MISTOFF
AUTO
LO
HI
HIREARLO
OFF
MIST OFF
AUTO
LO
HI
HIREARLO
OFF
To operate:
•Move lever Up/Down A to change Wiper modes
•Push switch B to adjust Intermittent Wipe Speed
•Pull lever to spray and wipe C
Rain Sensing* (Auto Control Wipe):
The rain sensor located on the upper end of the windshield glass senses the amount of rainfall and controls the wiping cycle for the interval selected The more it rains, the faster the wiper operates When the rain stops, the wiper stops
To vary the speed setting, press the Wiper Switch B up/down
If the wiper lever is set in AUTO mode when the Power button is ON, the wiper will operate once to per form a self-check of the system
Windshield Wipers & Washers
MIST: Single wipeOFF: Wiper offINT/AUTO*:
Intermittent Wipe/ Rain Sensing*LO: Slow wipeHI: Fast wipe
MIST
OFF
AUTO
LO
HI
HIREARLO
OFF
MIST OFF
AUTO
LO
HI
HIREARLO
OFF
) * ' B T U X J Q F - 0 4 M P X X J Q F 0 ' ' 8 J Q F S P G G
To operate:
•Rotate Rear Wiper switch to change Wiper modes D
•Push to spray and wipe E
39 *IF EQUIPPEDALWAYS CHECK THE OWNER ’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS
A
B
C
DE
Refer to the inside front cover for more information on QR codes www youtube com/KiaFeatureVideos
Wipers and Wipers Stalk Video
Lifting Wipers (Wiper Service Mode) Video
QR CODE
•Moving switch B up increases intermit tent wipe frequency and wipe speed Moving switch down decreases frequency of wipes
•Set the wiper to the OFF position when the wiper is not in use
QUICK TIPS
On Rear Wipers, the intermit tent wipe function is not adjustable LO and HI sets wiper speed
QUICK TIP
Rear Wiper & Washer*Lifting Wipers (Wiper Service Mode)
To lift the windshield wipers to clean windshield, inspect or replace wiper blades or raise wipers in snow/ice conditions without damaging the hood, the blades need to be moved to the service position F to prevent damaging the hood
With the ignition ON, turn the ignition OFF, and within 20 seconds move the wiper switch B to the MIST position and hold the switch for more than two seconds until the wiper blade is in the fully up position
To return wipers to normal position, turn the ignition ON, then activate MIST
F
Refer to section 7 in the Owner ’s Manual for more information
STEERING WHEEL CONTROLS
STEERING
WHEEL CONTROLS