Page 7 of 256
Emergency unlocking/locking of doors220
Replacing windscreen wiper blades
221
Fuses and light bulbs
222
Fuses
222
Bulbs
226
Technical data
Technical data
231
Basic vehicle data
231
Vehicle-specific details per engine type
235
Index
5Table of Contents
Page 41 of 256
If the seat belt is not fastened by the driver or front passenger during the next
approx. 2 minutes, the warning signal is deactivated and the warning light i
illuminates permanently.
v v Power steering/steering lock (engine start with button
press)
Page 46 of 256
Fault on the engine oil level sensor
Page 90 of 256
NotevThe air inlet in front of the windscreen must be free of e.g. ice, snow or
leaves to ensure that the heating and cooling system operates properly.v
After switching on the cooling Condensation from the evaporator of the air
conditioning may drip down and form a puddle below the vehicle. This is not a
leak!
v
If the coolant temperature is too high, the cooling system is switched off to
ensure that the engine cools down.
Heating and manual air conditioning
Fig. 116
Controls of the heating / air conditioning
Page 98 of 256
If the vehicle is fitted with the starter button, Infotainment will switch off au-
tomatically after the engine is switched off and the door is opened.
With the ignition off, Infotainment will automatically switch off after about 30
minutes.
Infotainment switches off automatically under certain circumstances. Infotain-
ment informs you of this via a text message on the Infotainment display.
Infotainment restart
If Infotainment stops responding (if it “freezes”), it can be restarted by press-
ing and holding
for longer than 10 s (does not apply to Infotainment Blues).
Show time and date on the screen
Applies to Infotainment Columbus, Amundsen.
Standby mode
With the ignition on and infotainment off (Standbymode), it is possible to dis-
play the time and date on the Infotainment screen.
Applies to Infotainment Amundsen
Page 161 of 256
Driving
Starting-off and Driving
Starting and stopping the engine
Page 163 of 256
NotevThe engine running noises may be louder at first for a short time after start-
ing the cold engine.v
You should not switch on any major electrical components during the heating
period, otherwise the vehicle battery will be drained unnecessarily.
v
After switching off the ignition, the radiator fan may (also intermittently)
continue to operate for approx. 10 minutes.
Problems with starting the engine - Vehicles with starter button
Fig. 187
Starting the engine - Press the
button with the key
Page 165 of 256
Before negotiating a long or steep gradient , reduce speed and shift down a
gear. As a result, the braking effect of the engine will be used, reducing the
load on the brakes. If, nevertheless, there is a need for additional braking, it
should be carried out at intervals.
Emergency braking warning - if it is necessary to brake hard, the system may
cause the brake lights to automatically flash, to alert the traffic behind.
New brake pads must first be “run in” because these do not initially have the
best possible braking effect. Drive especially carefully for the first 200 km or
so.
If the brake fluid level is too low, it can cause faults in the braking system
