2020 Alfa Romeo 4C lock

SERVICING AND CARE
112
Lifting blade
If it is necessary to lift the blade from the
windscreen (e.g. in the event of snow or if
the blade needs replacement) proceed as
follows:
❒ by turning the ring nut 1 fig. 96 to
;
❒ turn the ignition key to MAR and then
to STOP;
❒ after turning the ignition key to STOP,
within 2 minutes move the right stalk
upwards, into unstable (“anti-panic”)
position, for at least half a second. The
windscreen wiper then executes part of a
stroke; at each command, approximately
1/3 of a normal wiper stroke is triggered.
❒ the previous operation can be
repeated up to 3 times, in order to move
the blade to the most suitable position;
❒ lift the blade from the windscreen and
proceed with the required operation;
96A0L0021
❒ lower the blade, bringing it into
contact with the windscreen;
❒ bring the blade to the initial rest
position, turning the ignition key to MAR.
20)
Replacing the front windscreen wiper
blade
Proceed as follows:
❒ lift the windscreen wiper blade,
following the instructions given
preciously;
❒ press tab 1 fig. 97 of the attachment
spring and remove the blade from the
arm;
❒ fit the new blade, inserting the tab in
the dedicated housing in the arm and
checking that it is locked;
AIR FILTER
For cleaner replacement, contact a
dedicated Alfa Romeo Dealership.
WINDSCREEN WIPER
It is advisable to replace the blade about
once a year.
125)
A few simple precautions can reduce the
possibility of damage to the blade:
❒ if the temperature falls below zero,
make sure that ice has not frozen the
rubber to the glass.
Use an antifreeze product to release it if
required;
❒ remove any snow from the glass;
❒ do not operate the windscreen wiper
on dry glass.
IMPORTANT Do not lift the arm of the
windscreen wiper when it is in its initial
rest position. Refer to the following
instructions to lift the windscreen wiper
blade correctly.

121
VEHICLE IDENTIFICATION
NUMBER
This is located on the dashboard at the
bottom of the windscreen fig. 105.
Marking
The marking 1 fig. 106 is printed
on the passenger compartment floor
panel, near the passenger side seat.
The marking includes: vehicle type and
sequential chassis number.
105A0L0158
106A0L0089
BODYWORK PAINT
IDENTIFICATION PLATE
It is applied under the tailgate and shows
the following data fig. 107:
A Paint manufacturer.
B Colour name.
C Colour code.
D Respray and touch up code.
107A0L0090
ENGINE MARKING
It is stamped on the cylinder block and
includes the type and the engine serial
number.

129
Prescribed fuels /
Fluids and original lubricants1750 Turbo Petrol
kglitres
REFUELLING
Fuel tank 40 –
Unleaded petrol no
including a reserve of 4 - 5 – lower than 95 RON (EN228 specifications)
Engine cooling system 10,6 9,4 50% mixture of distilled water and
PARAFLUUP(*)
Engine sump 5.4 4.6
SELENIA SPORT POWER
Engine sump and filter 5.8 5.0
Gearbox/differential 1.88 1.6 TUTELA TRANSMISSION GEARTECH
Hydraulic gearbox actuator system 1.45 1.2 TUTELA CS SPEED
Hydraulic brake circuit with
0.52 0.56 TUTELA TOP 4 or TUTELA TOP 4/S
ABS anti-locking device
Windscreen washer liquid vessel 1.9 1.7 Water and liquid mixture
PETRONAS DURANCE SC 35
(*) When the vehicle is used in particularly harsh weather conditions, we recommend using a 60% mixture of PARAFLU
UPand 40% of
demineralised water.

SPIDER
136
REMOVABLE SOFT TOP
135) 29)
The car is equipped with a soft top
fig. 109 that can be removed manually
and combines ease of use and total
protection against weather agents.
The soft top can be stored in a suitable
container inside the luggage
compartment after having been removed.
To remove the soft top, proceed as
follows:
❒ release the two central locking
devices 1 fig. 110 inside the car by
rotating them by ¼ turn anti-clockwise;
109A0L0200
❒ at the side of the car, with the door
open, press the rail downwards to de-
tension the soft top, then move the two
side devices 2 fig. 111 inwards and lift
the soft top end part releasing it from the
retainers;
❒ package the first side of the soft top
rolling it up to the centre line;
❒ proceed in the same way for the other
side of the soft top;
❒ remove the soft top with both sides
rolled and store it in the suitable
container inside the luggage
compartment.
❒ before placing it in the dedicated
container it is necessary to cover the
central pins 1 Fig. 112 with the
appropriate buffer included in the supply
to prevent damage to the soft top fabric
during the packaging.
110A0L0201
112A0L0198
111A0L0202

137
To position again the soft top on the car,
proceed as follows:
❒ open the doors;
❒ take the soft top from the luggage
compartment and place it in the centre
line; the front side can be recognised by
the presence of the safety visor fig. 110;
❒ unroll the soft top inserting it under
the spoiler and making sure that it is
correctly positioned;
❒ turn the rail upwards and insert in the
side centring pins of the soft top in the
respective housings
fig. 113 on the car being careful to insert
the front pin and the rear pin;❒ press the side devices 2 inwards
fig. 114 and turn the rail downwards;
❒ leave the handles and complete the
rail rotation pressing it until you hear the
closing click of the lock;
❒ check that the devices 2 are
completely closed fig. 115;
❒ proceed in the same way for the other
side of the soft top;
114A0L0220
❒ position the two central devices
1 fig. 110 in the suitable housing inside the
car and rotate them by ¼ turn clockwise
to lock them. Check the correct insertion of
the pins into their seats and make sure the
grab ring is in horizontal position.
The fixing is carried out correctly and the
soft top is ensured only when the ring is
located in a horizontal position
(not vertical, or at 45°).
IMPORTANT NOTES
❒ It is advisable to install the soft top
after parking the car.
The closed top effectively protects the
car from rain and from theft.
115A0L0221
113A0L0203

139
SCHEDULED SERVICING
During each scheduled servicing
operation and anyway every 12 months,
check operation of the soft top locks.135)Before starting the car make sure
the soft top is correctly locked.
It is recommended not to remove/install
the soft top with people sitting in the car,
as the soft top could fall in the passenger
compartment while it is moved.
Be careful while installing/removing the
soft top to prevent any damage or injury.
Keep children away from the area in which
the soft-top is folding while
installing/removing it.
IMPORTANT
29)Never open the soft top in presence
of snow or ice to prevent damage. Loads
may not be secured on the vehicle roof.
30)Bird droppings and plant resins must
be washed off the soft top immediately
as they can damage its fabric. Never use
high-pressure washing systems. When
using steam washers or high-pressure
water washers, maintain a suitable
distance and do not exceed a maximum
temperature of 60°C.
Damage, alterations and water
infiltration may occur if the distance is
too small and the pressure is too high.
WARNING
If a water jet is used, direct away from the
edges of the fabric and the windscreen
surround: water infiltration can occur.
Never use alcohol, petrol, chemical
products, detergents, stain removers,
wax, solvents and “wash and polish”
products. Rinse immediate to remove
soap to prevent stains and halos.
Repeat the operation if needed.
31) Follow the instructions on the
waterproofing product container for
perfect results. The rubber seals of the
soft top must be washed with water only.
If you notice that this trim is dry or is
sticking, apply talcum powder or products
specifically for rubber trim (silicone
spray).

141
Direction indicators
To replace the bulb, proceed as follows:
❒ steer the wheel completely;
❒ open the protective flap
1 fig. 117 by rotating the fixing screw;
❒ rotate the plug 1 fig. 118
anti-clockwise and remove the bulb
holder;
118A0L0196
❒ rotate the bulb 2 fig. 119 to release it
from the retainers and remove it;
❒ replace the bulb making sure it is
correctly locked;
❒ close the protective flap 1 fig. 117.
Side lights/daytime running lights
(DRL)
These are LEDs. For the replacement
contact a dedicated Alfa Romeo
Dealership.
119A0L0197
Dipped/main beam headlights
(versions with halogen headlights)
To replace the bulb, proceed as follows:
❒ steer the wheel completely;
❒ open the protective flap 2 fig. 117 by
rotating the fixing screw;
❒ take out the electric connector
1 fig. 120 and then rotate the bulb holder
2 anticlockwise and remove it;
❒ emove the bulb and replace it;
❒ refit the new bulb, making sure that it
is locked correctly, and reconnect the
connector 1;
❒ close the protective flap 2 fig. 117.
120A0L0093

149
ALPHABETICAL INDEX
ABS system......................................................50
Active safety systems ..........................50
Air cleaner ................................................112
Alarm .............................................................11
Alfa DNA system .....................................27
All Weather mode ...................................28
Dynamic mode ..........................................27
Natural mode .............................................27
Race mode ..................................................27
All Weather mode ...................................28
Alfa Romeo CODE system .................11
Alfa Romeo Code.....................................12
ASR (AntiSlip Regulation) system..50
Battery.............................................................113
recharging ................................................113
replacement ...........................................114
tips for extending battery life ......114
Body cleaning and maintenance..........115
Body paintwork
identification plate ....................................121
Bodywork........................................................115
corrosion warranty .............................115
maintenance ...........................................116
protection against
atmospheric elements ......................115
Boot/bonnet.............................................24/25
opening .........................................................24
closing ..........................................................25Brake (liquid level) ......................................110
Bulb types .........................................................82
Bump starting ..................................................98
Carrying children safely ............................60
CBC (Cornering Brake Control)
system .................................................................51
Changes/alterations to the car..................4
Changing a bulb ..............................................82
Changing a wheel ...........................................90
Chassis number ...........................................121
Checking levels ...........................................106
Child restraint system ........................61/62
Child restraint systems
recommended by Alfa Romeo.................62
Cleaning (outside and inside) ....116/118
engine compartment ..........................116
fabric seats and parts ........................118
genuine leather parts .........................118
headlights ................................................116
interiors.....................................................117
leather seats...........................................118
plastic and coated parts ...................118
windows ....................................................116
Climate control system ..............................20
CO
2emissions .............................................133
Courtesy lights ...............................................18
Cruise Control..................................................75
Dashboard ...........................................................8
Dashboard and on-board
instruments.......................................................30
Daytime running lights (DRL) ...................17
Dimensions ....................................................127
Dipped beam headlights ............................17
bulb replacement ....................................84
Dipped beam headlights ............................17
bulb replacement ....................................82
Direction indicators ......................................17
bulb replacement ....................................82
Display .................................................................32
Door locking .....................................................12
Door mirrors .....................................................15
Door opening/closing ..................................13
Doors ...................................................................12
central locking/unlocking....................12
DTC (Drag Torque Control) system ......50
EBD system .....................................................50
Electronic Q2 system (“E-Q2”) ................51
Emergency starting .....................................97
Engine codes .................................................121
Engine compartment ................................106
engine coolant level ...........................108
engine oil ..................................................130
identification codes ............................120