2022 TOYOTA BZ4X air conditioning

394
Owners Manual_Europe_M42D76_en
5-4. Using the driving support systems
the vehicle will move and park-
ing assistance will be per-
formed.
If operation of the screen of the smart- phone is stopped, assistance can be suspended and the vehicle can be
stopped. After assistance has been started, it can be stopped part way or the direction of travel of the vehicle can
be changed.
5 Move the vehicle to the position
where assistance ends and
enter the vehicle while carrying
the electronic key.
To stop assistance part way, stop oper-
ating the smartphone or enter the vehi- cle.
■Exit while using the remote air con-ditioner
●Exit assist can be done even when using remote air conditioning.
●When Remote control function is started while the remote air condition-
ing is operating, if tracing operations are not performed on a smartphone, assistance can be canceled by enter-
ing the vehicle and depressing the brake pedal.
A smartphone can be used to
remotely operate the memory func-
tion if the target parking space can
be detected when the vehicle is
stopped close to a parking space
which was previously registered to
the memory function. Also, depend-
ing on the condition of the parking
space, etc., if it is necessary to
change the direction of travel of the
vehicle, the shift position can be
changed by assistance control.
1 Stop the vehicle with it aligned
near the center of the target
parking space. ( P.386)
2 Press the Advanced Park main
switch, check that a possible
parking space is displayed on
the multimedia display.
( P.386)
3 Select the button and then
select [Perpendicular/parallel].
4 [OK].
If the [MODE] button is displayed, the
button can be selected to change between the memory function, perpen-dicular parking (forward/reverse) func-
tion and parallel parking function.
5 Exit the vehicle while carrying
the electronic key and smart-
phone, and then start the
Remote Park app on the smart-
phone.
The detection area of the electronic key is within approximately 3 m (9.8 ft.)
around the vehicle.If there is a cone or other obstruction in the path of the vehi-cle, move it after exiting the vehicle.
6 From outside of the vehicle,
confirm the parking space on
the screen of the smartphone
and then select the start button.
Start operation of Remote control func- tion while standing approximately 50
cm (1.6 ft.) or more from the vehicle and out of the path of the vehicle.
7 Checking the safety of the area
around the vehicle, trace the
Parking using the Remote
control function and mem-
ory function

397
5
Owners Manual_Europe_M42D76_en
5-4. Using the driving support systems
Driving
steering wheel.
The Advanced Park main switch
is pushed
 The shift position has been
changed to P
 The parking brake is engaged
 A door or back door is opened
 The driver’s seat belt is unfas-
tened
 The outside rear view mirrors are
folded
 The TRAC or VSC is turned off
 The TRAC, VSC or ABS oper-
ates
 The power switch is pushed
 The system determines assis-
tance cannot be continued in the
current parking environment
 The system malfunctions
 While the vehicle was stopped,
“Cancel” was selected on the
multimedia display
■Assistance will be suspended
when
In situations such as the following,
Advanced Park operation will be
suspended.
Assistance can be started again by fol-
lowing the directions displayed on the
multimedia display.
Also, when assistance is suspended, if
the shift position is changed twice with
the brake pedal depressed, assistance
will be canceled in that shift position.
However, if assistance is suspended by
changing the shift position, assistance
will be canceled if the shift position is
changed once.
 The steering wheel is operated
 The accelerator pedal is
depressed
 The shift position has been
changed
 Brake control operates
 Camera switch is pressed
 The PKSB (Parking Support
Brake) PCS (Pre-Collision Sys-
tem) has operates
■Remote control function assis-
tance will be canceled when
In situations such as the following,
Remote control function operation
will be canceled.
As system operation has been can-
celed, while carrying an electronic
key, enter the vehicle and park the
vehicle manually, using the steering
wheel.
 When a condition for stopping
Advanced Park assistance is
met, with the exception suspen-
sion due to a door being opened
or the driver’s seat seat belt
being released
 When Remote control function is
operated while the remote air
conditioning is operating and the
power switch is changed to ON
before remote air conditioning
has ended
 When 5 minutes have elapsed
since Remote control function
operation was started

6
417
Owners Manual_Europe_M42D76_en
6
Interior features
Interior features
6-1. Using the air conditioning
system and defogger
ALL AUTO (“ECO”) control 418
Automatic air conditioning sys-
tem ................................. 420
Remote Air Conditioning Sys-
tem ................................. 427
Heated steering wheel/seat
heaters/seat ventilators .. 429
6-2. Using the interior lights
Interior lights list................ 431
6-3. Using the storage features
List of storage features ..... 434
Luggage compartment features
....................................... 437
6-4. Using the other interior fea-
tures
Electronic sunshade ......... 442
Other interior features....... 444

418
Owners Manual_Europe_M42D76_en
6-1. Using the air conditioning system and defogger
6-1.Using the a ir c onditioning sys te m and de fog ger
*: If equipped
Press the ALL AUTO (“ECO”)
switch
The indicator on the ALL AUTO
(“ECO”) switch illuminates, and the
automatic air conditioning system, seat
heaters* and ventilators*, and heated
steering wheel* operate in automatic
mode.
If any of the system is operated manu-
ally, the indicator turns off. However, all
other functions continue to operate in
automatic mode.
Even if ALL AUTO (“ECO”) control is
turned off, the air conditioner, seat
heater/ventilator, and steering heater
will not be turned off.
If the front window glass becomes
cloudy due to a drop in the outside air
temperature while the ALL AUTO
(“ECO”) control is operating, you can
remove the cloudiness by pressing the
AUTO switch on the air conditioner con-
trol panel.
*: If equipped
■Automatic air conditioning
system ( P.420)
The temperature can be adjusted
independently for each seat.
■Seat heaters (if equipped) and
ventilators (if equipped)
( P.429)
Heating or ventilation is automati-
cally selected according to the set
temperature of the air conditioning
system, the outside temperature,
etc.
■Heated steering wheel (if
equipped) ( P.429)
Heated steering wheel operates
automatically according to the set
temperature of the air conditioning
system, the outside temperature,
etc.
■Passenger detection functions
When a passenger is detected in the front passenger seat, the seat heater
and ventilator will operate automatically.
■Seat heater (if equipped)/ventilator (if equipped) operation
If the seat heater/ventilator switch is set
to auto, it will operate without performing the passenger detection. When the ALL AUTO (“ECO”) switch is pressed in that
state, the passenger seat heater and ventilator will operate according to that
ALL AUTO (“ECO”) con-
trol
The seat heaters*, seat ventila-
tors* and heated steering
wheel* are each automatically
controlled according to the set
temperature of the air condi-
tioning system, the outside
and cabin temperature, etc.
ALL AUTO (“ECO”) controls
the power consumption in
order to both extend the cruis-
ing range and maintain com-
fortable conditions.
Turning on ALL AUTO
(“ECO”) control
Operation of each system

419
6
Owners Manual_Europe_M42D76_en
6-1. Using the air conditioning system and defogger
Interior features
passenger detected state.
■Rear seat heater (if equipped) oper-
ation
The rear seat heaters are not controlled by the ALL AUTO (“ECO”) control.

420
Owners Manual_Europe_M42D76_en
6-1. Using the air conditioning system and defogger
ALL AUTO (“ECO”) switch (→P.418)
Automatic mode switch
“OFF” switch
Outside/recirculated air mode switch
“A/C” switch
Front seat concentrated airflow mode (S-FLOW) switch
Windshield wiper de-icer switch (if equipped) or heated windshi eld
defroster switch (if equipped)
“SYNC” switch
Right-hand side temperature control switch
Airflow mode control switch
Automatic air conditioning system
Air outlets and fan speed are au tomatically adjusted according to
the temperature setting.
The illustrations below are for left-hand drive vehicles.
The button positions will differ for right-hand drive vehicles.
Air conditioning controls

421
6
Owners Manual_Europe_M42D76_en
6-1. Using the air conditioning system and defogger
Interior features
Fan speed control switch
Left-hand side temperature control switch
Rear window and outside rear view mirror defogger switch
Windshield defogger switch
■Adjusting the temperature set-
ting
Operate the temperature control
switch upwards to increase the
temperature and downwards to
decrease the temperature.
If “A/C” is not pressed, the system
will blow ambient temperature air or
heated air.
■Adjusting the fan speed set-
ting
Operate the fan speed control
switch upwards to increase the fan
speed and downwards to decrease
the fan speed.
Press the “OFF” switch to turn off the
fan.
■Change the airflow mode
Operate the airflow mode control
switch upwards or downwards.
The mode changes as follows each
time the switch is operated.
1 Air flows to the upper body.
2 Air flows to the upper body and
feet.
3 Air flows to the feet.
4 Air flows to the feet and the
windshield defogger operates.
■Switching between outside air
and recirculated air modes
Press the outside/recirculated air
mode switch.
The mode switches between outside air
mode (the indicator is off) and recircu-
lated air mode (the indicator is on) each
time the switch is pressed.
■Set cooling and dehumidifica-
tion function
Press the “A/C” switch.
When the function is on, the indica-
tor illuminates on the “A/C” switch.

422
Owners Manual_Europe_M42D76_en
6-1. Using the air conditioning system and defogger
■Defogging the windshield
Defoggers are used to defog the
windshield and front side windows.
Press the windshield defogger
switch.
Set the outside/recirculated air mode
switch to outside air mode if the recircu-
lated air mode is used. (It may switch
automatically.)
To defog the windshield and the side
windows early, turn the air flow and
temperature up.
To return to the previous mode, press
the windshield defogger switch again
when the windshield is defogged.
When the windshield defogger switch is
on, the indicator illuminates on the
windshield defogger switch.
■Defogging the rear window
and outside rear view mirrors
Defoggers are used to defog the
rear window and to remove rain-
drops, dew and frost from the out-
side rear view mirrors.
Press the rear window and outside
rear view mirror defogger switch.
The defoggers will automatically turn off
after a period of time.
■Windshield wiper de-icer (if
equipped)
This feature is used to prevent ice
from building up on the windshield
and wiper blades.
Press the windshield wiper de-icer
switch.
The indicator comes on when the
windshield wiper de-icer is on.
The windshield wiper de-icer will auto-
matically turn off after a period of time.
■Fogging up of the windows
●The windows will easily fog up when the humidity in the vehicle is high.
Selecting “A/C” will dehumidify the air from the outlets and defog the wind-shield effectively.
●If you turn “A/C” off, the windows may fog up more easily.
●The windows may fog up if the recir-culated air mode is used.
■When driving on dusty roads
Close all windows. If dust thrown up by the vehicle is still drawn into the vehicle after closing the windows, it is recom-
mended that the air intake mode be set to outside air mode and the fan speed to any setting except off.
■Outside/recirculated air mode
●Setting to the recirculated air mode temporarily is recommended in pre-
venting dirty air from entering the vehicle interior and helping to cool the vehicle when the outside air tempera-
ture is high.
●Outside/recirculated air mode may automatically switch depending on the temperature setting or the inside tem-
perature.
■When the outside temperature is low
The dehumidification function may not
operate even when “A/C” is selected.