2020 Seat Leon warning

Driving
system itself, the rear and side environment of
the v ehicl
e using the rear sensors
››› page 242. It detects moving objects that
approach from behind, such as cars
››› Fig. 193.
If a critical situation is detected when the
door is opened, it will be alerted by an acous-
tic signal on the door speaker of the corre-
sponding side ››› Fig. 194
. Additionally, the
control lamp of the lane departure warning of
the corresponding door will flash. If the door
has already been opened and another road
user has been detected in a critical situation,
the control lamp of the lane departure warn-
ing on the corresponding side will light up
permanently.
The brightness of the door opening warning
indication cannot be adjusted.
When you want to access the vehicle for the
first time, with the doors closed and locked,
the function will be available 3 minutes after
the first opening of any of the doors. The
function will continue to be available as long
as the vehicle has the ignition connected and
is not moving.
After switching off the ignition, the function
will remain available for approximately 3 mi-
nutes. After that time, the control lamps will
light up indicating the deactivation of the
function. WARNING

Braking and parking
harder, as the braking distance increases due
t o the l
ack of assistance from the servo brake. WARNING
Any anomaly in the brake system can in-
cr ease the br

aking distance, with the re-
sulting risk of an accident.

Driving
ignition, the function will remain on the next
time the ignition is s wit
ched on.
If the Auto Hold function was not switched on,
it will automatically remain off next time the
ignition is engaged.
The Auto Hold function connects automat-
ically if the following conditions are met
(all points must be met at the same time
››› ):
The v ehicl

e is kept stationary with the
brake pedal on a flat surface or on a
slope.
The engine rotates “correctly”.
The Auto Hold function is automatically
turned off if the following conditions are
met: If any of the conditions mentioned on
››› page 277, Conditions for keeping
the vehicle stationary with the Au-
to Hold function are no longer met.
If the engine is running irregularly or an
anomaly is detected.
If the engine stalls.
Manual gearbox: The clutch and the ac-
celerator are pressed at the same time.
Automatic gearbox: If the accelerator is
pressed
Automatic gearbox: If any of the tyres
has only minimal contact with the
1.
2.
1.
2.
3.
4.
5. ground, e.g. in the case of axle articula-
tion. WARNING
The smart technology incorporated into
the Aut o Hol

d function cannot defy the
laws of physics; it only works within the lim-
its of the system. The greater convenience
provided by the Auto Hold function should
never tempt you to take any risk that may
compromise safety.

Braking and parking
Brake assist systems Electronic Stability Control (ESC)
The ESC helps t
o impr
ove safety. It reduces
the tendency to skid and improves the stabili-
ty and roadholding of the vehicle. The ESC
detects critical handling situations, such as
vehicle understeer or oversteer, or wheelspin
on the driving wheels. It stabilises the vehicle
by braking individual wheels or by reducing
the engine torque. The warning lamp will
flash on the instrument panel when the ESC is
intervening !.
The ESC includes the anti-lock brake system
(ABS), the hydraulic brake assist (HBA), the
traction control system (TCS), electronic dif-
ferential lock (EDS), electronic torque control
(XDS) and the tractor-trailer sway mitiga-
tion*.
ESC also helps stabilise the vehicle by
changing the torque.
The TCS can be deactivated when wheel
spin is desirable ››› page 281
.
Anti-lock brake system (ABS)
ABS prevents the wheels from locking up un-
der braking until the vehicle has reached a
virtual standstill. You can continue to steer the
vehicle even when the brakes are on full.
Keep your foot on the brake pedal and do not
pump the brakes. You will feel the brake pedal
pulsate while the ABS is working. If the running gear or brake system is modi-
fied, the eff
ectiv

eness of the ABS could be se-
verely limited.
Hydraulic Brake Assist (HBA)
The brake assist system can reduce the re-
quired braking distance. The braking force is
automatically boosted if you press the brake
pedal quickly in an emergency. You must
keep pressing the brake pedal until the dan-
ger has passed.
Traction control (TCS)
In the event of the wheels spinning, the TCS
reduces the engine torque to adapt to the
road condition. This helps the car to start
moving, accelerate or climb a gradient.
Electronic differential lock (EDL)
When the EDL detects wheelspin, it brakes
the spinning wheel and directs the power to
the other driven wheel. This function is active
up to approximately 100 km/h (62 mph).
To prevent the disc brake of the braked wheel
from overheating, the EDL cuts out automati-
cally if subjected to excessive loads. The ve-
hicle can still be driven. The EDL will switch on
again automatically when the brake has
cooled down. Tractor-trailer sway mitigation*
If the vehicl
e is pulling a trailer, it will control
the following: tractor-trailers tend to sway.
When the swaying of the trailer is felt by the
vehicle and detected by the ESC, it will auto-
matically brake the towing vehicle within the
limits of the system and mitigate the sway.
Tractor-trailer sway mitigation is not available
in all countries ››› page 303
.
Electronic engine torque management
(XDS)
When taking a curve, the driveshaft differen-
tial allows the outer wheel to turn at a higher
speed than the inner wheel. In this way, the
wheel that is turning faster (outer wheel) re-
ceives less drive torque than the inner wheel.
This may mean that in certain situations the
torque delivered to the inner wheel is too
high, causing the wheels to spin. On the other
hand, the outer wheel is receiving a lower
drive torque than it could transmit. This can
cause a loss of grip on the drive axle, in this
case the front axle, which results in under-
steer or “lengthening” of the trajectory.
The XDS can detect and correct this effect
via the sensors and signals of the ESC.
Via the ESC, the XDS will brake the inside
wheel and counter the excess driving torque
of that wheel. This means that the requested
trajectory is much more precise. »
279

Help with parking and manoeuvring
WARNING
The technology used in the park assist sys-
t em inv
olves a series of limitations inherent
in the actual system and in the use of ultra-
sonic sensors. The use of Park Assist should
never tempt you to take any risk that may
compromise safety. The system is not a re-
placement for driver awareness.

Help with parking and manoeuvring
Visual indication segments Fig. 203
Parking aid view on the Infotainment
syst em displ
ay. The optical indication of the segments works
as f
oll

ows:
Grey segments: the obstacle is more
than approx. 30 cm away from the path
or in the direction opposite to travel.
They are also displayed when the elec-
tronic parking brake is activated.
Yellow segments: the obstacles lie on
the vehicle’s path and are at a distance
of less than approx. 30 cm away.
Red segments: obstacles are less than
approx. 30 cm away.
A wake will indicate the anticipated forward
or backward trajectory, depending on the en-
gaged gear. –
–
– If an obstacle is located in the vehicle’s way,
the corresponding audibl

e warning will
sound.
When the penultimate segment is displayed,
the vehicle has reached the collision zone. In
the collision zone, the obstacles are repre-
sented in red (including those out of the
path). Stop the vehicle! ››› in Introduction
on page 290, ››

› in Introduction on
page 290 !
Setting the indications and audio
signal s The indications and acoustic signals are set
in the Inf
ot

ainment system: function button 
> Driver assistance> Parking aid: Setup
Automatic activa-
tion On/off
Front volume* Volume in the front and rear
area.
R

ear volume* Volume in the rear area.
Adjust volume When the parking aid is
s
wit

ched on, the volume of
the audio source will be re-
duced, depending on the se-
lected option. Error messages
If a an error or fault message appears on the
instrument clust
er in P

ark Assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated
next time the parking aid is connected.
If a rear sensor is faulty, only the obstacles in
the areas A and
B are displayed
› ›

› Fig. 202. If a front sensor is faulty, only the
obstacles in the areas C and
D will be dis-
pl ayed. Symbol

Help with parking and manoeuvring
Towing device
In v ehicl
es equipped with a towing bracket
device from the factory, when the trailer is
connected, the parking aid will not be activa-
ted when reverse gear is engaged.
Reverse Assist (Rear View
Camera)*
Oper

ating and safety warnings WARNING

Driving
Towing bracket device*
T r
ailer mode
Introduction Take into account country-specific regula-
tions about driving with a tr
ail

er and the use
of a towing bracket.
The vehicle has been developed primarily for
carrying people, although it can also be used
to tow a trailer if fitted with the corresponding
technical equipment. This additional load has
an effect on the useful life, fuel consumption
and vehicle performance and in some cases
can reduce the service intervals.
Driving with a trailer requires more force from
the vehicle, and thus more concentration
from the driver.
In winter, winter tyres should be fitted on both
the vehicle and the trailer.
Maximum vertical load technically permit-
ted on the coupling device
The maximum technical permitted vertical
load of the trailer's towing bracket on the
hook of the tow-bar is 80 kg.
Vehicles with the Start-Stop system
If the vehicle has a factory-fitted towing
bracket or one that is retrofitted by SEAT, the Start-Stop system operates as normal. No
special char
act

eristics need to be taken into
account.
If the system does not recognise the trailer or
the trailer bracket has not been retrofitted by
SEAT, the Start-Stop system must be discon-
nected by pressing the corresponding button
in the lower part of the centre console before
driving with the trailer, and it should remain
off for the rest of the journey ››› .
V ehicl

es with driving profile selection
If you are going to be towing a trailer, the use
of the Eco driving profile is not recommen-
ded. You are advised to select another of the
available driving profiles before beginning to
drive with a trailer.
Trailer weight/drawbar load
Never exceed the authorised trailer weight. If
you do not load the trailer up to the maximum
permitted trailer weight, you can then climb
correspondingly steeper slopes.
The maximum trailer weights listed are only
applicable for altitudes up to 1000 m above
sea level. Since higher altitude decreases en-
gine performance and the ability to climb
slopes, the tow load decreases proportional-
ly. The weight of the vehicle and trailer com-
bination must be reduced by 10% for every
1000 m of altitude. When possible, operate
the trailer with the maximum authorised drawbar load on the ball joint of the to

wing
bracket, but do not exceed the specified lim-
it. WARNING
Never use the trailer to transport people,
since it w oul

d put their life in danger and is
also prohibited. WARNING
Undue use of the towing bracket may
cause injury and accidents.