2022 HYUNDAI ELANTRA N flat tire

08
8-15
IF YOU HAVE A FLAT TIRE (WITH TIRE MOBILITY KIT)
OCN7N081003NOCN7N081003N
For safe operation, carefully read and
follow the instructions in this manual
before use.
(1) Compressor
(2) Sealant bottle
The Tire Mobility Kit is a temporary fix
to the tire and we recommend that the
system be inspected by an authorized
HYUNDAI dealer.
CAUTION
When two or more tires are flat, do not
use the tire mobility kit because the
supported one sealant of Tire Mobility
Kit is only used for one flat tire.
WARNING
Do not use the Tire Mobility Kit to repair
punctures in the tire walls. This can
result in an accident due to tire failure.
WARNING
Have your tire repaired as soon as
possible. The tire may loose air pressure
at any time after inflating with the Tire
Mobility Kit.
Introduction
With the Tire Mobility Kit you stay mobile
even after experiencing a tire puncture.
The system of compressor and sealing
compound effectively and comfortably
seals most punctures in a passenger car
tire caused by nails or similar objects and
reinflates the tire.
After you ensured that the tire is properly
sealed you can drive cautiously on the
tire (distance up to 120 miles (200 km/h))
at a max. speed of 50 mph (80 km/h) in
order to reach a service station or tire
dealer to have the tire replaced.
It is possible that some tires, especially
with larger punctures or damage to the
sidewall, cannot be sealed completely.
Air pressure loss in the tire may adversely
affect tire performance.
For this reason, you should avoid abrupt
steering or other driving maneuvers,
especially if the vehicle is heavily loaded
or if a trailer is in use.
The Tire Mobility Kit is not designed
or intended as a permanent tire repair
method and is to be used for one tire
only. This instruction shows you step
by step how to temporarily seal the
puncture simply and reliably.
Read the section “Notes on the safe use
of the Tire Mobility Kit”.
WARNING
Do not use the TMK if a tire is severely
damaged by driving run flat or with
insufficient air pressure.
Only punctured areas located within the
tread region of the tire can be sealed
using the TMK.
CN7 N HMA 8.indd 8-152021-09-06  4:18:12

Emergency Situations8-16
Components of the Tire Mobility Kit
OCN7H080007OCN7H080007
0. Speed-restriction label
1. Sealant bottle and label with speed restriction
2. Filling hose
3. Connectors and cable for the power outlet direct connection
4. Holder for the sealant bottle
5. Compressor
6. ON/OFF switch
7. Pressure gauge for displaying the tire inflation pressure
8. Button for reducing the tire inflation pressure
Connectors, cable and connection hose are stored in the compressor housing.
Strictly follow the specified sequence, otherwise the sealant may escape under high
pressure.
CN7 N HMA 8.indd 8-16 2021-09-06  4:18:12

08
8-17
WARNING
Expired sealant
Do not use the Tire sealant after
the sealant has expired (i.e. pasted
the expiration date on the sealant
container). This can increase the risk of
tire failure.
WARNING
Sealant
• Keep out of reach of children.
• Avoid contact with eyes.
• Do not swallow.
Using the Tire Mobility Kit when
a Tire is Flat
CAUTION
OCN7N081004NOCN7N081004N
Detach the speed restriction label (0)
from the sealant bottle (1), and place
it in a highly visible place inside the
vehicle such as on the steering wheel to
remind the driver not to drive too fast.
CAUTION
If only the tire pressure needs to be
adjusted, refer to “How to Adjust Tire
Pressure” in this chapter.
Before using the Tire Mobility Kit, be
fully aware of the explanation on the
sealant. 1. Shake the sealant bottle.
OCN7070007OCN7070007
2. Connect the filling hose (2) to the
sealant bottle (1) in the direction of (A)
and connect the sealant bottle to the
compressor (5) in the direction of (B).
3. Ensure that the compressor is switched OFF.
4. Unscrew the valve cap from the valve of the defective wheel and screw the
filling hose (2) of the sealant bottle
onto the valve.
OCN7N081093OCN7N081093
CAUTION
Securely install the sealant filling hose
to the valve. If not, sealant may flow
backward, possibly clogging the filling
hose.
CN7 N HMA 8.indd 8-17 2021-09-06  4:18:13

Emergency Situations8-18
OCN7N081005OCN7N081005
5. Plug the compressor power cord (4) into the vehicle power outlet.
NOTICE
Only use the front passenger side
power outlet when connecting the
power cord.
6. Set the Engine Start/Stop button to the ON position.
7. Switch on the compressor and let it run for approximately 5~7 minutes to
fill the sealant up to proper pressure.
(refer to the Tire and Wheels, chapter
2). The inflation pressure of the tire
after filling is unimportant and will be
checked/corrected later.
Be careful not to overinflate the tire
and stay away from the tire when
filling it.
CAUTION
Tire pressure
Do not attempt to drive your vehicle if
the tire pressure is below 29 psi (200
kPa). This could result in an accident
due to sudden tire failure. 8. Switch off the compressor.
9. Detach the hoses from the sealant
bottle connector and from the tire
valve.
Return the Tire Mobility Kit to its storage
location in the vehicle.
WARNING
Carbon monoxide
Do not leave your vehicle running in
a poorly ventilated area for extended
periods of time. Carbon monoxide
poisoning and suffocation can occur.
OLMF064106OLMF064106
10. Immediately drive approximately 4~6
miles (7~10 km or, about 10min) to
evenly distribute the sealant in the
tire.
Do not exceed a speed of 50 mph (80
km/h). If possible, do not fall below a
speed of 12 mph (20 km/h).
While driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive with
caution until you can safely pull off of the
side of the road.
Call for road side service or towing.
CN7 N HMA 8.indd 8-18 2021-09-06  4:18:13

08
8-19
OOSN081023OOSN081023
OCN7N081093OCN7N081093
11. After driving approximately 4~6 miles
(7~10 km or, about 10min), stop at a
safety location.
12. Connect the filling hose (2) of the
compressor directly to the tire valve.
13. Plug the compressor power cord into
the vehicle power outlet.
14. Adjust the tire inflation pressure to the
recommended tire inflation.
With the Engine Start/Stop button in
the ON position, proceed as follows.
- To increase the inflation pressure
: Switch on the compressor. To
check the current inflation pressure
setting, briefly switch off the
compressor.

- To reduce the inflation pressure:
Press the button (8) on the
compressor.
NOTICE
Do not let the compressor run for more
than 10 minutes, otherwise the device
will overheat and may be damaged.
Information
The pressure gauge may show higher than
actual reading when the compressor is
running. To get an accurate tire reading,
the compressor needs to be turned off.
CAUTION
If the inflation pressure is not
maintained, drive the vehicle a second
time, refer to step 10.
Then repeat steps 11 to 14.
Use of the TMK may be ineffectual for
tire damage larger than approximately
0.16 in (4 mm).
Please contact the nearest HYUNDAI
dealership if the tire cannot be made
roadworthy with the Tire Mobility Kit.
WARNING
The tire inflation pressure must be at
least 32 psi (220 kPa). If it is not, do not
continue driving.
Call for road side service or towing.
CAUTION
Tire pressure sensor
(if equipped with TPMS)
The sealant on the tire pressure sensor
and wheel should be removed when
you replace the tire with a new one and
inspect the tire pressure sensors. We
recommend that you get this done at an
authorized HYUNDAI dealer.
CN7 N HMA 8.indd 8-19 2021-09-06  4:18:15

Emergency Situations8-20
Information
When reinstalling the repaired or replaced
tire and wheel on the vehicle, tighten the
wheel lug nut to 79~94 lbf·ft (11~13 kgf·m).
How to Adjust Tire Pressure
OOSN081023OOSN081023
OCN7N081093OCN7N081093
1. Park your vehicle in a safe location.
2. Connect the filling hose (2) of the compressor directly to the tire valve.
3. Plug the compressor power cord into the vehicle power outlet.
4. Adjust the tire inflation pressure to the recomended tire inflation.
With the Engine Start/Stop button ON,
proceed as follows.

- To increase the inflation pressure
: Switch on the compressor. To
check the current inflation pressure
setting, briefly switch off the
compressor.

- To reduce the inflation pressure:
Press the button (8) on the
compressor.
NOTICE
Do not let the compressor run for more
than 10 minutes, otherwise the device
will overheat and may be damaged.
Information
The pressure gauge may show higher than
actual reading when the compressor is
running. To get an accurate tire reading,
the compressor needs to be turned off.
CAUTION
Do not use the sealant when the tire
pressure only needs to be adjusted.
WARNING
The tire inflation pressure must be at
least 32 psi (220 kPa). If it is not, do not
continue driving.
Call for road side service or towing.
CN7 N HMA 8.indd 8-20 2021-09-06  4:18:15

08
8-21
Notes on the Safe Use of the Tire
Mobility Kit
• Park your car at the side of the road so that you can work with the Tire
Mobility Kit away from moving traffic.
• To be sure your vehicle will not move, even when you’re on fairly level
ground, always set your parking brake.
• Only use the Tire Mobility Kit for sealing/inflation passenger car tires.
Only punctured areas located within
the tread region of the tire can be
sealed using the tire mobility kit.
• Do not use on motorcycles, bicycles or any other type of tires.
• When the tire and wheel are damaged, do not use Tire Mobility Kit
for your safety.
• Use of the Tire Mobility Kit may not be effective for tire damage larger than
approximately 0.24 in (6 mm).
• Please contact the nearest HYUNDAI dealership if the tire cannot be made
roadworthy with the Tire Mobility Kit.
• Do not use the Tire Mobility Kit if a tire is severely damaged by driving run flat
or with insufficient air pressure.
• Do not remove any foreign objects such as nails or screws that have
penetrated the tire.
• Provided the car is outdoors, leave the engine running. Otherwise operating
the compressor may eventually drain
the car battery. • Never leave the Tire Mobility Kit
unattended while it is being used.
• Do not leave the compressor running for more than 10 min. at a time or it
may overheat.
• Do not use the Tire Mobility Kit if the ambient temperature is below -22°F
(-30°C).
• In case of skin contact with the sealant, wash the area thoroughly
with plenty of water. If the irritation
persists, seek medical attention.
• In case of eye contact with the sealant, flush your eyes for at least 15
minutes. If the irritation persists, seek
medical attention.
• In case of swallowing the sealant, rinse the mouth and drink plenty of
water. However, never give anything
to an unconscious person and seek
medical attention immediately.
• Long time exposure to the sealant may cause damage to bodily tissue
such as kidney, etc.
CN7 N HMA 8.indd 8-21 2021-09-06  4:18:16

Tires and Wheels ........................................................................\
.................. 9-33Tire Care ........................................................................\
.......................................... 9-34
Recommended Cold Tire Inflation Pressures ....................................................... 9-34
Check Tire Inflation Pressure ........................................................................\
......... 9-35
Tire Rotation ........................................................................\
................................... 9-35
Wheel Alignment and Tire Balance ....................................................................... 9-36
Tire Replacement ........................................................................\
........................... 9-37
Wheel Replacement ........................................................................\
....................... 9-38
Tire Traction ........................................................................\
.................................... 9-38
Tire Maintenance..................................................................\
.................................. 9-38
Tire Sidewall Labeling ........................................................................\
.................... 9-38
Tire Terminology and Definitions ........................................................................\
...9-41
All Season Tires ........................................................................\
...............................9-44
Summer Tires ........................................................................\
.................................9-44
Snow Tires......................................................................\
.........................................9-44
Radial-Ply Tires ........................................................................\
............................... 9-45
Low Aspect Ratio Tires ........................................................................\
................... 9-45
Fuses ...................................................................\
.......................................... 9-47Instrument Panel Fuse Replacement ....................................................................9-48
Engine Compartment Panel Fuse Replacement ..................................................9-49
Fuse/Relay Panel Description........................................................................\
........9-50
Light Bulbs ........................................................................\
............................9-58Headlamp, Position Lamp, Turn Signal Lamp and Daytime Running
Light Bulb Replacement ........................................................................\
................ 9-59
Side Repeater Lamp Replacement ...................................................................... 9-60
Rear Combination Lamp Bulb Replacement ....................................................... 9-60
High Mounted Stop Lamp Replacement .............................................................. 9-62
License Plate Light Bulb Replacement .................................................................9-63
Interior Light Bulb Replacement ........................................................................\
...9-63
Appearance Care ........................................................................\
.................9-65Exterior Care ........................................................................\
................................... 9-65
Interior Care ........................................................................\
.................................... 9-70
Emission Control System ........................................................................\
..... 9-73
California Perchlorate Notice ...................................................................... 9-76
9
CN7 N HMA 9.indd 9-22021-09-08  9:30:13