2019 TOYOTA RAV4 ignition
[x] Cancel search: ignitionPage 4 of 64
2
OVERVIEW
Instrument panel
Steering wheel controls
Audio volume
control switch2
Telephone switch2
Voice
command switch2
Tilt and telescopic steering
lock release lever
Ignition switch
Audio control switches2
LTA (Lane Tracing Assist)/Lane Departure
Alert with Steering Assist (LDA w/SA) switch
Meter control
switches
Hood lock release lever Headlight/turn signal/fog light
1 control
Fuel tank door release lever Power Liftgate main switch
1
Bird’s Eye View Camera
ON/OFF switch1,2
Windshield de-icer
switch1
Instrument panel
light control dial
Automatic High Beam
(AHB) switch
Heated steering wheel switch
1
Windshield wiper and washer control
Meters Multi-Information Display (MID)
Full-Speed Range Dynamic Radar
Cruise Control (DRCC) Vehicle-to-
vehicle distance switch
Full-Speed Range
Dynamic Radar Cruise
Control (DRCC) switch
Page 14 of 64
12
* The “ENGINE START STOP” switch/ignition switch must be “ON” and the brake
pedal depressed to shift from Park.
Shift the shift lever to “S” position from “D” position.
+ 6 Q T I J G U Q V T I B O E S F M F B T F
- % P X O T I J G U Q V M M B O E S F M F B T F
Downshifting increases power going uphill, or provides engine braking downhill. For
best fuel economy during normal driving conditions, always drive with the shift lever
in the “D” position.
Auto lock/unlock
Automatic transmission
Automatic door locks can be programmed to operate in different modes, or turned
OFF.
Shift position linked door locking/unlocking function
-Doors lock when shifting from Park.
-Doors unlock when shifting into Park.
Speed linked door locking function
-Doors lock when the vehicle speed goes above approximately 12 mph.
' U L Y H U
Page 24 of 64
22
FEATURES & OPERATIONS
Refer to the Owner’s Manual for more details.
Seat heaters/ventilators (if equipped)
FrontRear
The engine switch must be in the “ON” mode.
Yellow - seat heater on
Green - seat ventilator on Level indicators
4 & " 5 7 & / 5 * - " 5 0 3 4 * ' & 2 6 * 1 1 & %
4 & " 5 ) & " 5 & 3 4 * ' & 2 6 * 1 1 & %
Driver’s seatPassenger’s seat
Engine switch must be in the “ON” position or MID must display the “IGNITION ON.”
Steering wheel-heater (if equipped)
Page 41 of 64
39
CHANGING PRE-COLLISION ALERT TIMING
% * 4 " # - * / ( 1 3 & $ 0 - - * 4 * 0 / 4 : 4 5 & . 1 $ 4
Each time the PCS switch is pressed, the response to the PCS alert timing changes.
FarMiddle
(default)Near
1 S F T T “ ” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select from the MID and then press
“
”. The setting screen is displayed.
1 S F T T “
” each time to change the setting. Each time it is pressed, the
response to the PCS alert timing changes as shown above. You can press “
” to
go back to the menu.
Note: PCS is enabled each time the engine switch is turned to Ignition On.
The system can be disabled/enabled and the alert timing of the system can be
changed. (Alert timing only, brake operation remains the same).
1 S F T T “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” and “” switches to change the setting.
1 S F T T “
” to go back to the menu.
Note: The system is enabled each time the power switch is turned to ON mode.
Refer to the Toyota Owner’s Manual for additional information on PCS operation,
settings adjustments, limitations, and precautions before attempting to use it.
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Page 42 of 64
40
TOYOTA SAFETY SENSE™
LDA in TSS uses an in-vehicle camera designed to detect visible white and yellow
lane markers or road edge in front of the vehicle and the vehicle’s position on the
road. If the system determines that the vehicle is starting to unintentionally deviate
from its lane, the system alerts the driver with an audio and visual alert. When the
alerts occur, the driver must check the surrounding road situation and carefully
operate the steering wheel to move the vehicle back to the center part of their lane.
- % " J T E F T J H O F E U P G V O D U J P O B U T Q F F E T P G B Q Q S P Y J N B U F M Z N Q I L N I
P S I J H I F S
on relatively straight roadways.
In addition to the alert function, LDA w/SA also features a steering assist
function. When enabled, if the system determines that the vehicle is on a path to
unintentionally depart from its lane, the system may provide small corrective steering
inputs to the steering wheel for a short period of time to help keep the vehicle in its
lane.
If the vehicle repeatedly deviates from the lane, the vehicle drifts within the lane due
to inattention, or the driver abruptly operates the steering wheel after an inattentive
period, when enabled, the vehicle sway warning function alerts the driver with an
audio and visual alert, urging them to take a break.
Lane Departure Alert with Steering Assist
(LDA w/SA)
TURNING THE LDA SYSTEM ON/OFF
Press the LDA switch to turn the LDA system on. Depress again to turn it off.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
Refer to the Toyota Owner’s Manual for additional information on LDA operation,
settings adjustments, limitations, and precautions before attempting to use it.
Page 44 of 64
42
" % + 6 4 5 * / ( - % " " - & 3 5 4 & / 4 * 5 * 7 * 5 :
DISABLING STEERING ASSIST
TOYOTA SAFETY SENSE™
SWAY WARNING SYSTEM
1 S F T T “ ” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select the “Steering Assist” setting function and then
press “
.”
1 S F T T “
” each time to change the setting.
1 S F T T “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
5 I F E S J W F S D B O B E K V T U U I F T F O T J U J W J U Z P G U I F - % " X B S O J O H
G V O D U J P O G S P N U I F
. V M U J * O G P S N B U J P O % J T Q M B Z . * %
D V T U P N J [ B U J P O T D S F F O
High - Is designed to warn approximately before the front
tire crosses the lane marker.
Normal - Is designed to warn approximately when the front
tire crosses the lane marker.
1 S F T T “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select the “Sensitivity” setting function and then
press “
.”
1 S F T T “
” each time to change the setting.
1 S F T T “
” to go back to the menu.
SWS is a function of LDA and is designed to detect swaying based on the vehicle
location in the lane and the driver’s steering wheel operation. To help prevent
swaying, the system alerts the driver using a buzzer sound and a warning displays
in the MID.
Continuous lane deviations from
swaying.
Gentle swaying from driver’s
inattentiveness.
Acute steering wheel operation after the
number of operations decrease due to driver’s
inattentiveness.
Page 45 of 64
43
" % + 6 4 5 * / ( 4 8 " : " - & 3 5 4 & / 4 * 5 * 7 * 5 :
DISABLING LDA SWAY WARNING ALERT
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
1 S F T T “ ” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select the “Sway Sensitivity” setting function and then
press “
.”
1 S F T T “
” each time to change the setting.
1 S F T T “
” to go back to the menu.
1 S F T T “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select the “Sway Warning” setting function and then
press “
.”
1 S F T T “
” each time to change the setting.
1 S F T T “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
Page 46 of 64
44 The LTA system is comprised of the lane departure alert function, the steering
assist function, the lane centering function, and the vehicle sway warning function.
The in-vehicle camera detects the visible white and yellow lane markers in front the
vehicle and the vehicle’s position on the road. If the vehicle starts to unintentionally
deviate from its lane when the LTA system is on, the lane departure alert function
alerts the driver with an audio and visual alert. When the steering assist function
is enabled, if the system determines that the vehicle is on a path to unintentionally
depart from its lane, the system may provide small corrective steering inputs to
the steering wheel for a short period of time to help keep the vehicle in its lane.
Additionally, when enabled, the lane centering function will automatically provide
assistance to help keep the vehicle in the center of the lane when Full-Speed DRCC
is set. If the vehicle repeatedly deviates from the lane, the vehicle drifts within the
lane due to inattention, or the driver abruptly operates the steering wheel after an
inattentive period, when enabled, the vehicle sway warning function alerts the driver
with an audio and visual alert, urging them to take a break.
TOYOTA SAFETY SENSE™
TURNING THE LTA SYSTEM ON/OFF
Press the LTA switch to turn the LTA system on. Depress again to turn it off.
Note: Operation of the LTA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
Refer to the Toyota Owner’s Manual for additional information on LTA operation,
settings adjustments, limitations, and precautions before attempting to use it.
Lane Tracing Assist (LTA)