Page 74 of 476
& $ 8 7 , 2 1
Do not exceed the maximum power of
160 Watts (13 Ampsyf D W 9 R O W V , I W K H
160 Watt (13 Ampyf S R Z H U U D W L Q J L V H [ F H H G H G
the fuse protecting the system will need to
be replaced.
Power outlets are designed for accessory
plugs only. Do not insert any other object in
the power outlets as this will damage the
outlet and blow the fuse. Improper use of the
power outlet can cause damage not covered
by your New Vehicle Limited Warranty.
WARNING!
To avoid serious injury or death:
Do not insert any objects into the receptacles.
Do not touch with wet hands.
Close the lid when not in use.
If this outlet is mishandled, it may cause an
electric shock and failure.
Page 409 of 476
& $ 8 7 , 2 1
8 V L Q J D W U D Q V P L V V L R Q I O X L G R W K H U W K D Q W K H
P D Q X I D F W X U H U U H F R P P H Q G H G I O X L G P D \ F D X V H
G H W H U L R U D W L R Q L Q W U D Q V P L V V L R Q V K L I W T X D O L W \ D Q G R U
W R U T X H F R Q Y H U W H U V K X G G H U Úpage 456.
WARNING!
When replacing a blown fuse, always use an
appropriate replacement fuse with the same
amp rating as the original fuse. Never replace
a fuse with another fuse of higher amp rating.
Never replace a blown fuse with metal wires or
any other material. Failure to use proper fuses
may result in serious personal injury, fire and/
or property damage.
Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an
authorized dealer.
If a general protection fuse for safety systems
(air bag system, braking systemyf S R Z H U X Q L W
systems (engine system, gearbox systemyf R U
steering system blows, contact an authorized
dealer.8
21_JL_OM_EN_USC_t.book Page 407
Page 417 of 476
& $ 8 7 , 2 1
When installing the power distribution center cover, it is important to ensure the cover is properly positioned and fully latched. Failure to do so may allow
water to get into the power distribution center and possibly result in an electrical system failure.
When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating. The use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If a properly rated fuse continues to blow, it indicates a problem in the circuit that must be corrected.8
21_JL_OM_EN_USC_t.book Page 415
