2022 HYUNDAI I10 Owners Manual

7-25
07
OAC3079010TU
For safe operation, carefully read and
follow the instructions in this manual
before use.
(1) Compressor
(2) Sealant bottle
The Tyre Mobility Kit is a temporary
fix to the tyre and we recommend that
the system be inspected by a
HYUNDAI authorised repairer.
CAUTION
:KHQWZRRUPRUHW\UHVDUHIODWGR
QRW XVH WKH W\UH PRELOLW\ NLW
EHFDXVH WKH VXSSRUWHG RQH VHDO-
DQWRI7\UH0RELOLW\.LWLVRQO\XVHG
IRURQHIODWW\UH
WARNING
'RQRWXVHWKH7\UH0RELOLW\.LWWR
UHSDLU SXQFWXUHV LQ WKH W\UH ZDOOV
7KLV FDQ UHVXOW LQ DQ DFFLGHQW GXH
WRW\UHIDLOXUH
WARNING
+DYH\RXUW\UHUHSDLUHGDVVRRQDV
SRVVLEOH 7KH W\UH PD\ ORVH DLU
SUHVVXUHDWDQ\WLPHDIWHULQIODWLQJ
ZLWKWKH7\UH0RELOLW\.LW
,QWURGXFWLRQ
With the Tyre Mobility Kit you stay
mobile even after experiencing a tyre
puncture.
The system of compressor and seal-
ing compound effectively and com-
fortably seals most punctures in a
passenger car tyre caused by nails or
similar objects and reinflates the tyre.
After you ensured that the tyre is
properly sealed you can drive cau-
tiously on the tyre (distance up to 120
miles (200 km)) at a max. speed 50
mph (80 km/h) in order to reach a ser-
vice station or tyre dealer to have the
tyre replaced.
It is possible that some tyres, espe-
cially with larger punctures or dam-
age to the sidewall, cannot be sealed
completely.
Air pressure loss in the tyre may
adversely affect tyre performance.
For this reason, you should avoid
abrupt steering or other driving
manoeuvres, especially if the vehicle
is heavily loaded or if a trailer is in
use.
The Tyre Mobility Kit is not designed
or intended as a permanent tyre
repair method and is to be used for
one tyre only. This instruction shows
you step by step how to temporarily
seal the puncture simply and reliably.
Read the section “Notes on the safe
use of the Tyre Mobility Kit”.
IF YOU HAVE A FLAT TYRE
ãWITH TYRE MOBILITY KIT
IF EQUIPPED
ä

7-26
Emergency situations
WARNING
'R QRW XVH WKH 70. LI D W\UH LV
VHYHUHO\ GDPDJHG E\ GULYLQJ UXQ
IODW RU ZLWK LQVXIILFLHQW DLU SUHV-
VXUH
2QO\SXQFWXUHGDUHDVORFDWHGZLWK-
LQ WKH WUHDG UHJLRQ RI WKH W\UH FDQ
EHVHDOHGXVLQJWKH70.
1RWHVRQWKHVDIHXVHRIWKH
W\UH0RELOLW\.LW

7-27
07
&RPSRQHQWVRIWKH7\UH0RELOLW\.LW
1. Speed-restriction label
2. Sealant bottle and label with speed
restriction
3. Filling hose from sealant bottle to
wheel
4. Connectors and cable for the
power outlet direct connection
5. Holder for the sealant bottle
6. Compressor
7. ON/OFF switch8. Pressure gauge for displaying the
tyre inflation pressure
9. Button for reducing the tyre infla-
tion pressure
Connectors, cable and connection
hose are stored in the compressor
housing.
Strictly follow the specified sequence,
otherwise the sealant may escape
under high pressure.
ODE067044

7-28
Emergency situations
WARNING
([SLUHGVHDODQW
'R QRW XVH WKH 7\UH VHDODQW DIWHU
WKH VHDODQW KDV H[SLUHG LH SDVW


WKH H[SLUDWLRQ GDWH RQ WKH VHDODQW
FRQWDLQHU 7KLV FDQ LQFUHDVH WKH
ULVNRIW\UHIDLOXUH
WARNING
6HDODQW

7-29
07
OAC3079013R
5. Plug the compressor power cord
(4) into the vehicle power outlet.
6. With the ignition switch in the ON
position, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the Tyre
and Wheels, chapter 2). The infla-
tion pressure of the tyre after filling
is unimportant and will be checked/
corrected later.
Be careful not to overinflate the
tyre and stay away from the tyre
when filling it.
CAUTION
7\UHSUHVVXUH
'R QRW DWWHPSW WR GULYH \RXU YHKL-
FOHLIWKHW\UHSUHVVXUHLVEHORZ
SVL  N3D 7KLV FRXOG UHVXOW LQ
DQ DFFLGHQW GXH WR VXGGHQ W\UH
IDLOXUH
7. Switch off the compressor.
8. Detach the hoses from the sealant
bottle connector and from the tyre
valve.
Return the Tyre Mobility Kit to its stor-
age location in the vehicle.
WARNING
&DUERQPRQR[LGH
'R QRW OHDYH \RXU YHKLFOH UXQQLQJ
LQ D SRRUO\ YHQWLODWHG DUHD IRU
H[WHQGHG SHULRGV RI WLPH  &DUERQ
PRQR[LGH SRLVRQLQJ DQG VXIIRFD-
WLRQFDQRFFXU

7-30
Emergency situations
'LVWULEXWLQJWKHVHDODQW
OHI068053
9. Immediately drive approximately
4~6 miles (7~10 km or, about 10
min) to evenly distribute the seal-
ant in the tyre.
Do not exceed a speed of 50 mph (80
km/h). If possible, do not fall below a
speed of 12 mph (20 km/h).
Whilst driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive
with caution until you can safely pull
off of the side of the road.
Call for road side service or towing.
&KHFNLQJWKHW\UHLQIODWLRQ
SUHVVXUH
OIGH067043
OAC3079012TU
1. After driving approximately 4~6
miles (7~10 km or, about 10 min),
stop at a safety location.
2. Connect the filling hose (3) of the
compressor directly to the tyre
valve.
3. Connect between compressor and
the vehicle power outlet using the
cable and connectors.

7-31
07
4. Adjust the tyre inflation pressure to
the recommended tyre inflation.
With the ignition switched on, pro-
ceed as follows.
- 7R LQFUHDVH WKH LQIODWLRQ SUHV-
VXUH Switch on the compressor.
To check the current inflation
pressure setting, briefly switch off
the compressor.
- 7R UHGXFH WKH LQIODWLRQ SUHV-
VXUH Press the button (9) on the
compressor.
NOTICE
'R QRW OHW WKH FRPSUHVVRU UXQ IRU
PRUH WKDQ  PLQXWHV RWKHUZLVH
WKH GHYLFH ZLOO RYHUKHDW DQG PD\
EHGDPDJHG
i,QIRUPDWLRQ
The pressure gauge may show higher
than actual reading when the compres-
sor is running. To get an accurate tyre
reading, the compressor needs to be
turned off.
CAUTION
,I WKH LQIODWLRQ SUHVVXUH LV QRW
PDLQWDLQHG GULYH WKH YHKLFOH D
VHFRQG WLPH UHIHU WR 'LVWULEXWLQJ
WKHVHDODQW7KHQUHSHDWVWHSVWR

8VHRIWKH70.PD\EHLQHIIHFWXDO
IRUW\UHGDPDJHODUJHUWKDQDSSUR[-
LPDWHO\PPLQ
:HUHFRPPHQGWKDW\RXFRQWDFWD
+<81'$,DXWKRULVHGUHSDLUHULIWKH
W\UH FDQQRW EH PDGH URDGZRUWK\
ZLWKWKH7\UH0RELOLW\.LW
WARNING
7KH W\UH LQIODWLRQ SUHVVXUH VKRXOG
PHHW WKH VWDQGDUG

7-32
Emergency situations
7RZLQJVHUYLFH
OAC3079029TU
[A] : Dolly
If emergency towing is necessary, we
recommend having it done by a
HYUNDAI authorised repairer or a
commercial tow-truck service.
Proper lifting and towing procedures
are necessary to prevent damage to
the vehicle. The use of wheel dollies
or flatbed is recommended.
It is acceptable to tow the vehicle with
the rear wheels on the ground (with-
out dollies) and the front wheels off
the ground.
If any of the loaded wheels or sus-
pension components are damaged or
the vehicle is being towed with the
front wheels on the ground, use a
towing dolly under the front wheels.
When being towed by a commercial
tow truck and wheel dollies are not
used, the front of the vehicle should
always be lifted, not the rear.
CAUTION