Page 22 of 308
On the roadDriving
Starting and stopping the engineIgnition on/off
Page 88 of 308
Overview
Storing
1.Turn on the ignition.2.Set the desired position.3. Press the button. The LED in the
button lights up.4.Press the desired button 1 or 2 while the
LED is lit. The LED goes out.
Button was pressed inadvertently:
Press the button again.
The LED goes out.
Calling up settings
The stored position is called up automatically.
Press the desired button 1 or 2.
The procedure stops when a seat setting switch or one of the memory buttons ispressed.
Once underway, adjustment of the seat posi
Page 98 of 308
If the engine is not running and the ignition is
switched on: the system automatically acti
Page 99 of 308
The ignition is activated automatically for a
brief time and is stopped as soon as the en
Page 115 of 308
selector lever automatically returns to the
center position when released.
Engaging selector lever position P
Press button P.
Rolling or pushing the vehicle General informationIn some situations, the vehicle is to roll without
its own power for a short distance, for instance in a car wash, or be pushed.
Engaging selector lever position N:
with a latching selector lever
1.Turn on the ignition.2.If necessary, release the parking brake.3.Depress the brake pedal.4.Touch the selector lever lock and engage selector lever position N.5.Release brake.
The vehicle can roll.
If there is a malfunction, you may not be able
to change the selector lever position.
Manually unlock the transmission lock, if
needed, refer to page 117.
Engaging selector lever position N:
with a tap
Page 202 of 308
Sockets
General information
The socket can be used for electronic devices
while the engine is running or when the ignition is switched on.
The total load of all sockets must not exceed
140 watts at 12 volts.
Do not damage the socket by using unsuitable
connectors.
Safety information
Warning
Devices and cables in the unfolding area of
the airbags, such as portable navigation devi
