2021 LINCOLN CORSAIR Owners Manual

Page 185 of 638

LINCOLN CORSAIR 2021  Owners Manual Folding the Power Seat Backrest (If
Equipped) Folds the left-hand rear seat
backrest.
A
Folds the right-hand rear seat
backrest.
B
Press and hold the button for a few seconds
to fold the corresponding

Page 186 of 638

LINCOLN CORSAIR 2021  Owners Manual Note:
Depending on your remote start
settings, the heated seats may remain on
after you remote start your vehicle. The
heated seats may also turn on when you
start your vehicle if they were on when yo

Page 187 of 638

LINCOLN CORSAIR 2021  Owners Manual Press this symbol to cycle through the
various ventilation settings and off. More
indicator lights indicate higher fan speeds.
If the engine falls below 350 RPM while the
ventilated seats are on, the

Page 188 of 638

LINCOLN CORSAIR 2021  Owners Manual WHAT IS THE REAR OCCUPANT
ALERT SYSTEM
The rear occupant alert system monitors
vehicle conditions and notifies you to check
for rear seat occupants when you switch the
ignition off.
HOW DOES THE REAR

Page 189 of 638

LINCOLN CORSAIR 2021  Owners Manual SWITCHING REAR OCCUPANT
ALERT SYSTEM ON AND OFF
1. Press Settings on the touchscreen.
2. Press 
Vehicle.
3. Switch 
Rear Occupant Alert on or off.
Note: The default setting is on.
Note: When you switc

Page 190 of 638

LINCOLN CORSAIR 2021  Owners Manual WHAT IS THE GARAGE DOOR
OPENER
Universal Garage Door Opener: HomeLink
HomeLink Wireless Control System
The universal garage door opener replaces
the common hand-held garage door opener
with a three-bu

Page 191 of 638

LINCOLN CORSAIR 2021  Owners Manual Note:
We recommend that upon the sale or
lease termination of your vehicle, you erase
the programmed function buttons for security
reasons.  See Clearing the Garage Door
Opener (page 190).
GARAGE DOOR

Page 192 of 638

LINCOLN CORSAIR 2021  Owners Manual Note:
If the indicator light stays on, the
programming is complete.
Note: If the HomeLite indicator flashes
rapidly, repeat step 5.
Note: If your device still does not operate,
you must program your g