Page 18 of 256
“Care Connect” Services
Proactive service
Fig. 12
Buttons and warning lights of the Care Connect services
The proactive service provides an overview of the technical status of your ve-
hicle and on any due service events. It is also possible to establish a connection
to the information or breakdown call centre.
Buttons and warning lights of “Care Connect”services
Page 38 of 256
Instruments and warning lights
Instrument cluster
Page 40 of 256
Page 44 of 256
Page 48 of 256
Outside temperature
Warning lights
Driving data (multifunction display)
Total distance travelled
Distance travelled by resetting the memory (trip)
Cruise control / speed limiter
Service interval display
Information messages
Fuel gauge
Door, luggage compartment and bonnet alarm
When the door or luggage compartment / bonnet is open, a graphic warning appears in the display.
An acoustic signal will also sound if you drive the vehicle above 6 km/h when a
door is open.
Reset counter for distance travelled (trip)
Page 49 of 256
Certain functions and conditions of individual vehicle systems are checked
continuously when the ignition is switched on. If there is a fault in the system, the following message will appear in the display of the instrument cluster.
As long as the faults are not rectified the messages are always shown. After
the message is displayed for the first time, the warning lights
Page 62 of 256
WARNINGAlways adjust the headlight beam to meet the following conditions - other-
wise risk of accident.v
The vehicle does not dazzle other road users, especially oncoming vehi-
cles.
v
The beam range is sufficient for safe driving.
Note
v If, with a dipped beam, the ignition is turned off, then the dipped beam will
automatically switch off and the parking lights will come on. Does not apply to
the position , as long as the conditions are met for the COMING HOME
function . The parking lights are switched off when the ignition key is removed
(for vehicles with the KESSY system, after opening the driver
Page 165 of 256
Before negotiating a long or steep gradient , reduce speed and shift down a
gear. As a result, the braking effect of the engine will be used, reducing the
load on the brakes. If, nevertheless, there is a need for additional braking, it
should be carried out at intervals.
Emergency braking warning - if it is necessary to brake hard, the system may
cause the brake lights to automatically flash, to alert the traffic behind.
New brake pads must first be “run in” because these do not initially have the
best possible braking effect. Drive especially carefully for the first 200 km or
so.
If the brake fluid level is too low, it can cause faults in the braking system
