
 Heed the following cautions to assure that the 360° view monitor operates
normally.
 Do not modify the suspensions.
 Always use wheels of the specified size for the front and rear wheels. Consult an
Authorized Mazda Dealer for tire replacement.
 When the center display is cold, images may leave trails or the display might be
darker than usual, making it difficult to check the vehicle surroundings. Always
confirm the safety around the vehicle visually when driving.
 Recognizing images at night may be
difficult because there are no lights in the
shooting range of the side camera. Always confirm the safety around the vehicle
visually when driving.
 The method for parking/stopping the vehicle using the 360° View Monitor
differs
depending on the road conditions and ve hicle conditions. In addition, when and
how much you turn the steering wheel will differ depending on the situation,
therefore always check the vehicle surroundings directly with your eyes while using
the system.
Driving
360° View Monitor
5-211
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Secondary CollisionReduction
*
The Secondary Collision Reduction
reduces secondary damage by
decelerating the vehicle when it is
damaged in a collision to the extent
that the airbags are deployed while
driving.
If a collision occurs to the extent that
the airbags are deployed while driving,
the hazard warning lights flash to alert
surrounding vehicles and the brakes
are controlled to reduce damage in the
event of a collision with an obstruction
or other object.
Warnings and Cautions
for Using the Secondary Collision Reduction
WARNING
Do not rely completely on the
Secondary Collision Reduction.
The Secondary Collision Reduction
may not operate normally depending
on various conditions such as the
accident condition, component part
damage condition, target object
condition, weather conditions, or
traffic conditions. Do not rely
completely on the system and make
it your responsibility as a driver to
drive the vehicle.
 The functions of the Secondary
Collision Reduction have limitations.
If you neglect to operate the brake
and accelerator pedals correctly, it
could result in serious injury.
Driving
Secondary Collision Reduction
*Some models.5-223
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

How to Use the
Secondary Collision Reduction
When the Secondary Collision
Reduction operates
The Secondary Collision Reduction
operates if the vehicle is damaged in a
collision to the extent that the airbags
are deployed while driving.

When the Secondary Collision
Reduction operates, the system
controls and applies the brakes until
the vehicle stops. In addition, the
hazard warning lights continue to flash.
After the vehicle stops, the parking
brake is applied by the Electric Parking
Brake (EPB).
NOTE
The brake lights turn on while the
brakes are operating by the system
control.
If there is a malfunction with the
electric parking brake (EPB), the
brakes are released by the system
control after the vehicle is stopped.
The settings for the Secondary
Collision Reduction system differ
depending on the grade/specification-separate equipment.
Secondary Collision Reduction is
disabled
If any of the following conditions is
met, the Second ary Collision
Reduction is canceled.
A certain period of time has passed
since the system operated.
After stopping the vehicle, the
accelerator pedal is strongly
depressed 3 times.
The parking brake is released after
the Electric Parking Brake (EPB)
operates.
NOTE
If the driver's brake pedal depression
force is stronger than the system's
brake control, the driver's brake
operation takes priority.
Flashing of the hazard warning lights
by the system control is canceled
when any of the following operations
is performed.
Hazard warning light switch is
pressed.
Vehicle power is switched OFF.
Driving
Secondary Collision Reduction
5-224
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

While the cruise control is operating,
the driver is notified of the operation
condition by the screen display.
Instrument cluster
1. Set speed

Active driving display
1. Set speed
NOTE
The cruise control does not operate
when the Hill Descent Control is
operating.
While in EV mode, acceleration may
be restricted and the vehicle may not
be able to be driven at the set speed.
Refer to Mazda intelligent Drive
Select (Mi-Drive) on page 5-95.
The accelerator pedal operation
takes priority during constant speed
driving. When you release your foot
from the accelerator pedal, the
vehicle returns to constant speed
driving at the set speed.
(Vehicles with Mazda Radar Cruise
Control with Stop & Go function
(MRCC with Stop & Go function))
If the distance between vehicles
control is disabled using the Mazda
Connect, the system switches to the
cruise control. At this time, the
MRCC switch functions as the cruise
control switch.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
If the vehicle power is switched OFF
while the distance between vehicles
control is disabled, the distance
between vehicles control is enabled
automatically the next time the
vehicle power is switched ON.
The system may not be able to
maintain the set speed depending
on the road conditions such as steep
up or down slopes.
When the vehicle speed is less than
20 km/h (12 mph), the cruise
control is canceled. If you want to
use the cruise control again, reset the
cruise control.
The brake lights turn on while the
brakes are operating by the cruise
control.
The cruise control cannot be
canceled while driving in manual
shift mode (selector lever shifted
from the D to M position).
Therefore, engine braking does not
work even if you shift down to a
lower gear. If deceleration is
required, lower the set vehicle speed
or depress the brake pedal.
Changing the set vehicle speed
Changing the set vehicle speed using
the RES switch
Press the RES switch up (SET+) or
down (SET-) to the desired speed.
Press and release immediately: 1
km/h (1 mph)
Press and hold: 10 km/h (5 mph)
Driving
Cruise Control
5-227
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Interior Lights......................... 7-41Illuminated Entry System.......7-41
How to Use the Illuminated Entry
System................................ 7-41
How to Use the Overhead
Lights.................................. 7-42
How to Use the Map Lights..........
.......................................... 7-43
How to Use the Door Courtesy
Lights.................................. 7-44
How to Use the Luggage
Compartment Lights............ 7-44
How to Use the Ambient
Lights.................................. 7-45
Accessory Sockets................... 7-46 Accessory Sockets................ 7-46
Warnings and Cautions When
Using the Accessory Socket ..........
.......................................... 7-46
How to Use the Accessory
Socket.................................7-47
AC Power Outlet (120 V/150
W)...................................... 7-47
Warnings and Cautions When
Using the AC Power Outlet (120
V/150 W)........................... 7-48
How to Use the AC Power Outlet
(120 V/150 W)................... 7-49
AC Power Outlet (120 V/1,500
W)...................................... 7-50
Warnings and Cautions When
Using the AC Power Outlet (120
V/1,500 W)........................ 7-50
How to Use the AC Power Outlet
(120 V/1,500 W).................7-51
USB Power Outlet................ 7-52
Warnings and Cautions When
Using the USB Power
Outlet................................. 7-53How to Use the USB Power
Outlet................................. 7-53
Wireless Charger (Qi).............. 7-54 Wireless Charger (Qi)........... 7-54
Warnings and Cautions When
Using the Wireless Charger
(Qi).................................... 7-54
How to Use the Wireless Charger
(Qi).................................... 7-56
Convenient Ways to Use the
Wireless Charger (Qi)........... 7-57
Assist Grip..............................7-58 Warnings and Cautions When
Using the Assist Grips........... 7-58
How to Use the Assist
Grips.................................. 7-58
Towing (U.S.A. and Canada)..... 7-59 Towing................................ 7-59
Warnings and Cautions for Using
the Towing.......................... 7-60
How to Use the Towing........ 7-62
HomeLink Wireless Control
System...................................7-68 HomeLink Wireless Control
System................................ 7-68
Warning and Cautions for Using
the HomeLink Wireless Control
System................................ 7-68
How to Use the HomeLink
Wireless Control System....... 7-69
Accessories............................ 7-73 Warnings and Cautions For Using
the Accessories.................... 7-73
7-2
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Illuminated Entry System
The interior lights turn on/off in
conjunction with the opening/closing
of the doors and the position of the
vehicle power (ON/OFF).
How to Use the
Illuminated Entry System
The overhead lights turn on when any
of the following operations is done
with the overhead light switch in the
DOOR-linked position.
The driver's door is unlocked with
the vehicle power switched OFF.
The vehicle power is switched OFF
with all doors closed.
The overhead lights turns off when any
of the following operations is done.
The driver's door is locked.The vehicle power is switched ON.
When the vehicle power is switched
OFF and the interior lights remain on,
they turn off after a certain period of
time has passed.
NOTE
The amount of time until the
illuminated entry system turns off can
be changed.
Refer to Mazda Connect Owner's
Manual or consult an Authorized
Mazda Dealer.
The illuminated entry system does
not operate when the overhead
lights are turned on by operating the
overhead light ON/OFF switch.
Other Equipment
Interior Lights
7-41
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

How to Use the
Overhead Lights
Front
The overhead lights turn on.
Press the
switch again to turn off
the overhead lights.
When the door interlock is ON
The indicator light in the switch
turns off.
The lights turn on when any of the
doors is opened.
The light turns on/off depending on
the illumination entry system.
When the door interlock is OFF
The indicator light in the switch turns
on.
Center
The center overhead lights also turns
on/off in conjunction with the
operation of the front overhead lights.
Ty p e A
Ty p e B
Rear
The rear overhead lights also turns
on/off in conjunction with the
operation of the front overhead lights.
Other Equipment
Interior Lights
7-42
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

How to Use the MapLights
Front
The map light turns on.
Press the switch again to turn off the
map lights.
Rear
Ty p e A
Ty p e B
The map light turns on.
Press the switch again to turn off the
map lights.
NOTE
Pressing the switch does not turn the
lights off in any of the following
cases.
When the light is turned on by
operating an overhead light
switch.When the illuminated entry system
is operating.
(Rear)
Once the rear map lights have been
turned off, they will turn
on/off in
conjunction with the operation of an
overhead light switch.
Other Equipment
Interior Lights
7-43
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04