Page 19 of 68
17
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
) " / % 4 ' 3 & & ' 6 / $ 5 * 0 / $ 0 / 5 * / 6 & %
Power tilt & telescopic steering wheel
Toggle the control switch to set angle and length.
NOTE: Do not attempt to adjust while the vehicle is in motion.
Power easy access system (if equipped): The steering wheel and driver’s seat
move in accordance with power switch mode and the driver’s seat belt condition.
Up
Control switch
Away from
the driverToward
the driver
DownAngleLength
Power windows
All window auto up/down
Push the switch completely down or pull it completely up and release to fully open
or close. To stop window partway, lightly push the switch in the opposite direction.
Window lock switch
Deactivates all passenger windows. Driver’s window remains operable.
Driver side
UpDown
Indicator
Window lock switch
To automatically open/close Power Liftgate Quickly swipe your foot near the
lower center part of the rear bumper for within 1 second to trigger sensor. To
operate, make sure that the touchless sensor operation is enabled, the vehicle is
OFF and that you are carrying the remote.
Press “
” or “ ” of the meter control switches and select “ 1 # %
w from
the “Vehicle Settings” in the “
” screen J O U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
U P
access hands-free settings. And push “
” to enter selection.
NOTE: Use the same gear and “
” icons from the HUD section.
For more details, refer to the Owner’s Manual.
Page 22 of 68
20
* Move lever partway and release. The signals will flash three times.
Right turn
Lane change
*
Lane change*
Left turn
Lights & turn signals
Daytime Running Light system (DRL) Automatically turns on under certain
conditions to make vehicle more visible to other drivers. Not for use at night.
Automatic light cut off system Automatically turns lights off after 30 second
delay, or lock switch on the remote is pushed after all doors are locked.
Automatic High Beams (AHB) system* Automatically switches between high
and low beams as appropriate to enhance vision at night.
Refer to Toyota Safety Sense™ 2.0 (TSS 2.0) in this guide or the Owner’s Manual
for more details on the Automatic High Beams feature.
* Operating conditions must be met. Refer to the Owner’s Manual for details.
HEADLIGHTS
Parking lights
Auto Headlights
DRL OFF
TURN SIGNALS
Low beam
(Original position)High beam flasher
(Pull)
High beam (Push)
Bottle holders
' 3 0 / 5 % 0 0 3 . 0 6 / 5 & %
3 & " 3 % 0 0 3 . 0 6 / 5 & %
FEATURES & OPERATIONS
Page 25 of 68
23
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Clock
Star Gaze™ fixed panoramic roof (if equipped)
1 V T I iMENU” button next to the screen.
4 F M F D U iSetup” or “General” in the touch screen to access the general settings
screen.
4 F M F D U iClock.”
5 I F O T F M F D U E F T J S F E J U F N T U P C F S F T F U
Refer to the Navigation and Multimedia System Owner’s Manual for more details.
* Available only on vehicles equipped with 12.3-in display
Refer to Panoramic fixed moonroof with one-touch frosted glass control in the
Owner’s Manual for more details. NOTE: The roof automatically becomes opaque when the vehicle is turned off.
Select to change the time zone.
Select to set daylight saving
time ON/OFF/AUTO*.
Select to set automatic GPS
adjustment of clock.
Select to set the 24 hour time
format on/off.
The fixed glass roof can change between
opaque and transparent when the dimming
switch is pressed.
The indicator on the dimming switch turns
on when the moon roof is transparent.
If the dimming switch is pressed when the
electronic sunshade is fully closed, the
electronic sunshade opens automatically
and the roof changes from opaque to
transparent automatically.
Indicator
Press
DIMMING OPERATION
The fixed glass roof automatically returns
to opaque when the electronic sunshade is
closed, and the indicator on the dimming
switch turns off.
SUNSHADE SLIDING OPERATION
Page 29 of 68
27
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURESPower switchCharge area
Operation indicator light
Qi Wireless charger
A mobile device can be charged wirelessly on the tray. (1) Press the wireless
charger power switch and the green operation indicator light turns on. (2) Place
a compatible mobile device on the tray as shown in the illustration. An amber
indicator illuminates while charging is in progress. When charging is complete, the
indicator illuminates green. Some phones, cases or cover type wireless chargers
may not cause the green indicator to illuminate even though it is fully charged.
Refer to the Owner’s Manual for limitations and more details on this system before
attempting to use it.
Press (1)
When the engine is turned off, the last state
(ON/OFF) of the charger is memorized.
Place device nearest the center of charging
area for best results. Moving device may
result in stopping or restarting the charging
process.
Place (2)
Page 34 of 68
32
FEATURES & OPERATIONS
Heated steering wheel (if equipped)
The vehicle must be on for use.
Garage door openers manufactured under license from HomeLink®* can be
programmed to operate garage doors, estate gates, security lighting, etc.
Refer to the Owner’s Manual for limitations and more details.
For programming assistance, contact HomeLink
® at 1-800-355-3515, or visit
http://www.homelink.com/toyota.
*
HomeLink® is a registered trademark of Gentex Corporation.
Garage door opener (HomeLink®)* (if equipped)
HomeLink® icon
ButtonsHomeLink® indicator light
Vehicles with auto anti-glare inside rear view mirror
Garage door operation
indicatorsGarage door operation
indicators
HomeLink
® logo:
Appears while HomeLink®
is operating. HomeLink® indicator light:
Illuminates above each
button selected.HomeLink
® icon
Vehicles with Digital Rearview Mirror
HomeLink® buttons Menu buttonsSetting icon
Page 54 of 68
52
Automatic High Beams (AHB)
ACTIVATING THE AHB SYSTEM
CONDITIONS WHERE AHB WILL TURN ON/OFF AUTOMATICALLY
When all of the following conditions are met, the high beams will be automatically
U V S O F E P O B G U F S B Q Q S P Y J N B U F M Z T F D P O E
t 7 F I J D M F T Q F F E J T B C P W F B Q Q S P Y J N B U F M Z N Q I L N I
• The area ahead of the vehicle is dark.
• There are no oncoming or preceding vehicles with headlights or tail lights
turned on.
• There are few streetlights on the road ahead.
If any of the following conditions occur, the high beams will be automatically turned off:
t 7 F I J D M F T Q F F E E S P Q T C F M P X B Q Q S P Y J N B U F M Z N Q I L N I
• The area ahead of the vehicle is not dark.
• Oncoming or preceding vehicles have headlights or tail lights turned on.
• There are many streetlights on the road ahead. 5 I F " V U P N B U J D ) J H I # F B N T " ) #
T B G F U Z T Z T U F N J T E F T J H O F E U P I F M Q Z P V T F F
more clearly at night. At speeds above 25 mph, AHB can detect the headlights of
oncoming vehicles and taillights of preceding vehicles, then automatically toggles
between high and low beams accordingly.
See toyota.com/safety-sense for more information.
Refer to the Toyota Owner’s Manual for a list of additional situations in which the
system operation may be limited.
(2) (1)
1 S F T T U I F i
” switch.
5 V S O U I F I F B E M J H I U T X J U D I U P U I F U I F i " 6 5 0 w P S i
” position.
The AHB indicator will come on when the headlights are turned on automatically
to indicate that the system is active.
Note: Push the lever away from you to manually turn on high beams. Press the
AHB switch to turn the AHB system off.
The AHB indicator will turn off and “
” or “” will turn on. To activate the
system again, pull the lever its original position or press the “
” switch.
TOYOTA SAFETY SENSE™
Page 59 of 68
57
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Tire Pressure Monitoring (warning) System (TPMS)
The tire pressure warning system can be selected on “” of the Multi-Information
% J T Q M B Z . * %
System reset initialization
Press “
” or “ ” switches and select “” from the Multi-Information
% J T Q M B Z . * %
Press “
” or “ ” switches and select the “Vehicle Settings,” then push “.”
Press “
” or “ ” switches and select “TPWS setting” and then push “.”
Press “
” or “ ” switches and select “Setting Pressure” then push and
hold “
” until the warning light blinks three times.
The tire pressure detected by the tire pressure warning system can be displayed
P O U I F N V M U J J O G P S N B U J P O E J T Q M B Z . * %
Refer to the load label on the door jamb or the Owner’s Manual for tire inflation
specifications.
If the tire pressure indicator flashes for approximately 1 minute and then remains
on, take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not been
initialized recently, setting the tire pressures to factory specifications should
turn off the light.
VEHICLES EQUIPPED WITH 4.2-in MID
VEHICLES EQUIPPED WITH 7-in MID
Page 60 of 68
58
SAFETY & EMERGENCY FEATURES
Safety Connect®
Safety Connect is a subscription-based telematics service that uses Global
1 P T J U J P O J O H 4 Z T U F N ( 1 4
E B U B B O E F N C F E E F E D F M M V M B S U F D I O P M P H Z U P Q S P W J E F T B G F U Z
and security features to subscribers. Safety Connect is staffed with live agents at
the Toyota response center, which operates 24 hours per day, 7 days per week.
Services for subscribers include:
• Automatic collision notification
• Stolen vehicle locator
t & N F S H F O D Z B T T J T U B O D F i 4 0 4 w C V U U P O
• Enhanced roadside assistance
For additional information, refer to the “Owner’s Manual” or visit www.Toyota.com/
connected-services.
Microphone
LED light indicators
(Green is Active)
“SOS” button
