2023 HYUNDAI VENUE oil

Maintenance8-52
5. Install a new bulb by inserting it into the socket and rotating it until it locks
into place.
6. Install the socket in the assembly by aligning the tabs on the socket with
the slots in the assembly.
7. Push the socket into the assembly and turn the socket clockwise.
Type B, C
OQX089055N
(1) Cornering lamp
(2) Headlamp (Low/High)
(3) Daytime running lamp/parking lamp
(4) Turn signal lamp
(5) Side marker Headlamp (bulb type)
WARNING
OQX089043

[
Handle halogen bulbs with care.
Halogen bulbs contain pressurized
gas that will produce flying pieces
of glass that could cause injuries if
broken.

[ Wear eye protection when changing
a bulb. Allow the bulb to cool down
before handling it.

[ Always handle them carefully, and
avoid scratches and abrasions. If
the bulbs are lit, avoid contact with
liquids.

[ Never touch the glass with bare
hands. Residual oil may cause the
bulb to overheat and burst when lit.

[ A bulb should be operated only when
installed in a headlamp.

[ If a bulb becomes damaged or
cracked, replace it immediately and
carefully dispose of it.

Maintenance8-60
OQX089025N
NOTICE

[ Water washing in the engine
compartment including high
pressure water washing may cause
the failure of electrical circuits
located in the engine compartment.

[ Never allow water or other liquids
to come in contact with electrical/
electronic components inside the
vehicle as this may damage them.
NOTICE
Matte paint finish vehicle (if equipped)
Automatic car wash which uses rotating
brushes should not be used as this can
damage the surface of your vehicle. A
steam cleaner which washes the vehicle
surface at high temperature may result
the oil to adhere and leave stains that is
difficult to remove.
Use a soft cloth (e.g. microfiber towel
or sponge) when washing your vehicle
and dry with a microfiber towel. When
you hand wash your vehicle, you should
not use a cleaner that finishes with wax.
If the vehicle surface is too dirty (sand,
dirt, dust, contaminant, etc.), clean the
surface with water before washing the
car.
Waxing
A good coat of wax provides a barrier
be

tween your paint and environmental
contamination.
Keeping a good coat of wax on your
vehicle will help protect it.
Wax the vehicle when water will no
longer bead on the paint.
Always wash and dry the vehicle before
waxing. Use a good quality liquid or
paste wax, and follow the manufacturer’s
instructions. Wax all metal trim to protect
it and to maintain its luster.
Removing oil, tar, and similar materials
with a spot remover will usually strip the
wax from the finish. Be sure to re-wax
these areas even if the rest of the vehicle
does not yet need waxing.
NOTICE

[ Wiping dust or dirt off the body with
a dry cloth will scratch the finish.

[ Do not use steel wool, abrasive
cleaners, or strong detergents
containing highly alkaline or
caustic agents on chrome-plated or
anodized aluminum parts. This may
result in damage to the protective
coating and cause discoloration or
paint deterioration.
NOTICE
Matte paint finish vehicle (if equipped)
Do not use any polish protector such as
a detergent, an abrasive and a polish.
In case wax is applied, remove the wax
immediately using a silicon remover
and if any tar or tar contaminant is on
the surface use a tar remover to clean.
However, be careful not to apply too
much pressure on the painted area.

08
8-63

[When cleaning underneath the
vehicle, pay particular attention to the
components under the fenders and
other areas that are hidden from view.
Do a thorough job; just dampening
the accumulated mud rather than
washing it away will accelerate
corrosion rather than prevent it. Water
under high pressure and steam are
particularly effective in removing
accumulated mud and corrosive
materials.

[ When cleaning lower door panels,
rocker panels and frame members, be
sure that drain holes are kept open so
that moisture can escape and not be
trapped inside to accelerate corrosion.
Keep your garage dry
Don’t park your vehicle in a damp,
poorly ventilated garage. This creates
a favorable environment for corrosion.
This is particularly true if you wash your
vehicle in the garage or drive it into the
garage when it is still wet or covered with
snow, ice or mud. Even a heated garage
can contribute to corrosion unless it is
well ventilated so moisture is dispersed.
Keep paint and trim in good condition
Scratches or chips in the finish should
be covered with “touch-up” paint as
soon as possible to reduce the possibility
of corrosion. If bare metal is showing
through, the attention of a qualified body
and paint shop is recommended.
Bird droppings are highly corrosive and
may damage painted surfaces in just a
few hours. Always remove bird droppings
as soon as possible.Interior Care
Interior General Precautions
Prevent caustic solutions such as
perfume and cosmetic oil, from
contacting the interior parts because
they may cause damage or discoloration.
If they do contact the interior parts,
wipe them off immediately. See the
instructions for the proper way to clean
vinyl.
NOTICE

[ Never allow water or other liquids
to come in contact with electrical/
electronic components inside the
vehicle as this may damage them.

[ When cleaning leather products
(steering wheel, seats etc.), use
neutral detergents or low alcohol
content solutions. If you use high
alcohol content solutions or acid/
alkaline detergents, the color of the
leather may fade or the surface may
get stripped off.
Cleaning the Upholstery and Interior
Trim
Vinyl (if equipped)
Remove dust and loose dirt from vinyl
with a whisk br

oom or vacuum cleaner.
Clean vinyl surfaces with a vinyl cleaner.
Fabric (if equipped)
Remove dust and loose dirt from
f
abric with a whisk broom or vacuum
cleaner. Clean with a mild soap solution
recommended for upholstery or carpets.
Remove fresh spots immediately with
a fabric spot cleaner. If fresh spots do
not receive immediate attention, the
fabric can be stained and its color can be
affected. Also, its fire-resistant properties
can be reduced if the material is not
properly maintained.

Maintenance8-64
NOTICE
Using anything but recommended
cleaners and procedures may affect the
fabric’s appearance and fire-resistant
properties.
Leather (if equipped)

[ F
eatures of seat leather
- Leather is made from the outer skin of an animal, which goes through a
special process to be available for
use. Since it is a natural product,
each part differs in thickness or
density.
Wrinkles may appear as a natural
result of stretching and shrinking
depending on the temperature and
humidity.
- The seat is made of stretchable fabric to improve comfort.

- The parts contacting the body are
curved and the side supporting
area is high which provides driving
comfort and stability.
- Wrinkles may appear naturally from usage. It is not a fault of the
products.
CAUTION

[ Wrinkles or abrasions which appear
naturally from usage are not covered
by warranty.

[ Belts with metallic accessories,
zippers or keys inside the back
pocket may damage the seat fabric.

[ Make sure not to wet the seat. It may
change the nature of natural leather.

[ Jeans or clothes which could bleach
may contaminate the surface of the
seat covering fabric.
[
Caring for the leather seats
- Vacuum the seat periodically to remove dust and sand on the seat. It
will prevent abrasion or damage of
the leather and maintain its quality.
- Wipe the natural leather seat cover often with dry or soft cloth.
- Use of proper leather protector may prevent abrasion of the cover and
helps maintain the color. Be sure to
read the instructions and consult
a specialist when using leather
coating or protective agent.

- Light colored (beige, cream beige)
leather is easily contaminated and
the stain is noticeable. Clean the
seats frequently.
- Avoid wiping with wet cloth. It may cause the surface to crack.

[ Cleaning the leather seats

- Remove all contaminations
instantly. Refer to instructions below
for removal of each contaminant.
- Cosmetic products (sunscreen, foundation, etc.)
Apply cleansing cream on a cloth
and wipe the contaminated spot.
Wipe off the cream with a wet cloth
and remove water with a dry cloth.
- Beverages (coffee, soft drink, etc.) Apply a small amount of neutral
detergent and wipe until
contaminations do not smear.
- Oil
Remove oil instantly with
absorbable cloth and wipe with
stain remover used only for natural
leather.
- Chewing gum Harden the gum with ice and
remove gradually.

08
8-65
Cleaning the Seat Belt Webbing
Clean the belt webbing with any
mild soap solution recommended for
cleaning upholstery or carpet. Follow
the instructions provided with the soap.
Do not bleach or re-dye the webbing
because this may weaken the seat belt.
Cleaning the Interior Window Glass
If the interior glass surfaces of the
vehicle become hazy (that is, covered
with an oily, greasy or waxy film), they
should be cleaned with glass cleaner.
Follow the directions on the glass cleaner
container.
NOTICE
Do not scrape or scratch the inside of
the rear window. This may result in
damage to the rear window defroster
grid.
The emission control system of your
vehicle is covered by a written limited
warranty. Please see the warranty
information contained in the Owner’s
Handbook & Warranty Information
booklet in your vehicle.
Your vehicle is equipped with an
emission control system to meet all
applicable emission regulations. There
are three emission control systems, as
follows.
(1) Crankcase emission control system
(2) Evaporative emission control system
(3) Exhaust emission control system
In order to ensure the proper function
of the emission control systems, it
is recommended that you have your
vehicle inspected and maintained
by an authorized HYUNDAI dealer in
accordance with the maintenance
schedule in this manual.
NOTICE
For the Inspection and Maintenance
Test (with Electronic Stability Control
(ESC) system)

[To prevent the vehicle from misfiring
during dynamometer testing, turn
the Electronic Stability Control
(ESC) system off by pressing the ESC
switch (ESC OFF light illuminated).

[ After dynamometer testing is
completed, turn the ESC system back
on by pressing the ESC switch again.
EMISSION CONTROL
SYSTEM

IndexI-4
Door Locks ........................................................................\
.................................. 5-12 Automatic Door Lock and Unlock Features ................................................... 5-15
Child-Protector Rear Door Locks ................................................................... 5-15
Operating Door Locks from Inside the Vehicle .............................................. 5-13
Operating Door Locks from Outside the Vehicle ............................................ 5-12
Drive Mode Integrated Control System ............................................................... 6-28
LCD Display Message ........................................................................\
............ 6-30
Driver Attention Warning (DAW) ....................................................................... 6-78
Leading Vehicle Departure Alert ..................................................................... 6-81
Resetting the System ........................................................................\
............... 6-79
System Malfunction ........................................................................\
................ 6-79
System Setting and Activation ........................................................................\
6-78
System Standby ........................................................................\
....................... 6-79
E
Emission Control System ........................................................................\
............ 8-65 Crankcase Emission Control System .............................................................. 8-66
Evaporative Emission Control System Including Onboard Refueling Vapor
Recovery (ORVR) ........................................................................\
................... 8-66
Exhaust Emission Control System .................................................................. 8-66
Engine .................................................................\
................................................... 2-7
Engine Compartment ........................................................................\
..................... 8-3
Engine Compartment ........................................................................\
..................... 2-6
Engine Coolant ........................................................................\
............................ 8-16 Changing Engine Coolant ........................................................................\
....... 8-18
Checking the Engine Coolant Level ............................................................... 8-16
Engine Number ........................................................................\
............................ 2-14
Engine Oil ........................................................................\
.................................... 8-15 Checking the Engine Oil and Filter ................................................................. 8-15
Checking the Engine Oil Level ....................................................................... 8-15
Explanation of Scheduled Maintenance Items .................................................... 8-12 Air Cleaner Filter ........................................................................\
.................... 8-13
Air Conditioning Refrigerant ........................................................................\
.. 8-14
Brake/Clutch Fluid ........................................................................\
.................. 8-14
Brake Discs, Pads, Calipers and Rotors .......................................................... 8-14
Brake Hoses and Lines ........................................................................\
............ 8-13
Cooling System ........................................................................\
....................... 8-13
Drive Belts ........................................................................\
.............................. 8-12

I
I-5
Drive Shafts and Boots........................................................................\
............ 8-14
Engine Coolant ........................................................................\
........................ 8-13
Engine Oil and Filter ........................................................................\
............... 8-12
Exhaust Pipe and Muffler ........................................................................\
........ 8-14
Fuel Filter ........................................................................\
................................ 8-12
Fuel Lines, Fuel Hoses and Connections ........................................................ 8-12
Intelligent Variable Transmission (IVT) Fluid ................................................ 8-13
Manual Transmission Fluid ........................................................................\
..... 8-13
Parking Brake ........................................................................\
.......................... 8-14
Spark Plugs........................................................................\
.............................. 8-13
Steering Gear Box, Linkage & Boots/Lower Arm Ball Joint ......................... 8-14
Suspension Mounting Bolts ........................................................................\
.... 8-14
Vacuum Crankcase Ventilation Hoses ............................................................. 8-12
Vapor Hose and Fuel Filler Cap ...................................................................... 8-12
Exterior Features ........................................................................\
.......................... 5-75 Roof Side Rails ........................................................................\
....................... 5-75
Exterior Features ........................................................................\
.......................... 5-31
Fuel Filler Door ........................................................................\
....................... 5-34
Hood ...................................................................\
............................................. 5-31
Liftgate ...............................................................\
............................................. 5-32
Exterior Overview ........................................................................\
......................... 2-2
F
Forward Collision-Avoidance Assist (FCA) System ........................................... 6-48 FCA Sensor ........................................................................\
............................. 6-52
FCA Warning Message and System Control ................................................... 6-50
Limitations of the System ........................................................................\
....... 6-54
System Malfunction ........................................................................\
................ 6-53
System Setting and Activation ........................................................................\
6-48
Forward Collision-Avoidance Assist (FCA) System-Sensor Fusion ................... 6-59 FCA Sensor ........................................................................\
............................. 6-63
FCA Warning Message and System Control ................................................... 6-61
Limitations of the System ........................................................................\
....... 6-66
System Malfunction ........................................................................\
................ 6-65
System Setting and Activation ........................................................................\
6-59
Fuel Requirements ........................................................................\
......................... 1-5