2022 TOYOTA GR86 check engine

319
6
6-3. Do-it-yourself maintenance
Maintenance and care
1 Turn the engine switch off.
2 Open the fuse box cover.
Engine compartment
Push the tab in and lift the lid off.
Instrument panel
Remove the lid.
3Remove the fuse with the pull-
out tool.
Only type A fuses can be removed
using the pullout tool.
4 Check if the fuse is blown.
Type A and B:
Replace the blown fuse with a new fuse of an appropriate amperage rating. The
amperage rating can be found on the
fuse box lid.
Ty p e C :
Contact any authorized Toyota retailer
or Toyota authorized repairer, or any reliable repairer.
Ty p e A
Normal fuse
Blown fuse
Checking and replacing
fuses
If any of the electrical compo-
nents do not operate, a fuse
may have blown. If this hap-
pens, check and replace the
fuses as necessary.
Checking and replacing
fuses
A

3246-3. Do-it-yourself maintenance
and install it.
7 Install the clips.
WA R N I N G
■Replacing light bulbs
●Turn off the lights. Do not attempt to
replace the bulb immediately after
turning off the lights. The bulbs become very hot and may cause
burns.
●Do not touch the glass portion of
the light bulb with bare hands.
When it is unavoidable to hold the glass portion, use and hold with a
clean dry cloth to avoid getting
moisture and oils on the bulb. Also, if the bulb is scratched or dropped,
it may blow out or crack.
●Fully install light bulbs and any
parts used to secure them. Failure
to do so may result in heat damage, fire, or water entering the light unit.
This may damage the lights or
cause condensation to build up on the lens.
■When changing the rear fog light or back-up lights
●Stop the engine and wait until the
exhaust pipes and surrounding parts have cooled down suffi-
ciently. The lights are located near
the exhaust pipe and touching a hot exhaust pipe and surrounding parts
can cause burns.
■To prevent damage or fire
●Make sure bulbs are fully seated
and locked.
●Check the wattage of the bulb
before installing to prevent heat damage.

3427-2. Steps to take in an emergency
■Tire pressure warning light (warning buzzer)
■GPF system warning light (warning buzzer)
■Front passenger detection sensor,
seat belt reminder and warning buzzer
●If luggage is placed on the front pas-
senger seat, the front passenger
detection sensor may cause the warn- ing light to flash and the warning
Warning lightDetails/Actions
When the light comes on:
Low tire inflation pressure such as
 Natural causes (P.343)
 Flat tire (P.345)
 Adjust the tire inflation pressure to the specified level. The
light will turn off after a few minutes. In case the light does
not turn off even if the tire inflation pressure is adjusted,
have the system checked by any authorized Toyota retailer
or Toyota authorized repairer, or any reliable repairer.
When the light comes on after blinking for 1 minute:
Malfunction in the tire pressure warning system
 Have the system checked by any authorized Toyota retailer
or Toyota authorized repairer, or any reliable repairer.
Warning lightDetails/Actions
When the light comes on:
The accumulated particulate matter exceeds the specified limit.
Have the vehicle inspected by any authorized Toyota retailer or
Toyota authorized repairer, or any reliable repairer or drive the
vehicle under the following conditions after the engine has been
warmed up completely.
 Drive at a speed of 60 km/h (37 mph) or higher.
 Periodically release the accelerator pedal.
 The light will turn off after approximately 30 minutes. If the
light does not turn off, inspected by any authorized Toyota
retailer or Toyota authorized repairer, or any reliable
repairer immediately.
When the light blinks:
Indicates a malfunction in the GPF system
 Have the vehicle inspected by any authorized Toyota
retailer or Toyota authorized repairer, or any reliable
repairer immediately.

343
7
7-2. Steps to take in an emergency
When trouble arises
buzzer to sound even if a passenger
is not sitting in the seat.
●If a cushion is placed on the seat, the
sensor may not detect a passenger, and the warning light may not operate
properly.
■If the malfunction indicator lamp
comes on while driving
The malfunction indicator lamp will
come on if the fuel tank becomes com-
pletely empty. If the fuel tank is empty, refuel the vehicle immediately. The mal-
function indicator lamp will go off after
several trips.
If the malfunction indicator lamp does
not go off, contact any authorized Toyota
retailer or Toyota authorized repairer, or any reliable repairer as soon as possi-
ble.
■Electric power steering system
warning light (warning buzzer)
When the battery charge becomes
insufficient or the voltage temporarily
drops, the electric power steering sys- tem warning light may come on and the
warning buzzer may sound.
■When the tire pressure warning
light comes on
Check the tire inflation pressure and
adjust to the appropriate level. Pushing
the tire pressure wa rning reset switch will not turn off the tire pressure warning
light.
■The tire pressure warning light may
come on due to natural causes
The tire pressure warning light may
come on due to natural causes such as
natural air leaks and tire inflation pres- sure changes caused by temperature. In
this case, adjusting the tire inflation
pressure will turn off the warning light
(after a few minutes).
■Conditions that the tire pressure warning system may not function
properly
 P.304
■If the tire pressure warning light
frequently comes on after blinking for 1 minute
If the tire pressure warning light fre-
quently comes on after blinking for 1 minute when the engine switch is turned
to ON, have it checked by any author-
ized Toyota retailer or Toyota authorized repairer, or any reliable repairer.
■Warning buzzer
In some cases, the buzzer may not be
heard due to being in a noisy location or audio sound.
WA R N I N G
■If both the ABS and the brake
system warning lights remain on
Stop your vehicle in a safe place immediately and contact any author-
ized Toyota retailer or Toyota author-
ized repairer, or any reliable repairer. The vehicle will become extremely
unstable during br aking, and the ABS
system may fail, which could cause an accident resulting in death or seri-
ous injury.
■When the electric power steer-
ing system warning light comes
on
The steering wheel may become
extremely heavy.
When steering wheel operations are heavier than usual, grip the steering
wheel firmly and operate it using more
force than usual.
■If the tire pressure warning light
comes on
Be sure to observe the following pre-
cautions. Failure to do so could cause
a loss of vehicle control and result in death or serious injury.
●Stop your vehicle in a safe place as soon as possible. Adjust the tire
inflation pressure immediately.

345
7
7-2. Steps to take in an emergency
When trouble arises
■If “Check Owner’s Manual” is dis-
played
●If the following messages are shown,
following the instructions, accordingly. • “High Coolant Temperature” ( P.362)
• “Transmission Oil Temperature”
( P.143)
●If any of the following messages are
shown on the multi-information dis- play, it may indicate a malfunction.
Have the vehicle inspected by any
authorized Toyota retailer or Toyota authorized repairer, or any reliable
repairer immediately.
• “EyeSight OFF” • “Headlights Disabled”
• “ABS”
• “Steering System” • “Vehicle Stability Control”
• “Transmission”
• “Low Tire Pressure” • “RAB Disabled”
• “BSD/RCTA Disabled”
• “Keyless Access System Disabled” • “Auto Headlight Leveler Disabled”
• “SRH Disabled”
• “Gasoline Particulate Filter”
●If any of the following messages are
shown on the multi-information dis- play, it may indicate a malfunction.
Immediately stop the vehicle and con-
tact any authorized Toyota retailer or Toyota authorized repairer, or any reli-
able repairer.
• “Brake System” • “Check Engine”
• “SRS Airbag System”
 Stop the vehicle in a safe place
on a hard, flat surface.
 Set the parking brake.
 Shift the shift lever to P (auto-
matic transmission) or R (manual
transmission).
 Stop the engine.
 Turn on the emergency flashers.
( P.326)
 Check the degree of the tire
damage.
A tire should only be repaired with
the emergency tire puncture repair
If you have a flat tire
Your vehicle is not equipped
with a spare tire, but instead is
equipped with an emergency
tire puncture repair kit.
A puncture caused by a nail or
screw passing through the tire
tread can be repaired tempo-
rarily with the emergency tire
puncture repair kit.
WA R N I N G
■If you have a flat tire
Do not continue driving with a flat tire.
Driving even a short distance with a flat tire can damage the tire and the
wheel beyond repair. Driving with a
flat tire may cause a circumferential groove on the side wall. In such a
case, the tire may explode when
using the emergency tire puncture repair kit, resulting in death or serious
injury.
Before repairing the vehicle

357
7
7-2. Steps to take in an emergency
When trouble arises
Remove the access cover at the
rightside of the trunk trim.
Push the yellow le ver to unlock the
fuel filler lid.
■When the electronic key does not work properly
●Make sure that the smart entry & start system has not been deactivated in
the customization setting. If it is off,
turn the function on.
●Check if battery-saving mode is set. If
it is set, cancel the function. ( P. 111 )
■Unlocking the door
Use the mechanical key ( P.100)
If the fuel filler door can-
not be opened
If the fuel filler door cannot be
opened by pressing the center
of the rear edge of the fuel filler
door with the doors unlocked,
the following procedure can be
used to open the fuel filler
door.
Opening the fuel filler door
If the electronic key
does not operate prop-
erly
If communication between the
electronic key and vehicle is
interrupted ( P. 1 1 1 ) o r t h e
electronic key cannot be used
because the battery is
depleted, the smart entry &
start system and wireless
remote control cannot be used.
In such cases, the doors can
be opened and the engine can
be started by following the pro-
cedure below.
NOTICE
■In case of a smart entry & start system malfunction or other
key-related problems
Take your vehicle with all the elec- tronic keys provided with your vehicle
to any authorized Toyota retailer or
Toyota authorized repairer, or any reli- able repairer.
Locking and unlocking the
doors

3587-2. Steps to take in an emergency
in order to perform the following
operations:
1 Unlocks all the doors
2 Locks all the doors
1 Vehicles with an automatic
transmission: Ensure that the
shift lever is in P and depress
the brake pedal.
Vehicles with a manual trans-
mission: Shift the shift lever to N
and depress the clutch pedal.
2 Touch the area behind the lock
button and unlock button on the
electronic key to the engine
switch.
When the electronic key is detected, a
buzzer sounds and the engine switch
will turn to ON.
When the smart entry & start system is
deactivated in customization setting,
the engine switch will turn to ACC.
3 Firmly depress the brake pedal
(automatic transmission) or
clutch pedal (manual transmis-
sion) and check that is
shown on the multi-information
display.
4 Press the engine switch.
In the event that the engine still
cannot be started, contact any
authorized Toyota retailer or Toyota
authorized repairer, or any reliable
repairer.
■Stopping the engine
Vehicles with an automatic transmis- sion: Shift the shift lever to P and press
the engine switch as you normally do
when stopping the engine. Vehicles with a manual transmission:
Shift the shift lever to N and press the
engine switch as you normally do when stopping the engine.
■Electronic key battery
As the above procedure is a temporary
measure, it is recommended that the
electronic key battery be replaced immediately when the battery is
depleted. ( P.316)
■Alarm (if equipped)
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechani-
Starting the engine

3627-2. Steps to take in an emergency
1Stop the vehicle in a safe place
and turn off the air conditioning
system, and then stop the
engine.
2 If you see steam: Carefully lift
the hood after the steam sub-
sides.
If you do not see steam: Care-
fully lift the hood.
3 After the engine has cooled
down sufficiently, inspect the
WA R N I N G
●In the event that battery fluid comes
into contact with the skin or eyes,
immediately wash the affected area with water and seek medical atten-
tion. Place a wet sponge or cloth
over the affected area until medical attention can be received.
●Always wash your hands after han-
dling the battery support, terminals, and other battery-related parts.
●Do not allow children near the bat-tery.
■To prevent damage to the vehicle
Do not pull- or push-start the vehicle
as the three-way catalytic converter
may overheat and become a fire haz- ard.
NOTICE
■When handling jumper cables
Be careful that the jumper cables do
not become tangled in the cooling fans or any of the belts when connect-
ing or disconnecting them.
■When closing the doors
While pushing the door glass towards
the inside of the vehicle, slowly close the door.
Because the side window open/close
function linked to door operation will not operate, the window may interfere
with the vehicle body, possibly
scratching both the vehicle body and window, or even shattering the win-
dow.
If your vehicle overheats
The following may indicate that
your vehicle is overheating.
 The engine coolant tempera-
ture gauge ( P.88) is in the
red zone or a loss of engine
power is experienced. (For
example, the vehicle speed
does not increase.)
 “High Coolant Temperature
Check Owner's Manual” is
shown on the multi-information
display.
 Steam comes out from under
the hood.
Correction procedures