TIRE MIXING
For best performance it is recommended
that the same size and type of tire be used
on all four wheel positions. Before mixing
tires of different types in any configuration
on any vehicle, be sure to check the vehicle
manufacturer’s Owner’s Manual for its
recommendations.
It is especially important to check the
vehicle manufacturer’s owner’s manual
when mixing, matching, or replacing tires
on 4-wheel drive vehicles, as this may
require special precautions.
NOTE:Tires which meet the U.S. Tire
Manufacturers Association (USTMA)
definition of snow tires are marked M/S,
M+S or M&S. On such tires, this
designation is molded into the sidewall.
Tires without this notation are not
recommended for winter driving.
Tires designated for use in severe winter
conditions are marked on at least one
sidewall with the letters ‘‘M” and ‘‘S” plus
a pictograph of a mountain with a
snowflake on it. It is recommended that
winter tires be applied to all four wheel
positions. Failure to do so may negatively
affect vehicle handling.
TIRE ROTATION
To obtain maximum tire wear, it may be
necessary to rotate your tires. Refer to
your vehicle owner’s manual for
instructions on tire rotation.
NOTE: Your vehicle may be equipped
with a dissimilar spare tire/wheel.
A dissimilar spare tire/wheel is defined
as a spare tire and/or wheel that is
different in brand, size or appearance
from the road tires and wheels. If you have a dissimilar spare tire/wheel it is
intended for temporary use only and
should not be used in a tire rotation.
NOTE:
After having your tires rotated,
inflation pressure must be checked and
adjusted to the vehicle requirements.
Monthly inspection for tire wear is
recommended. Your tires should be
rotated at the first sign of irregular wear,
even if it occurs before the next
recommended rotation interval for your
vehicle. This is true for all vehicles. When
rotating tires with a directional tread
pattern, observe the arrows molded on
the sidewall which show the direction the
tire should turn. Care must be taken to
maintain the proper turning direction. As a
general rule, whenever only two tires are
replaced, the new ones should be put on
the rear.
CUSTOMIZATION OF TIRES,
WHEELS, OR SUSPENSION
ON SUVS AND LIGHT TRUCKS
Due to their size, weight and higher center
of gravity, vehicles such as SUVs and light
trucks do not have the same handling
characteristics as automobiles. Because
of these differing characteristics, failure to
operate your SUV/truck in a proper and
safe manner can increase the likelihood of
vehicle rollover. Modifications to your
SUV/truck tire size, tire type, wheels or
suspension can change its handling
characteristics and further increase the
likelihood of vehicle rollover. Whether
your SUV/truck has the original
equipment configuration for tires, wheels
and suspension or whether any of these
items have been modified, always drive
safely, avoid sudden, sharp turns or lane
Safety Information
63
