2019 SUBARU LEGACY height

3
Seating
Getting
Started
Power Driver’s Seat (if equipped)
Do not adjust the seat while driving.
1 Forward/Backward,
Angle and Height

Move the switch toward the front
or rear to move the seat forward
or backward. Pull the switch up
or push down on the front of the
switch to adjust the angle of the
seat cushion. Pulling the switch
straight up or pushing the switch
straight down will adjust the height
of the entire seat cushion.
2 Seatback

Move the switch in the
corresponding direction to adjust
the angle of the seatback.
3 Lumbar Support

Press the front part of the switch
to increase lumbar support;
press the rear part of the switch
to decrease lumbar support.
3
2
1
Memory Driver’s Seat (if equipped)
While pressing the “SET” button, press and hold the desired button “1” or “2”.
A beep sounds when the seat position is registered. Press button “1” or “2” to
retrieve the seat positions.
3645634_19b_Subaru_Legacy_QG_082818.indd 38/28/18 1:25 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

4
Heated Seats (if equipped)
Press the front seat heater switch. Each time you press the switch, the mode will change as
follows: High, Mid, Low, Off.
Seat Controls
Do not adjust the seat while driving.
1 Forward/Backward
Pull up on the lever below the front
of the driver’s seat to move the seat
forward or backward.
2 Raise/Lower Seat Cushion
To adjust the height of the driver’s seat,
pull up or push down the seat height
adjustment lever, located on the lower
left front of the seat.
3 Recline Seatback
To adjust the seatback to the desired position, pull up on the recline lever, located on the
lower left rear of the driver’s seat or lower right rear of the passenger’s seat.
Seating
1
23
3645634_19b_Subaru_Legacy_QG_082818.indd 48/28/18 1:26 PM

12
Personalize
Tilt and Telescopic Steering Column
Pull the lever down firmly to adjust the height and lengthwise positio\
n of the column; firmly push
the lever back up to lock the column in place. Do not adjust while drivi\
ng.
Heated Steering Wheel (if equipped)
To activate, pull the Heated Steering Wheel switch while the ignition is \
in the ON position.
The indicator light on the switch will illuminate.
To deactivate, pull the Heated Steering Wheel switch again.
3645634_19b_Subaru_Legacy_QG_082818.indd 128/28/18 1:26 PM