2020 TOYOTA RAV4 change time
[x] Cancel search: change timePage 2 of 64
RAV4 2020
This Quick Reference Guide is a summary of basic vehicle
operations. It contains brief descriptions of fundamental
operations so you can locate and use the vehicle’s main
equipment quickly and easily.
The Quick Reference Guide is not intended as a substitute for
the Owner’s Manual located in your vehicle’s glove box. We
strongly encourage you to review the Owner’s Manual and
supplementary manuals so you will have a better understanding
of your vehicle’s capabilities and limitations.
Your dealership and the entire staff of Toyota Motor North
<0022004e00460053004a00440042000d0003002a004f0044000f00030058004a005400490003005a005000560003004e0042004f005a0003005a00460042005300540003005000470003005400420055004a0054006d00460045000300450053004a005700
4a004f00480003004a004f0003005a0050005600530003>
new RAV4.
A word about safe vehicle operations
This Quick Reference Guide is not a full description of RAV4 operations. Every
RAV4 owner should review the Owner’s Manual that accompanies this vehicle.
Pay special attention to the boxed
information highlighted in color throughout
the Owner’s Manual. Each box contains safe operating instructions to help you
avoid injury or equipment malfunction.
All information in this Quick Reference Guide is current at the time of printing.
Toyota reserves the right to make changes at any time without notice.
Page 18 of 64
16
FEATURES & OPERATIONS
1 The right hand signals will flash three times.2 The left hand signals will flash three times.
Right turn
Lane change
1
Lane change2
Left turn
Lights & turn signals
Daytime Running Light system (DRL) Automatically turns on under certain
conditions to make vehicle more visible to other drivers. Not for use at night.
Automatic light cut off system Automatically turns lights off after 30 second
delay, or lock switch on remote is pushed after locking.
Automatic High Beam (AHB) system Automatically switches between high
and low beams as appropriate to enhance vision at night.
Refer to Toyota Safety Sense™ 2.0 (TSS 2.0) in this guide or the Owner’s Manual
for more details on the Automatic High Beam feature.
* Operating conditions must be met. Refer to the Owner’s Manual for details.
Type AType B
HEADLIGHTS
Parking lights
Low beam
High beam
Automatic High beam*or Auto Headlights
DRL OFFParking lights
DRL ONHeadlights
OFF
High beam flasher
TURN SIGNALS
Page 22 of 64
20
FEATURES & OPERATIONS
Moonroof (if equipped)
Recommended driving position to
minimize wind noise. Push once to open partway; again
to open completely.
SLIDING OPERATION
TILTING OPERATION
Lightly press either side of the moonroof switch while opening/tilting is in progress,
the moonroof stops partway.
Push once to open completely.
Tilt
Close
Open
Close
Clock
1 V T I iMENU” button next to the screen.
4 F M F D U iSetup” or “General” in the touch screen to access the general settings
screen.
4 F M F D U iClock.”
5 I F O T F M F D U E F T J S F E J U F N T U P C F S F T F U
Refer to the “Navigation and Multimedia System Owner’s Manual” for more details.
* Premium Audio only
Select to change time zone
Select to daylight savings
time ON/OFF/AUTO*.
Select to set to automatic
GPS adjustment of clock.
Select to set hour display
to 12 or 24 hour time.
Page 26 of 64
24
Microphone
FEATURES & OPERATIONS
Bluetooth® technology allows dialing or receipt of calls without removing your hands
from the steering wheel.
Refer to the Bluetooth
® device pairing in this guide or the Navigation and
Multimedia System Owner’s Manual for additional user instructions.
NOTE: Concentrating on the road should always be your first priority while
driving. Do not use the Audio Multimedia system if it will distract you.
Back switch
Volume control
Voice command
switch Start and end call
“MODE”
Push to change audio mode.
Push and hold to mute or
pause the audio.
“ ”
Use to search within the
selected audio feature.
Steering wheel switches
& telephone controls (Bluetooth®)
Page 32 of 64
30
FEATURES & OPERATIONS
If the sensors detect an obstacle, the buzzer and MID or navigation system
display informs the driver of the approximate position and distance of the obstacle
C Z J M M V N J O B U J O H D P O U J O V P V T M Z G B S
P S C M J O L J O H O F B S
% F Q F O E J O H P O Z P V S " V E J P
Multimedia system, you can adjust settings.
To turn system ON/OFF:
Press “
/ ” or “ / ” and “” of the meter control switches and select
“
” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
4 F M F D U
and press “”. The system displays when the the system is
operational.
Refer to the Owner’s Manual for limitations and more details.
Refer to all of the section Parking Support Brake functions (static objects and rear-
crossing vehicles) in the Owner’s Manual for limitations and more details.
Front
center sensor
Rear
center sensor Corner sensors
(front)Corner sensors
(front)
Corner sensors
(rear)Corner sensors
(rear)
Intuitive Parking Assist (if equipped)
The Front and Rear Parking Assist with Automated Braking consists of the following
functions that operate when driving at a low speed or backing up, such as when
parking. When the system determines that the possibility of a collision with a
detected object is high, a warning operates to urge the driver to take evasive
action. If the system determines that the possibility of a collision with a detected
object is extremely high, the brakes are automatically applied to help avoid the
collision or help reduce the impact of the collision.
CHANGE SETTINGS
Use “ / ” or “ / ” and “” of the meter control switches to select “”
and
J O U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
U P D I B O H F T F U U J O H T 5 I F T Z T U F N X J M M
D P O U J O V F J O U I F M B T U T U B U F J U X B T J O 0 / P S 0 ' '
X I F O U I F F O H J O F J T T U B S U F E B H B J O
Front and Rear Parking Assist with
Automated Braking
(if equipped)
Page 41 of 64
39
CHANGING PRE-COLLISION ALERT TIMING
% * 4 " # - * / ( 1 3 & $ 0 - - * 4 * 0 / 4 : 4 5 & . 1 $ 4
Each time the PCS switch is pressed, the response to the PCS alert timing changes.
FarMiddle
(default)Near
1 S F T T “ ” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ PCS” and then press “.” The setting
screen is displayed.
1 S F T T “
” switches and select “Sensitivity” and then press “” to select
the desired setting. Each time it is pressed, the response to the PCS alert timing
changes as shown above.
1ress “
” to go back to the menu.
Note: PCS is enabled each time the engine switch is turned to Ignition On.
The system can be disabled/enabled and the alert timing of the system can be
changed. (Alert timing only, brake operation remains the same).
1 S F T T “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ PCS” and then press “.”
1 S F T T “
” and select “PCS” and then press “” to select the desired setting.
1 S F T T “
” to go back to the menu.
Note: The system is enabled each time the power switch is turned to ON mode.
Refer to the Toyota Owner’s Manual for additional information on PCS operation,
settings adjustments, limitations, and precautions before attempting to use it.
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Page 42 of 64
40
TOYOTA SAFETY SENSE™
LDA in TSS 2.0 uses an in-vehicle camera designed to detect visible white and
yellow lane markers or road edge in front of the vehicle and the vehicle’s position
on the road. If the system determines that the vehicle is starting to unintentionally
deviate from its lane, the system alerts the driver with an audio and visual alert.
When the alerts occur, the driver must check the surrounding road situation and
carefully operate the steering wheel to move the vehicle back to the center part of
their lane.
- % " J T E F T J H O F E U P G V O D U J P O B U T Q F F E T P G B Q Q S P Y J N B U F M Z N Q I L N I
P S I J H I F S
on relatively straight roadways.
In addition to the alert function, LDA w/SA also features a steering assist
function. When enabled, if the system determines that the vehicle is on a path to
unintentionally depart from its lane, the system may provide small corrective steering
inputs to the steering wheel for a short period of time to help keep the vehicle in its
lane.
If the vehicle repeatedly deviates from the lane, the vehicle drifts within the lane due
to inattention, or the driver abruptly operates the steering wheel after an inattentive
period, when enabled, the vehicle sway warning function alerts the driver with an
audio and visual alert, urging them to take a break.
Lane Departure Alert with Steering Assist
(LDA w/SA)
TURNING THE LDA SYSTEM ON/OFF
Press the LDA switch to turn the LDA system on. Depress again to turn it off.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
Refer to the Toyota Owner’s Manual for additional information on LDA operation,
settings adjustments, limitations, and precautions before attempting to use it.
Page 57 of 64
55
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Tire Pressure Monitoring (warning) System (TPMS)
The image may differ from the image that is
actually displayed on the MID.
Refer to the load label on the door jamb or the Owner’s Manual for tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then remains on,
take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not been
initialized recently, setting the tire pressures to factory specifications should
turn off the light.
The tire pressure warning system can be selected on “” of the multi-information
E J T Q M B Z . * %
System rest initialization
4 F M F D U i 7 F I J D M F T 4 F U U J O H w B O E U I F O Q V T I i”.
4 F M F D U i 5 1 8 4 w B O E U I F O Q V T I i
”.
4 F M F D U i 4 F U 1 S F T T V S F w U I F O Q V T I B O E I P M E i
” until the message displays on
MID and the warning light blinks three times.
Safety Connect® (if equipped)
Safety Connect® is a subscription-based telematics service that uses Global
1 P T J U J P O J O H 4 Z T U F N ( 1 4
E B U B B O E F N C F E E F E D F M M V M B S U F D I O P M P H Z U P Q S P W J E F T B G F U Z
and security features to subscribers. Safety Connect
® is staffed with live agents at
the Toyota response center, which operates 24 hours per day, 7 days per week.
Services for subscribers include:
• Automatic collision notification
• Stolen vehicle locator
t & N F S H F O D Z B T T J T U B O D F i 4 0 4 w C V U U P O
• Enhanced roadside assistance
For additional information, refer to the “Owner’s Manual” or visit www.Toyota.com/
connected-services.
Microphone
LED light indicators
“SOS” button