2019 TOYOTA RAV4 Headlight

2
OVERVIEW
Instrument panel
Steering wheel controls
Audio volume
control switch2
Telephone switch2
Voice
command switch2
Tilt and telescopic steering
lock release lever
Ignition switch
Audio control switches2
LTA (Lane Tracing Assist)/Lane Departure
Alert with Steering Assist (LDA w/SA) switch
Meter control
switches
Hood lock release lever Headlight/turn signal/fog light
1 control
Fuel tank door release lever Power Liftgate main switch
1
Bird’s Eye View Camera
ON/OFF switch1,2
Windshield de-icer
switch1
Instrument panel
light control dial
Automatic High Beam
(AHB) switch
Heated steering wheel switch
1
Windshield wiper and washer control
Meters Multi-Information Display (MID)
Full-Speed Range Dynamic Radar
Cruise Control (DRCC) Vehicle-to-
vehicle distance switch
Full-Speed Range
Dynamic Radar Cruise
Control (DRCC) switch

6
OVERVIEW
Indicator symbols
For details, refer to “Indicators and warning lights,” Section 2-1, 2019 Owner’s
Manual.
Blind Spot Monitor (BSM) warning4
BSM outside rear view mirror
indicators1,4
Brake system warning1
Charging system warning1
Brake system warning1
[Yellow]
Fuel tank door position Airbag ON/OFF indicator
1
Anti-lock Brake System (ABS)
warning1
Automatic High Beam (AHB)
indicator
ECO drive mode indicator
Electric power steering system
warning1 [Red/yellow]
Intuitive parking assist OFF
indicator2,4
Brake hold operating indicator1,2
Brake hold standby indicator1
Downhill assist control system
indicator1,2,4
Brake Override System/Drive-Start
Control/PKSB 4 warning
Driver’s and front passenger’s seat
belt reminder
(alarm will sound if
speed is over 12 mph)Airbag SRS warning1
Fog light indicator4
High coolant temperature warningHeadlight low/high beam
indicators
Eco driving indicator1,4
Constant speed cruise control
indicator/Constant speed
cruise control SET indicator
Full-Speed Range Dynamic
Radar Cruise Control (DRCC)
indicator/DRCC SET indicator

16
FEATURES & OPERATIONS
1 The right hand signals will flash three times.2 The left hand signals will flash three times.
Right turn
Lane change
1
Lane change2
Left turn
Lights & turn signals
Daytime Running Light system (DRL) Automatically turns on under certain
conditions to make vehicle more visible to other drivers. Not for use at night.
Automatic light cut off system Automatically turns lights off after a 30 second
delay, or lock switch on remote is pushed after locking.
Automatic High Beam (AHB) system Automatically switches between high
and low beams as appropriate for enhanced vision at night.
Refer to Toyota Safety Sense™ (TSS) in this guide or the Owner’s Manual for more
details on the Automatic High Beam feature.
* Operating conditions must be met. Refer to Owner’s Manual for details.
Type AType B
HEADLIGHTS
Parking lights
Low beam
High beam
Auto High beam*or Auto Headlights
DRL OFFParking lights
DRL ONHeadlights
OFF
High beam flasher
TURN SIGNALS

17
Windows-Power
Windshield wipers & washers
Front fog lights come on only when the headlights are on low beam.
Turn OFFON
FRONT
*Intermittent windshield wiper
frequency adjustment Rotate to
increase/decrease wipe frequency.* Rain-sensing windshield wiper Rotate
to increase/decrease sensor sensitivity. Intermittent
Adjust frequency* Adjust frequency*Single wipeSingle wipe
Interval wipeInterval wipe
Slow
Slow
FastFastPull to wash
and wipePull to wash
and wipe Off
Off
Rain-sensing (if equipped)
REAR
Single wipe
Interval wipe
Off
Push to Wash and wipe
All window auto up/down Push the switch completely down or pull it completely
up and release to fully open or close. To stop window partway, lightly push the
switch in the opposite direction.
Window lock switch Deactivates all passenger windows. Driver’s window remains
operable.
Driver side
Up
Down
Window lock switch
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
'0(-*()54 *'&26*11&%

51
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Automatic High Beams (AHB)
ACTIVATING THE AHB SYSTEM
CONDITIONS WHERE AHB WILL TURN ON/OFF AUTOMATICALLY
When all of these conditions are met, high beams will be automatically turned on
BGUFSBQQSPYJNBUFMZTFDPOE

t7FIJDMFTQFFEJTBCPWFBQQSPYJNBUFMZNQI LNI

• The area ahead of the vehicle is dark.
• There are no oncoming or preceding vehicles with headlights or tail lights turned
on.
• There are few streetlights on the road ahead.
If any of these conditions occur, high beams will be automatically turned off:
t7FIJDMFTQFFEESPQTCFMPXBQQSPYJNBUFMZNQI LNI

• The area ahead of the vehicle is not dark.
• Oncoming or preceding vehicles have headlights or tail lights turned on.
• There are many streetlights on the road ahead. AHB is a safety system designed to help drivers see more of what’s ahead at
nighttime without and reduce glare for oncoming drivers, AHB uses an in-vehicle
camera to help detect the headlights of oncoming vehicles and tail lights of
preceding vehicles, then automatically switches between high and low beams
as appropriate to provide the most light possible and enhance forward visibility.
By using high beams more frequently, the system may allow earlier detection of
pedestrians and obstacles.
Refer to the Toyota Owner’s Manual for additional information on AHB operation,
settings adjustments, limitations, and precautions before attempting to use it.
(2) (1)

1SFTTUIFi
” switch.

1VTIMFWFSBXBZGSPNZPVXJUIUIFIFBEMJHIUTXJUDIJTJOUIFi
” or “AUTO”
position.
The AHB indicator will come on when the headlights are turned on automatically
to indicate that the system is active.
Note: Pull the lever back toward you or press the AHB switch to turn the AHB
system off.
The AHB indicator will turn off. To turn switch to “
” position and the manual
high beam indicator “
” turns on.