2024 MAZDA CX90 change time

Active driving display
The CTS is temporarily canceled
Constant speed/Headway control function
If any of the following conditions is met, the constant speed/headway control
function is temporarily canceled.
The brake pedal is depressed.The CANCEL switch is pressed one time.The DSC has operated.The Smart Brake Support (SBS) has operated.The front radar sensors cannot detect target objects.The parking brake is applied.Any door is opened.The driver’s seat belt is unfastened.The frequency of the braking operation by the CTS is high.
If the constant speed/headway control function is temporarily canceled, it will
resume operation at the previously se t speed by pressing the RES switch.
Steering assist function
If any of the following conditions is met, the steering assist function is temporarily
canceled. The steering assist function is automatically restored when its operation
conditions are met.
The constant speed/headway control function is canceled.White (yellow) lane lines cannot be detected or a vehicle ahead cannot be
recognized.
The turn signal lever is operated.The steering wheel is operated abruptly.Hands are off the steering wheel.The vehicle is making a sharp curve.The vehicle crosses a lane line.The width of the vehicle lane is narrow or wide.
NOTE
The notification method when the steering assist function is canceled can be
changed.
Refer to the Settings section in the Mazda Connect Owner's Manual.
Driving
Cruising &
Tra ffi c Support (CTS)
5-186
CX-90_8KG7-EA-22L_Edition1_new
2022-11-17 16:05:04

1. “BRAKE!”

Active driving display
1. “BRAKE!”
NOTE
If any of the following conditions is
met, the forward detection function
may not operate normally.
The Forward Sensing Camera (FSC)
cannot detect target objects.
Refer to Forward Sensing Camera
(FSC) on page 5-127.
The front radar sensor cannot
detect target objects.
Refer to Radar Sensors on page
5-131.
When there is the possibility of a
partial contact with a target object.
The driver deliberately performs
driving operations (accelerator pedal
operation, steering wheel operation,
selector lever operation, and turn
signal lever operation).
If any of the follo wing conditions is
met, the forward detection function
may operate.
An animal or object on the road is
detected.
Passing an approaching vehicle
while rounding a curve.
Vehicle is passing through a narrow
gate or a gate with a low ceiling.
There is a metal object, bump, or a
protruding object on the road.
(Vehicles with Driver Monitoring
(DM))
If the system determines that the
driver is not paying attention to the
road, it activates the collision
warning earlier than normal.
If the forward detection function
performs brake control and the
vehicle is stopped, the system will
continue to hold the brakes for a
brief time unless there is an
operation performed by the driver.
The operation distance and volume
of the collision warning can be
changed.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
The Turn-Across Tra ffi c operation
conditions*
The Turn-Across
Tra ffi c operates when
all of the following conditions are met.
The vehicle speed is about 4 km/h
to 20 km/h (3 mph to 12 mph).
The left turn signal light is turned on
and the vehicle is turning left.
A lane line between your vehicle and
the vehicle approaching in the
opposite direction is detected.
The system determines that there is a
possibility of collision with an object
ahead.
When the Turn-Across Tra ffi c operates,
the driver is notified of the danger by
the screen display and warning sound.
Furthermore, if the possibility of a
collision increases, brake control is
performed.
Instrument cluster
Driving
Smart Brake Support (SBS)
*Some models.5-201
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Operating Each Switch
AUTO switch
Automatically controlled according to
the set temperature.
Temperature setting switch
How to increase the set temperature
How to decrease the set temperature
NOTE
The set temperature changes in
increments of 0.5 ℃ within a range
of 15 ℃ (60 °F) and 29 ℃ (84 °F).
The set temperature can be quickly
adjusted by pressing and holding the
temperature setting switch.
When the temperature is set to the
lower or upper limit, “Lo” or “Hi” is
displayed.
SYNC (synchronized temperature)
switch
The mode switches between
independent mode and
interconnection mode each time the
switch is pressed.
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-8
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Independent mode (indicator light
turned off)
The set temperature can be controlled
independently for the driver's side and
front passenger's side.
Press the driver’s side temperature
setting switch or the front passenger’s
side temperature setting switch to
control the temperature.
Interconnection mode (indicator light
turned on)
The set temperature for the driver's
side and front passenger's side is
controlled simultaneously.
Press the driver's side temperature
setting switch to control the
temperature.
NOTE
The set temperature for the front
passenger's side and the rear (while
the rear climate control system is
ON) changes to that of the driver
when independent mode is switched
to interconnection mode.
When the front passenger’s side
temperature setting switch or the
rear temperature setting switch is
pressed while in interconnection
mode (SYNC switch indicator light
turned on), the mode switches to
independent mode (SYNC switch
indicator light turned off).
A/C switch
The cooling/dehumidifying function
switches between on and off each time
the switch is pressed. The indicator
light turns on while the function is
operating.
NOTE
The air conditioner may not operate
when the ambient temperature falls to
nearly 0 ℃ to protect the system.
Rear window defogger switch
Use to defog the rear window.
Refer to How to Use the Rear Window
Defogger Switch on page 5-79.
Air intake selector switch
The mode is switched between
recirculate mode and fresh air mode
each time the switch is pressed.
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-9
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

The display indicates whether
recirculate mode (
) or fresh air
mode (
) is selected.
WARNING
Do not recirculate the air in the cabin
during cold or rainy weather.
Recirculating the air in the cabin during
cold and rainy weather is dangerous as
it will cause the windows to fog up.
Your vision will be hampered, which
could lead to a serious accident.
Recirculate mode (
)
Outside air is shut off. Air within the
vehicle is recirculated. Use this
position when going through tunnels,
driving in congested traffic (high engine
exhaust areas) or when quick cooling is
desired.
Fresh air mode (
)
Outside air is allowed to enter the
cabin.
Use this mode for ventilation or
windshield defrosting.
NOTE
The recirculated air position is the
default position whenever the
ignition is switched ON, the climate
control system is on, and the outside
temperature exceeds about 73 °F
(23 ℃).
To exit the default recirculated air
position, press the air intake selector
switch to select the outside air
position.
When the air intake selector switch is
set to the outside air position and
the outside temperature exceeds
about 73 °F (23 ℃), the climate
control system may automatically
select the recirculated air position to
improve the efficiency of the climate
control system.
Mode selector switch
The desired airflow mode can be
selected.
The mode changes each time the
switch is pressed. The selected mode is
indicated on the display.
NOTE
To set the air vent to press the
windshield defroster switch.
Fan control switch
How to increase the airflow amount
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-10
CX-90_8KG7-EA-22L_Edition1_new
2022-11-17 16:05:04

How to decrease the airflow amount
The airflow amount changes each time
the switch is pressed. The airflow
amount is indicated on the display.
The airflow amount can be adjusted to
7 levels.
Climate control system power switch
(system on/off)
Switches the climate control system on
and off.
The indicator light turns on while the
function is operating.
Windshield defroster switch
Use to defrost the windshield and front
windows.
Automatically switches to fresh air
mode. The indicator light turns on.
WARNING
Do not lower the airflow temperature
when defrosting the windshield.
Otherwise, the outer side of the
windshield will frost causing reduced
visibility which may lead to an
accident.
NOTE
For faster defrosting , do any of the
following operations.
Operate the fan switch and
increase the airflow amount.
Press the temperature setting
switch to increase the airflow
temperature.
Be careful that the windows do not
fog up when doing any of the
following operations.
Switch to recirculate mode.Tu r n o ff t h e a i r co n d i t i o n e r.
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-11
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

During the cabin preconditioning
operation, the cooling fan, the
compressor, and the cabin fans
operate, but this does not indicate a
problem.
 The climate control system functions
you can use
differ depending on the
vehicle power position.
Function Vehicle power position
OFF ACC ON
(Hy- brid sys-
tem off) ON
(Hy- brid sys-
tem on)
Air circulation — — X X
Cooling/heating — — X
*1X
Climate Control
Timer X———
Remote climate
control X———
X: Available
—: Not available
*1 The cooling/heating function can
be used only while charging.
NOTE
The recommended set temperature
is 22 °C (72 °F). If you set an
extremely high or low temperature,
power consumption will increase
and the charging time will take
longer.
If you operate the cabin
preconditioning while the charge
connector is connected, you can
reduce the electric power
consumption of the high voltage
battery.
While the cabin preconditioning is
operating , the indicator light for the
climate control power switch turns
on.
The cabin preconditioning operates
for 20 minutes. If you set the
departure time using the climate
control timer, set it 20 minutes or
later from the current time and if you
want to make several settings, space
them out at intervals of 30 minutes
or longer.
How to set the Climate Control Timer
1. Select “Settings” from the Mazda Connect home screen.
2. Select “EV Settings”.
3. Select “Climate Control Timer”.
4. Select the item setting you would like to change from the displayed
content.
5. Switch the vehicle power OFF.
Climate Control Timer
Allows climate control to adjust cabin
temperature before driving.
Function Available setting changes
1 ---
Enable,
Disable
*1Edit,
Delete*2
2 ---
3 ---
4 ---
5 ---
6 ---
7 ---
*1 If an item selected using the cursor has been set, the item can be
enabled or disabled.
*2 Settings can be “Edit”/“Delete” bysliding an item selected using the
cursor to the right.
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-13
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Edit
The Climate Control Timer settings can
be edited.
FunctionAvailable setting
changes
Departure Time Time
(10-minute inter- vals)
Repeat
*1Monday ― Sun-
day
Te m p e ra t u r e 15.5
℃ (61 ℉) ―
28.5℃ (83 ℉)
Front Defroster Enable,
Disable
Rear Defroster Enable,
Disable
*1 If no [Repeat] day is set, the climate control timer operates only
1 time at the set hours.
NOTE
Enabling “Front Defroster” /“Rear
Defroster” will aid you in defrosting
and removing ice or snow from the
window glass. The recommended set
temperature when setting the
defroster is 22 °C (72 °F) or higher.
The defroster performance changes
according to the set temperature.
The climate control timer does not
work if the vehicle is left unattended
for a long period of time in an
environment where GPS signal
reception is difficult, such as in an
underground parking lot or indoors,
or if GPS signals are not received.
When GPS signals are received, the
climate control timer becomes
operational.
The climate control timer does not
operate while the remote climate
control is operating.
The climate control timer can be
stopped by a Smartphone remote
control operation using the
Connected Service.
For details, consult an Authorized
Mazda Dealer.
How to Set the Remote Climate
Control
To use the remote climate control, it is
necessary to subscribe to Connected
Service.
For details, consult an Authorized
Mazda Dealer.
Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Front)
6-14
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04