2024 MAZDA CX90 Gas

Warnings and Cautionsfor Using the Towing
WARNING
Always keep tow loads within
specified limits as indicated in the
Trailer Towing-Load Table:
Attempting to tow loads greater than
those specified is dangerous as it may
cause serious handling and
performance problems that could
result in personal injury or vehicle
damage, or both.
Load your trailer with the weight
about 60 % toward the front and
40 % toward the rear:
Loading the trailer with more weight in
the rear than in the front is dangerous.
Doing so could cause you to lose
control. The trailer tongue load must
be 10 % ―15 % of the total trailer load
(sum of the weights of the trailer and
cargo).
Always have the total trailer weight
and tongue load determined prior to
departure:
Attempting to tow loads without
determining the total trailer weight and
tongue load is dangerous. Trailer sway
from crosswinds, rough roads or other
causes could result in loss of control
and a serious accident.
Always make sure the trailer hitch is
securely attached before departure:
An unsecured trailer hitch is dangerous
as it causes greater trailer sway from
crosswinds, rough roads or other
causes, resulting in loss of control and
a serious accident.
Examine all trailer-hitch mounting
bolts regularly and tighten any that are
loose. If the hitch is removed, seal any
open mounting holes to prevent
exhaust, dust, water, dirt and other
foreign elements from filtering in,
possibly endangering personal safety
and damaging your vehicle.
Do not install a hitch that stiffens the
bumper as it will reduce the bumper's
performance.
Make sure there are no exhaust gas
leaks into the passenger compartment
if any mounting bolts are connected
to the body:
Modifying your vehicle exhaust system
is dangerous. Exhaust gas entering the
vehicle could cause loss of
consciousness or even death.
When mounting the trailer hitch, make
no modifications to the vehicle exhaust
system.
Never use the temporary spare tire
when towing:
Using the temporary spare tire on your
vehicle when towing a trailer is
dangerous as it could result in tire
failure, loss of control, and injury to
vehicle occupants.
Make sure the safety chain is securely
attached to both the trailer and the
vehicle prior to departure:
Towing a trailer without using a safety
chain securely attached to both the
trailer and the vehicle is dangerous. If
damage occurs to the coupling unit or
hitch ball, the trailer could wander into
another lane and cause a collision.
Other Equipment
Towing (U.S.A. and Canada)
7-60
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Taking Action with Depleted Lead-acid Battery
The lead-acid battery might be depleted if the following conditions occur.
The hybrid system does not start.The selector lever cannot be shifted to a position other than P.The horn sound is weak or it does not sound.The brightness of the lights is extremely low.
Using commercially available booster cables, connect the lead-acid battery of the
booster vehicle’s battery to the lead-acid battery of your vehicle and start the hybrid
system.
Jump-starting is dangerous if done incorr ectly. Therefore, follow the procedure
carefully. If you feel unsure about jump-s tarting , we strongly recommend that you
have a competent service technician do the work.
WARNING
Read the following precautions carefully before using the lead-acid
battery or inspecting to ensure safe and correct handling.
Always wear eye protection when working near the lead-acid battery.
Working without eye protection is dangerous. Lead-acid battery fluid contains
SULFURIC ACID which could cause blindne ss if splashed into your eyes. Also,
hydrogen gas produced during normal lead-acid battery operation, could ignite and
cause the lead-acid battery to explode.
Wear eye protection and protective gloves to prevent contact with
lead-acid battery fluid.
Spilled lead-acid battery fluid is dangerous.
Lead-acid battery fluid contains SULFURIC ACID which could cause serious injuries if
it gets in eyes, or on the skin or clothing. If this happens, immediately flush your eyes
with water for 15 minutes or wash your skin thoroughly and get medical attention.
Always keep lead-acid batteries out of the reach of children.
Allowing children to play near lead-acid batteries is dangerous. Lead-acid battery
fluid could cause serious injuries if it gets in the eyes or on the skin.
What to Do in Case of Emergency
Engine Does Not Start
8-11
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Keep flames and sparks away from lead-acid battery cells and do not
allow metal tools to contact the positive (+) or negative (-) terminal of the
lead-acid battery when working near a lead-acid battery. Do not allow the
positive (+) terminal to contact the vehicle body.
Flames and sparks near lead-acid battery cells are dangerous. Hydrogen gas,
produced during normal lead-acid battery operation, could ignite and cause the
lead-acid battery to explode. An exploding lead-acid battery can cause serious burns
and injuries. Keep all flames including cigarettes and sparks away from lead-acid
battery cells.
Keep all flames and sparks away from lead-acid battery cells
because hydrogen gas is produced from le ad-acid battery cells while charging the
lead-acid battery or adding lead-acid battery fluid.
Flames and sparks near lead-acid battery cells are dangerous. Hydrogen gas,
produced during normal lead-acid battery operation, could ignite and cause the
lead-acid battery to explode. An exploding lead-acid battery can cause serious burns
and injuries. Keep all flames including cigarettes and sparks away from lead-acid
battery cells.
Do not jump-start a frozen lead-acid battery or one with a low fluid level.
Jump-starting a frozen lead-acid battery or one with a low fluid level is dangerous. It
may rupture or explode, causing serious injury.
Connect the negative cable to a good ground point away from the lead-acid
battery.
Connecting the end of the second jumper cable to the negative (–) terminal of the
depleted lead-acid battery is dangerous.
A spark could cause the gas around the lead-acid battery to explode and injure
someone.
Route the jumper cables away from parts that will be moving.
Connecting a jumper cable near or to moving part (cooling fans) is dangerous. The
cable could get caught when the hybrid system starts and cause serious injury.
CAUTION
Use only a 12 V booster system. You can damage a 12 V starter, ignition system,
and other electrical parts beyond repair with a 24 V power supply (two 12 V
batteries in series).
 Do not use your vehicle as a booster vehicle to prevent damaging your vehicle.
1. Make sure that the vehicle power is switched OFF.
What to Do in Case of Emergency
Engine Does Not Start
8-12
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Inspecting Engine Oil
CAUTION
Do not overfill the engine oil. This may
cause engine damage.

Use center display screen indication to
inspect the engine oil level.
1. Make sure the hood is closed.
2. Start the hybrid system.
3. Select “Information” on the Home screen to display the vehicle status
monitor.
4. Select “Vehicle Status Monitor”.
5. Select “Engine Oil Level”.
6. Select “Start”. The engine starts and measurement
of the engine oil level begins. Do
not depress the accelerator pedal
during the measurement.
NOTE
If measurement conditions not
shown on the display are not met
such as when warm-up operation
has not been completed due to low
outdoor temperatures, the
measurement error screen may be
displayed. In this case, drive the
vehicle using the engine for a
certain period of time to complete
the warm-up operation and repeat
the procedure.

7. Switch the vehicle power OFF.
NOTE
After the measurement is
completed, the engine does not
stop automatically.

Recommended Oil
Use SAE 0W-20 engine oil.
Mazda Genuine Oil is used in your
Mazda vehicle. Mazda Genuine
0W-20 Oil is required to achieve
optimum fuel economy.
For maintenance service, Mazda
recommends Genuine Mazda Parts
and Genuine Mazda Premium Oil.

Only use SAE 0W-20 oil “Certified For
Gasoline Engines” by the American
Petroleum Institute (API).
Oil with this trademark symbol
conforms to the current engine and
emission system protection standards
and fuel economy requirements of the
International Lubricant Standardization
and Approval Committee (ILSAC),
Inspection and Servicing/Cleaning
Engine Compartment Inspection
9-13
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Replenish the washer fluid on a flat
surface. If the vehicle is tilted, washerfluid may not fill sufficiently.
Add washer fluid under any of the
following conditions.
The top of the fluid level is low.The Low Washer Fluid Level Warning
Indication/Warning Light (if
equipped) turns on.
The top of the fluid level is lower
than L (if equipped).

Use plain water if washer fluid is
unavailable.
But use only washer fluid in cold
weather to prevent it from freezing.
Inspecting Lead-acid
Battery
WARNING
Read the following
precautions carefully before using the
lead-acid battery or inspecting to
ensure safe and correct handling.
Always wear eye
protection when working near the
lead-acid battery.
Working without eye protection is
dangerous. Lead-acid battery fluid
contains SULFURIC ACID which could
cause blindness if splashed into your
eyes. Also, hydrogen gas produced
during normal lead-acid battery
operation, could ignite and cause the
lead-acid battery to explode.
Wear eye protection
and protective gloves to prevent
contact with lead-acid battery fluid.
Spilled lead-acid battery fluid is
dangerous.
Lead-acid battery fluid contains
SULFURIC ACID which could cause
serious injuries if it gets in eyes, or on
the skin or clothing. If this happens,
immediately flush your eyes with water
for 15 minutes or wash your skin
thoroughly and get medical attention.
Inspection and Servicing/Cleaning
Engine Compartment Inspection
9-18
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Always keep lead-acid
batteries out of the reach of children.
Allowing children to play near
lead-acid batteries is dangerous.
Lead-acid battery fluid could cause
serious injuries if it gets in the eyes or
on the skin.
Keep flames and sparks
away from lead-acid battery cells and
do not allow metal tools to contact
the positive (+) or negative (-)
terminal of the lead-acid battery
when working near a lead-acid
battery. Do not allow the positive (+)
terminal to contact the vehicle body.
Flames and sparks near lead-acid
battery cells are dangerous. Hydrogen
gas, produced during normal lead-acid
battery operation, could ignite and
cause the lead-acid battery to explode.
An exploding lead-acid battery can
cause serious burns and injuries. Keep
all flames including cigarettes and
sparks away from lead-acid battery
cells.
Keep all flames and
sparks away from lead-acid battery
cells because hydrogen gas is
produced from lead-acid battery cells
while charging the lead-acid battery
or adding lead-acid battery fluid.
Flames and sparks near lead-acid
battery cells are dangerous. Hydrogen
gas, produced during normal lead-acid
battery operation, could ignite and
cause the lead-acid battery to explode.
An exploding lead-acid battery can
cause serious burns and injuries. Keep
all flames including cigarettes and
sparks away from lead-acid battery
cells.

Before performing lead-acid battery
maintenance, remove the hole cover
and the lead-acid battery cover.
Removing the Hole Cover
1.
2.
Inspection and Servicing/Cleaning
Engine Compartment Inspection
9-19
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Checking the Inspection
Locations and Inspection Items
Front
Rear
1. Windshield wipers
2. Tires
3. Light bulbs
Replacing Windshield
Wiper Blade Rubbers
CAUTION
 Hot waxes applied by automatic car
washers have been known to
affect
the wiper's ability to clean windows.
 An operation malfunction may occur
or the wiper
effectiveness may be
reduced if a water-repellent coating
is used.
 To prevent damage to the wiper
blades, do not use gasoline,
kerosene, paint thinner, or other
solvents on or near them.
 When the wiper lever is in the AUTO
position and the vehicle power is
switched ON, the wipers may move
automatically in the following cases:
 If the windshield above the rain
sensor is touched.
 If the windshield above the rain
sensor is wiped with a cloth.
 If the windshield is struck with a
hand or other object.
 If the rain sensor is struck with a
hand or other object from inside
the vehicle.
Be careful not to pinch hands or fingers as it may cause injury, or
damage the wipers. When washing
or servicing the vehicle, make sure
the wiper lever is in the OFF
position.
 Before lifting the windshield wiper
blades
off the windshield, always
follow the procedure for moving the
windshield wiper blades. Otherwise,
a wiper blade, wiper arm, or the
hood could be damaged.
Inspection and Servicing/Cleaning
Vehicle Exterior Inspection
9-23
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Replace the tire when this happens.
1. New tread
2. Worn tread
3. Tread wear indicator

You should replace the tire before the
band crosses the entire tread.
NOTE
Tires degrade over time, even when
they are not being used on the road. It
is recommended that tires generally be
replaced when they are 6 years or
older. Heat caused by hot climates or
frequent high loading conditions can
accelerate the aging process. You
should replace the spare tire when you
replace the other road tires due to the
aging of the spare tire. The period in
which the tire was manufactured (both
week and year) is indicated by a 4-digit
number.
Refer to Tire Labeling on page 10-30.
Replacing Light Bulbs
All the light bulbs are the LED type.
The LED bulb cannot be replaced as a
single unit because it is an integrated
unit.
The LED bulb has to be replaced with
the unit. If a replacement is necessary,
consult an Authorized Mazda Dealer.
Adjusting the Headlight Aim
If the headlight cannot be adjusted
using procedure below, consult an
Authorized Mazda Dealer.
1. Make sure the vehicle has a fulltank of gasoline and the area
around the headlight is not
deformed.
2. Park the vehicle on level ground.
3. Sit in the driver's seat.
4. Bounce the vehicle several times.
5. Using a Phillips-head screw-driver, turn bolt A in either direction.
Remember the turning direction
and the number of turns.
6. Turn bolt B the same number of turns and in the same direction as
step 5.

1. Adjustment bolt A
2. Adjustment bolt B
Inspection and Servicing/Cleaning
Vehicle Exterior Inspection
9-30
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04