Page 121 of 194
The engine makes noises after the cold start
The increased running noise is due to the briefly in-
creased engine speed. This is not a defect.
START STOPUsage
The START STOP system reduces environmentally
damaging emissions, including CO 2, and saves fuel.
If the system determine that the engine is not nee-
ded when the vehicle stops, it turns o
Page 122 of 194
Automatic gearbox
Lever positions
Parked vehicle The drive wheels are
locked.
Only set the posi-
tion when the vehi- cle is stationary.
Reverse gear
Only set the posi-
tion when the vehi- cle is stationary.
Neutral
There is no transmission of engine power to the
wheels.
Forward drive / sports program
The gear is changed automatically.
In
mode, the gear is changed at higher speeds
than in mode.
Choose between and (spring-loaded posi-
tion)
Moving the selector lever out of the
or position
lights up - the selector lever is locked
Page 123 of 194
If the engine threatens to over-rev
Page 124 of 194
Operation
Select driving mode
Page 125 of 194
Distribution of the load over the vehicle and trailer
combination
Page 126 of 194
Page 127 of 194
WARNING
Danger of brake failure!
If the brake fluid change date is exceeded, heavy
braking may cause vapour bubbles to form in the
brake system.
Troubleshooting
Brake fluid level is too low
illuminates
Page 128 of 194
Multi-Collision Brake (MCB)
MCB helps to decelerate and stabilize the vehicle af-
ter a collision with an obstacle. This reduces the risk
of further collisions.
Operating conditions
q There has been a frontal, side and rear collision of
a certain severity.
q The impact speed was greater than 10 km/h.
q The brakes, ESC and other required systems re-
mained functional after the impact.
q The accelerator pedal is not pressed.
Trailer Stability Assist (TSA)
TSA helps to stabilize the trailer. As the trailer begins
to lurch, TSA stabilizes the trailer by slowing down
the individual vehicle wheels.
Operating conditions
q The hitch was supplied from the factory or pur-
chased from