
 
Indicator lamps which light up in the light switch are described in the chapter Lights Lig
Symbol Meaning 
  Central warning lamp. Observe the additional information on the instrument cluster 
display. 
  Electronic parking brake  Operating the electronic parking brake. 
  Brake system fault   
  Electromechanical steering not functioning  Troubleshooting. 
  Fasten seat belt  Warning lamp. 
  Collision warning from area monitoring system (Front Assist)  Warning levels and 
 
  Depress the brake pedal. 
  Check brake pads  Troubleshooting. 
  Central warning lamp. Observe the additional information on the instrument cluster 
display. 
  Electronic Stability Control (ESC) OR traction control system (TCS)   TCS regulating 
to  
  Traction control system (TCS) switched off   TCS regulating to prevent the wheels 
 
  Fault in anti-lock brake system (ABS)    
  Fault in electronic parking brake  TroubleshootingOR: fault in Hill Start Assist   
 
  Rear fog light switched on  Switching the fog lights on and off. 
  Vehicle lighting is not working    
  Fault in exhaust system   Fault  
  Fault in engine management system  Troubleshooting.  

 
After validation and evaluation of the information from the camera, the Infotainment system and 
the current vehicle data, the activated Dynamic Road Sign Display shows up to three valid road signs 
Fig. 14 with the accompanying additional signs: 
1st position:The road sign that currently applies for the driver is shown on the left-hand side of the 
display, e.g. a speed limit of 130 km/h (80 mph) Fig. 14.2nd position:Road signs that do not 
always apply (e.g. 100 km/h (60 mph) in wet) are shown in second place.Additional sign:if the 
windscreen wiper is active while the vehicle is in motion, the now valid road sign with the additional 
In wet sign, for example, will be moved left to the first position.3rd position:Further road signs that 
do not always apply will be displayed in the third position, e.g. overtaking not permitted at certain 
times Fig. 14. 
Speed warning 
If the Dynamic Road Sign Display detects that an applicable speed limit has been exceeded, it can 
issue an acoustic warning signal and display a message on the instrument cluster display. 
The speed warning can be set or completely deactivated in the vehicle settings in the Infotainment 
system Vehicle settings menu km/h (3 mph) 
within a range between 0 km/h (mph) and 15 km/h (9 mph) above the permitted maximum speed. 
Trailer mode 
In vehicles with a factory-fitted towing bracket and a trailer with an electrical connection to the 
vehicle, the display of road signs that may apply to the vehicle when towing a trailer, e.g. applicable 
speed limits and no-overtaking signs, can be activated or deactivated in the vehicle settings in the 
Infotainment system Vehicle settings menu 
In trailer mode, the speed warning function display can be adjusted to the type of trailer or to legal 
requirements. The settings can be adjusted in increments of 10 km/h (5 mph) within a range 
between 60 km/h (40 mph) and 130 km/h (80 mph). If a higher speed is set than is permitted for 
driving with a trailer in the country in which you are currently travelling, Dynamic Road Sign Display 
automatically issues a warning at the usual speed limit, e.g. at 80 km/h (50 mph) in Germany. 
If the speed warning for the trailer is deactivated, Dynamic Road Sign Display issues warnings as if 
the vehicle was being driven without a trailer. 
Function limitations 
Dynamic Road Sign Display is subject to system-related limitations. The following conditions can 
restrict the function of Dynamic Road Sign Display, or prevent it from working altogether: 
Poor visibility, e.g. snow, rain, fog or heavy spray. 
Glare, e.g. due to oncoming traffic or sunlight. 
High speeds. 
Covered or dirty camera. 
Road signs that are located outside of the camera's field of view.  

 by trees, snow, dirt or other vehicles. 
Road signs that do not correspond to the standard design. 
Damaged or bent traffic signs. 
Variable road signs on gantries (changeable road sign display using LEDs or other light sources). 
Out-of-date map material in the Infotainment system. 
Stickers on vehicles that show road signs, e.g. speed restrictions on trucks. 
 
WARNING 
The intelligent technology used by the Dynamic Road Sign Display cannot overcome the laws of 
physics, and functions only within the limits of the system. Do not let the extra convenience afforded 
by the Dynamic Road Sign Display system tempt you into taking any risks when driving. The system is 
not a substitute for the full concentration of the driver. 
Always adapt your speed and driving style to suit visibility, weather, road and traffic conditions. 
Poor visibility, darkness, snow, rain and fog can cause road signs not to be displayed or to be 
incorrectly displayed by the system. 
If the camera's field of view is dirty, covered or damaged, the function of the Dynamic Road Sign 
Display system may be impaired. 
 
WARNING 
Driving recommendations and traffic symbols displayed by the Dynamic Road Sign Display system 
may differ from the current traffic situation. 
Not all road signs can be recognised by the system and displayed correctly. 
Road signs on the road and traffic regulations have priority over the recommendations and displays 
provided by the Dynamic Road Sign Display system. 
 
NOTICE 
Availability of the Dynamic Road Sign Display function is limited in waypoint mode (waypoint 
navigation) of the Infotainment system. 
 
Some settings can be saved in the user accounts of the personalisation function and can therefore 
change automatically when the user account is changed Personalisation 
 
  

 
Turn signals 
Side lights, dipped beam headlights and main beam headlights 
Tail light clusters 
Brake lights 
Rear fog light 
Number plate light 
Information on changing bulbs Changing bulbs 
 
DANGER 
Please observe important safety information about the front passenger front airbag Fitting and 
using chi
 
WARNING 
Driving under the influence of alcohol, drugs, medication or narcotics could cause accidents and fatal 
injuries. 
Alcohol, drugs, medication and narcotics can severely impair senses, reaction times and driving 
safety. This could cause you to lose control of the vehicle. 
 
WARNING 
Always observe current traffic regulations and speed limits, and think ahead when driving. The 
correct interpretation of the driving situation can make the difference between reaching your 
destination safely and having an accident with serious injuries. 
 
NOTICE 
Volkswagen is not responsible for any vehicle damage caused by low-quality fuel, inadequate 
servicing work or non-availability of Genuine Parts. 
 
Observe the instructions and information for vehicles with an N1 approval Information about 
vehicles with N1 approval (light commercial vehicle) 
  

tion: 
The lights are switched off.Leaving Home function (orientation lighting) can be switched on 
Coming Home and Leaving Home function (orientation lighting)Side lights or continuous 
parking light on both sides of the vehicle switched on Switching the parking lights on and off
symbol in the light switch lights up green.Dipped beam is switched off the side lights will stay 
on as long as the vehicle key is in the ignition lock or, in vehicles with Keyless Access, the driver door 
is closed. 
Daytime running lights 
The daytime running lights (dependent on equipment level) can increase the visibility of your vehicle 
in traffic during the day. 
The daytime running lights are switched on every time the ignition is switched on when the light 
switch is in position  ,  or (when brightness is detected). 
The daytime running lights cannot be switched on or off manually. 
 
WARNING 
Accidents and serious injuries can occur if the road is not sufficiently illuminated and other road 
users have difficulty seeing the vehicle, or cannot see it at all. 
The light assist systems are designed only to provide support; the driver is responsible for the 
correct vehicle lights being switched on. 
Always switch on the dipped beam headlights if it is dark, raining or visibility is poor. 
 
WARNING 
The side lights or daytime running lights are not bright enough to illuminate the road ahead and to 
ensure that other road users are able to see you. 
Always switch on the dipped beam headlights if it is dark, raining or visibility is poor. 
The tail light clusters are not switched on with the daytime running lights. If the tail light clusters are 
not switched on, the vehicle may not be visible to other road users if it is dark, raining, or if visibility 
is poor. 
 
WARNING 
The automatic headlights ( ) switch dipped beam on and off only when there is a change in 
the level of brightness. 
Switch on dipped beam manually if required by the weather conditions, e.g. in fog. 
  

both sides of the vehicle switches on to 
provide better illumination of the surrounding area when manoeuvring. 
Switching the fog lights on and off 
Switching on the front fog lights : pull the light switch Fig. 79out to the first position. The 
indicator lamp  in the light switch lights up green. 
Switching on the rear fog light : pull the light switch all the way out. The indicator lamp  in the 
instrument cluster lights up yellow. 
To switch the fog lights off, press in the light switch or turn it to position . 
 
When the automatic headlights  are switched on and the front or rear fog lights are switched 
on, the dipped beam headlights will also be switched on irrespective of the current light conditions 
outside. 
 
In vehicles with a factory-fitted towing bracket: the vehicle's rear fog light is not switched on if a 
trailer with rear fog light is electrically connected to the vehicle Trailer towing 
Light functions 
Side lights 
If the side lights are switched on, both headlights light up with the side lights, parts of the tail 
light clusters, the number plate lighting and the buttons in the centre console and the dash panel. 
The daytime running lights also switch on when the ignition is switched on. 
If the vehicle is not locked from outside when the ignition is switched off, the continuous parking 
light on both sides of the vehicle switches on automatically after around 10 minutes to reduce 12-
volt vehicle battery discharge Switching the parking lights on and off 
Automatic headlights  
If the automatic headlights are switched on, the vehicle lighting and the instrument and 
switch lighting will switch on and off according to the light conditions. When the lights are switched 
on, the indicator lamp lights up yellow. 
The automatic headlights are merely an aid and will not always be able to detect all driving 
situations. 
In vehicles with a corresponding equipment level, the switch-on time of the automatic headlights 
can be adjusted in the Infotainment system in the Vehicle settings menu Infotainment system 
controls an
Cornering light 
A cornering light is switched on when turning slowly or travelling around very tight bends. 
Signal tones if lights are not switched off  

 and the driver door opened, acoustic 
warnings sound under the following conditions: 
If the parking light is switched on. 
If the side lights are switched on or the rear fog light is switched on . 
When the Coming Home function is switched on, no signal tone will be given as a reminder that a 
light is still switched on when leaving the vehicle. 
 
Some settings can be stored in the user accounts of the personalisation function and therefore 
change when the user account changes Personalisation 
Troubleshooting 
  Turn signal indicator lamp 
If a turn signal on the vehicle has failed, the indicator lamp will start flashing twice as fast. 
The indicator lamp flashes green. 
Check the lighting and change the appropriate bulb as required Changing bulbs 
If the problem persists, go to a qualified workshop. 
Does not apply in China and Japan: trailer turn signals indicator lamp 
The indicator lamp goes out if a trailer turn signal or all trailer lights stop working. 
The indicator lamp flashes green. 
Check the lighting and change the appropriate bulb as required Changing bulbs 
If the problem persists, go to a qualified workshop. 
Vehicle lighting not working 
Vehicle lighting has failed either completely or partially. 
The indicator lamp lights up yellow. 
Check the lighting and change the appropriate bulb as required Changing bulbs 
If the problem persists, go to a qualified workshop. 
Fault in rain/light sensor 
In the light switch position , the vehicle lighting is not switched on or off automatically. 
The indicator lamp lights up yellow. 
Switch the ignition off and on. 
If the problem persists, go to a qualified workshop.  

matic headlights . 
Tap the turn signal and main beam lever forwards from the basic position. 
When main-beam control is switched on, the indicator lamp  lights up in the instrument cluster 
display. 
Switching off main-beam control 
Pull back the turn signal and main beam lever. 
OR: switch off the automatic headlights . 
OR: switch off the ignition. 
OR: push the turn signal and main beam lever forwards to switch on the manual main beam. 
System limits 
The main beam must be manually switched off under the following conditions, as it is not switched 
off by the main-beam control in time or at all: 
In poorly lit streets where there are highly-reflective signs. 
Other road users with insufficient lighting facilities, such as pedestrians, cyclists. 
In tight bends, with half-hidden oncoming traffic, on steep crests or in dips. 
With oncoming traffic on roads with a central barrier where the driver can see clearly over the 
central barrier e.g. truck drivers. 
In fog, snow or heavy rain. 
In conditions with swirled-up dust and sand. 
If the windscreen is damaged in the camera's field of vision. 
If the camera's field of vision is covered by condensation, dirt, a sticker, or by snow or ice. 
If the camera is faulty or the power supply is interrupted. 
 
WARNING 
Do not let the extra convenience afforded by main-beam control tempt you into taking any risks 
when driving. The system is not a substitute for the full concentration of the driver. 
Always check the vehicle lights yourself and adapt them to the prevailing conditions for light, 
visibility and road traffic. 
The main-beam control may not be able to recognise all driving situations correctly and may not 
work properly in certain situations. 
If the camera's field of view is dirty, covered or damaged, the function of the main-beam control 
may be impaired. This also applies if changes are made to the vehicle's lighting system, for example 
if additional headlights are fitted.