2020 SUBARU ASCENT lights

2PURPOSE OF THIS GUIDE
5ENTRY AND EXIT
8INSTRUMENT PANEL
10GETTING COMFORTABLE
21CONTROLS
27GAUGES AND WARNING LIGHTS
28OPERATING THE VEHICLE
33REFUELING
34PASSENGER/CARGO AREAS
39ENGINE COMPARTMENT
41ADDITIONAL SPECIFICATIONS
43INDEX
TABLE OF CONTENTS

KEYLESS ENTRY
1Lock/Arm
• Pressing this button will lock all doors, rear gate and fuel
door and activate the security alarm.
• If any of the doors or the rear gate are not fully closed, five
rapid chirps will sound and the hazard warning flashers will
flash.
• Pressing this button three times (within five seconds) will
activate the vehicle finder function. If you are within 30 feet
of your Subaru, the horn will sound once, and the hazard
warning flashers will flash three times.
2Unlock/Disarm
• Pressing this button once will unlock the driver’s door and
fuel door if set to do so in the Touchscreen.
• Pressing this button twice (within five seconds) will unlock
all doors and rear gate.
• When you press this button, the interior lights will illuminate,
if set to the “DOOR” position on the overhead console
switch.
3Rear Gate
• Pressing this button will unlock the rear gate.
• If equipped with a Power Rear Gate, pressing and holding
this button will open or close the rear gate.
4Panic Alarm
• Pressing this button will sound the horn and flash the
hazard warning lights.
• Press any button on the access key fob or transmitter to deactivate.
Access Key Fob
Transmitter
ENTRY AND EXIT
5

1Power Windows (p. 14)
2Power Exterior Mirrors (p. 13)
3Instrument Panel Switches (p. 25)
4I/Set Switch (p. 22)
5Audio Controls (p. 21)
6Light Controls (p. 22)
7Gauges and Warning Lights (p. 27)
INSTRUMENT PANEL
8

POWER EXTERIOR MIRRORS
Turn the knob to “L” (left side) or “R” (right side) to
select a mirror. Move the knob in the direction you
want to move the mirror. Return the knob to the
neutral center position.
Power Folding Mirrors(if equipped)
Press the switch to fold the outside mirrors.
Press again to unfold the mirrors.
REAR VIEW MIRROR
Auto-dimming Mirror(if equipped)
When driving at night, the auto-dimming function
senses brightness from vehicle headlights behind you
and automatically dims to reduce glare. Pressing the
switch will turn this function on or off. A green LED
indicator on the switch will illuminate when the
function is on.
HomeLink®5 Accessory Mirror(if equipped)
The HomeLink®5 accessory mirror provides three
buttons to replace up to three hand-held radio
frequency remotes used to activate devices, such as
garage door openers, gate openers, entry door locks,
security systems, and home lighting. For programming
instructions, please refer to the Owner’s Manual or
visit www.subaru.com/homelink to view a how-to
video.
NOTE: HomeLink
®5 may not be compatible with some older door
openers or additional equipment may be required.
GETTING COMFORTABLE
13

I/SET SWITCH
Use the controls to display and change selected items
in the Combination Meter Display (CMD). Pull and hold
this switch to access the settings menu. Pull the
arrows to move up or down the menu.
LIGHT CONTROLS
1AUTO:If equipped, rotate the end of the
lever to automatically turn your headlights
on or off, depending on the level of
outside light.
2Daytime Running Lights:Rotate the end
of the lever to turn on the instrument
panel lights, parking lights, side marker
lights, tail lights, and license plate lights.
3Headlights:Rotate the end of the lever to
turn on the headlights, instrument panel lights, parking lights, side marker lights, tail
lights, and license plate lights.
4High Beams:Push the lever forward to change from low beam to high beam. Pull the
lever back to center to return to low beam. If equipped, this also activates the High
Beam Assist (HBA) system.
5Fog Lights:If equipped, rotate the dial to turn on the fog lights.
Illumination Brightness
While the light switch is on, rotating the dial on the instrument panel
upward will make the instrument panel illumination brighter. When
the dial is fully rotated upward (dots aligned), the instrument panel
illumination stays at full brightness. Rotating the dial downward
dims the instrument panel illumination.
For map equipped vehicles, this setting also affects the day/night
view and illumination level.
CONTROLS
22

Daytime Running Lights
The daytime running lights automatically turn on when the engine has started, the parking
brake is fully released, the light switch is in the Off, “AUTO” (if equipped) or “
”
position, and the select lever is not in the “P” position. Always turn on the headlights when
it’s dark outside by rotating the dial to the “
” or “AUTO” position.
TURN SIGNALS
Push slightly up for right lane change or fully
up for right turn signal. Push slightly down for
left lane change or fully down for left turn
signal.
WINDSHIELD WIPERS
To turn on the wipers, press the wiper control
lever down one position for intermittent, two
positions for low speed, or three positions for
high speed. To turn the wipers off, return the
lever to the “OFF” position. For a single wipe,
move the lever up one position.
When the lever is in the intermittent position,
rotate the dial to adjust the operating interval
of the wipers.
Pull the lever toward you to spray washer fluid.
The washer will spray until you release the lever, then wipe twice.
CONTROLS
23

INSTRUMENT PANEL SWITCHES (LOWER LEFT)
1Power Rear Gate (if
equipped) (see page 36)
2One-touch Interior Lighting (if
equipped) (see following
section)
3Power Rear Gate Memory (if
equipped) (see page 37)
4Vehicle Dynamics Control
OFF
5Blind Spot Detection/Rear Cross Traffic Alert OFF (if equipped)
6Illumination Brightness (see page 22)
ONE-TOUCH INTERIOR LIGHTING(if equipped)
Press the switch to turn on the map lights and reading lights. Press
it again to turn the lights off. The lights will also turn off if you lock
your Subaru with the access key fob or transmitter, or using the
front door handle or rear gate lock.
CONTROLS
25

OVERHEAD PANEL
1SOS Emergency
Assistance:Press the
“SOS” button to connect
with a SUBARU STARLINK
®
Customer Care Advisor.
(Subscription required.)
Press and hold the button for
about two seconds to cancel
the call. Refer to the
SUBARU STARLINK
®Safety
and Security Owner’s
Manual or the SUBARU STARLINK
®Quick Guide.
2Enhanced Roadside Assistance:Press the “i” button to connect with a SUBARU
STARLINK
®Roadside Assistance Provider. (Subscription required.) Press and hold
the button for about two seconds to cancel the call. Refer to the SUBARU
STARLINK
®Quick Guide.
3Lane Departure Warning OFF switch:Press and hold this switch for two seconds to
turn off the Lane Departure Warning and the Lane Sway Warning function. Press and
hold the switch again for two seconds to turn the systems back on. Refer to the
EyeSight
®Owner’s Manual or Quick Guide.
4Pre-Collision Braking System OFF switch:Press and hold this switch for two
seconds to turn off the Pre-Collision Braking System and Pre-Collision Throttle
Management. Press and hold the switch again for two seconds to turn the systems
back on. Refer to the EyeSight
®Owner’s Manual or Quick Guide.
5Automatic Illumination:When the switch is in the “DOOR” position, the map lights
illuminate when any door is opened, the doors are unlocked using the remote keyless
entry system or keyless access function, or the ignition is turned from “ON” or “ACC”
to “LOCK”/“OFF”.
6Map Lights:Press a map light to turn it on or off.
CONTROLS
26