2019 Peugeot 208 Owner's Manual

31
F Turn the key towards the rear again within 5 seconds to deadlock the vehicle.
Lighting of the direction indicators for a
few
seconds confirms that the procedure has
completed correctly.
If your vehicle is fitted with an alarm, this
function will not be activated when locking
with the key.
If the alarm is activated, the siren sounds
on opening the door; switch on the ignition
to stop it.
Central locking not
functioning
Use these procedures in the following cases:
- c entral locking fault,
-
b

attery disconnected or discharged.
In the event of a
malfunction with the
central locking system, the battery must
be disconnected to lock the boot and thus
ensure that the vehicle is locked fully.
Driver's door
F Turn the key towards the rear of the vehicle to lock it, or towards the front to unlock it.
Passenger doors
Unlocking
F P ull the interior door opening handle.
Locking
F

O
pen the door.
F

F
or the rear doors, check that the child lock
is not activated. Refer to the corresponding
section.
F

R
emove the black cap, located on the edge
of the door, using the key.
F

I
nsert the key into the hole without forcing
it; then, without turning it, move the latch
sideways towards the inside of the door.
F

R
emove the key and refit the black cap.
F

C
lose the doors and check from the
outside that the vehicle is locked.
Changing the battery
If the battery is flat, you are informed
by illumination of this warning lamp,
an audible signal and a
message in
the screen. Batter y ref.: CR1620/3
volts.
F
U
nclip the cover by inserting a small
screwdriver in the slot and raise the cover.
F
R
emove the discharged battery from its
housing.
F
I
nsert the new battery, observing the
polarity, and clip the cover onto the
housing.
F
R
einitialise the remote control.
For more information on Reinitialising the
remote control , refer to the corresponding
section.
Do not throw remote control batteries
away as they contain metals which are
harmful to the environment. Take them
to an approved collection point.
2
Access

32
Reinitialising the remote
control
Following replacement of the battery or in
the event of a remote control fault, it may be
necessary to reinitialise the remote control.
F

S
witch off the ignition.
F

T
urn the key to position 2

(Ignition on).
F

P
ress the closed padlock button for a few
seconds.
F

S
witch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Boot
Opening
F After unlocking the boot or the vehicle using the remote control or the key, press
the opening control, then raise the tailgate.
Closing
F Lower the tailgate using the interior grab handle.
F

I
f necessary, press down on the tailgate to
fully close it.
If the tailgate is not fully closed:
-

w
ith the engine running ,
this warning lamp comes on,
accompanied by the display of an
alert message for a
few seconds,
-

w
hen driving (speed above 6
mph
(10
km/h)), this warning lamp comes on,
associated with an audible signal and
the display of an alert message for a
few
seconds. In the event of a
fault or difficulties felt in
manoeuvring the tailgate when opening
or closing it, have it quickly checked
by a PEUGEOT dealer or a qualified
workshop to stop this issue getting worse
and so as to not cause the tailgate to drop,
and serious injuries.
Backup control
System for mechanical unlocking of the boot in
the event of a central locking malfunction.
Unlocking
F Fold the rear seats to gain access to the lock from inside the boot.
F

I
nsert a small screwdriver into hole A of the
lock to unlock the boot.
F

M
ove the latch to the left.
Access

33
In the event of a fault with the central
l ocking system, it is essential to
disconnect the battery to lock the boot and
so ensure complete locking of the vehicle.
Alarm
System which protects and provides a deterrent
a gainst theft and break-ins. It provides the
following types of monitoring:
-

E
xterior perimeter :
T

he system checks whether the vehicle is
opened. The alarm is triggered if anyone
tries to open a
door, the boot or the bonnet.
-

I
nterior volumetric :
T

he system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks
a


window, enters the passenger
compartment or moves inside the vehicle. Self-protection function
: the system
checks for the putting out of ser vice of its
own components. The alarm is triggered
if the battery, button or siren wiring is
disconnected or damaged.
For all work on the alarm system, contact
a PEUGEOT dealer or a qualified
workshop.
Locking the vehicle with full
alarm system
Activation
F Turn the ignition off and exit the vehicle.
The exterior perimeter monitoring is activated
after 5
seconds and the interior volumetric
monitoring after 45


seconds.
F

L
ock or deadlock the vehicle
using the remote control.
When the monitoring system is active, the
indicator lamp in the button flashes once per
second and the direction indicators come on for
about 2


seconds. If an opening (door, boot, bonnet, etc.)
is incorrectly closed, the vehicle is
not locked, but the exterior perimeter
monitoring will be activated after
45
seconds, at the same time as the
interior volumetric monitoring.
Deactivation
F Press the remote control unlocking button.
The monitoring system is
deactivated: the indicator lamp in
the button goes off and the direction
indicators flash for about 2
seconds.
If the vehicle automatically locks itself
again (as happens if a
door or the boot
is not opened within 30
seconds of
unlocking), the monitoring system is
automatically reactivated.
Triggering of the alarm
This is indicated by sounding of the siren
and flashing of the direction indicators for
30


seconds.
The monitoring functions remain active until
the alarm has been triggered ten times in
succession.
2
Access

34
When the vehicle is unlocked using the remote
control, rapid flashing of the indicator lamp
in the button informs you that the alarm was
triggered during your absence. When the
ignition is switched on, this flashing stops
immediately.
Locking the vehicle
with exterior perimeter
monitoring only
Deactivate the interior volumetric monitoring
to avoid unwanted triggering of the alarm in
certain cases such as:
-
l
eaving a pet in the vehicle,
-
l

eaving a

window partially open,
-
w

ashing your vehicle,
-
c

hanging a

wheel,
-

h
aving your vehicle towed,
-
t

ransport by ship.
Deactivating the interior
volumetric monitoring
F Switch off the ignition and within ten seconds, press this button
until the indicator lamp is on
fixed.
F

G

et out of the vehicle.
F

I

mmediately lock the vehicle using the
remote control.
The exterior perimeter monitoring alone is
activated: the indicator lamp in the button
flashes once per second.
Reactivating the interior
volumetric monitoring
F Deactivate the exterior perimeter monitoring by unlocking the vehicle using
the remote control.
F

R
eactivate the alarm system normally.
Locking the vehicle without
activating the alarm
F Lock or deadlock the vehicle using the key (integral to the remote control) in the
driver's door lock.
Failure of the remote
control
To deactivate the monitoring functions:
F U nlock the vehicle using the key (integral to
the remote control) in the driver's door lock,
F

O
pen the door; this sets off the alarm.
F

U
pon switching on the ignition the alarm
stops. The indicator lamp in the button
goes off.
Operating fault
When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a
fault with the system.
Have it checked by a
PEUGEOT dealer or
a


qualified workshop.
To take effect, this deactivation must be carried
out after each time the ignition is switched off.
Electric windows
Manual operation
To open or close the window, press or pull the
switch gently, without exceeding the point of
resistance. The window stops as soon as the
switch is released. 1.
Left-hand front.
2. Right-hand front.
3. Right-hand rear.
4. Left-hand rear.
5. Deactivation of the electric window controls
located at the rear seats.
Access

35
Automatic operation
To open or close the window, press or pull the
switch fully, beyond the point of resistance: the
window opens or closes completely when the
switch is released. Pressing the switch again
stops the movement of the window.The electric window switches remain
operational for approximately 45


seconds
after switching off the ignition.
Once this time has elapsed, the electric
windows will not operate. To reactivate
them, switch the ignition on again.
Safety anti-pinch
When the window rises and meets an obstacle,
it stops and immediately partially lowers again.
To reinitialise normal operation , press the
switch until the window opens completely, then
pull the switch immediately until the window
closes fully. Continue to hold the switch for
approximately one more second.
The safety anti-pinch function is not active
during this operation.
Deactivation of the rear
controls for the rear electric
windows
The red indicator lamp in the button comes
on, accompanied by a message confirming
activation of the system. It remains on for as
long as the deactivation is maintained.
Use of the rear electric windows from the
driver's controls remains possible.
Reinitialising the electric
windows
Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch function is not active
during these operations.
For each window:
-

b
ring the window down completely, then
bring it back up. It will go up by a
few
centimetres each time. Per form the
operation again until the window is fully
closed,
-

c
ontinue to pull the switch for at least one
second after reaching the window closed
position.
In the event of pinching during operation
of the windows, you must reverse the
movement of the window. To do this, press
the switch in question.
Be particularly aware of children when
operating the windows.
For your children's safety, press control 5

to
deactivate the controls for the rear electric
windows, irrespective of their positions.
2
Access

36
PEUGEOT i-Cockpit
Once these adjustments have been made,
make sure that the "head-up" instrument
panel can be viewed correctly over the
smaller diameter steering wheel.
Steering wheel adjustment
For safety reasons, these adjustments
must only be made with the vehicle
stationary.
Mirrors
Door mirrors
As a safety measure, the mirrors should
b e adjusted to reduce the "blind spot".
Manual adjustments
F Operate the lever in the four directions to adjust the angle of the mirror glass.
Folding
F

F
old the mirror manually to protect it when
the vehicle is parked.
F

U
nfold it before moving off again.
They do not have automatic defrosting.
F

W

ith the vehicle stationary
, pull the
control lever to release the steering wheel.
F

A

djust the height and reach to suit your
driving position.
F

P

ush the control lever to lock the adjustment
mechanism.
Before taking to the road and in order to take
advantage of the specific ergonomics of the
PEUGEOT i-Cockpit, adjust it in the following order:
-

t
he height of the head restraint,
-

t
he seat backrest angle,
-
t

he seat cushion height,
-

t
he longitudinal position of the seat,
-
t

he depth and then the height of the steering
wheel,
-

t
he rear view mirror and door mirrors.
Ease of use and comfort

37
Electric adjustments
F Move control A to the right or to the left to select the corresponding mirror.
F

M
ove control B in any of the four directions
to adjust.
F

R
eturn control A to the central position.
Folding/unfolding
Lock the vehicle using the remote control or the
key; the mirrors will fold.
Unlock the vehicle using the remote control or
the key; the mirrors will unfold.
F

W
ith the ignition on, pull control A
rear wards to fold the mirrors.
F

P
ull it again to unfold them.
If the mirrors are folded using control A ,
they will not unfold when the vehicle is
unlocked. Pull again on control A .The objects obser ved are, in reality, closer
than they appear.
Take this into account in order to
correctly judge the distance of vehicles
approaching from behind.
The folding and unfolding of the door
mirrors using the remote control can be
deactivated by a
PEUGEOT dealer or
a


qualified workshop.
Fold the mirrors when putting your vehicle
through an automatic car wash.
If necessary, the mirrors can be folded
manually.
Rear view mirror
Equipped with an anti-dazzle system, which
darkens the mirror glass and reduces the
nuisance to the driver caused by the sun,
headlamps of other vehicles, etc.
Manual model
Adjustment
F A djust the mirror so that the mirror is
directed correctly in the "day" position. Day/night position
F

P
ull the lever to change to the "night" anti-
dazzle position.
F
P
ush the lever to change to the normal
"day" position.
Automatic " electrochrome " model
This system automatically and progressively
changes between day and night use by means
of a

s
ensor measuring the light coming from the
rear of the vehicle.
3
Ease of use and comfort

38
Seat backrest angle
F Press the control backwards.
Head restraints
F To raise a head restraint, pull it upwards.
F T o remove it, press the lug A and pull upwards.
F

T
o refit the head restraint back in place,
engage the head restraint rods in the openings
keeping them in line with the seat backrest.
F

T
o lower a head restraint, press the lug A and
push down on the head restraint at the same
time.
The head restraint has a frame with
n otches which prevents it from lowering;
this is a
safety device in case of impact.
The adjustment is correct when the
upper edge of the head restraint is
level with the top of the head.
Never drive with the head restraints
removed; they must be fitted and correctly
adjusted.
In order to ensure optimum visibility during
your manoeuvres, the mirror lightens
automatically when reverse gear is
engaged.
Front seats
Before moving the seat backwards,
ensure that there is nothing that might
prevent the full travel of the seat.
There is a
risk of trapping or pinching
passengers if present in the rear seats
or jamming the seat if large objects are
placed on the floor behind the seat.
Standard seats
Longitudinal adjustment
F Raise the control and slide the seat forwards or backwards.
Height adjustment
F Pull the control upwards to raise or push it downwards to lower, as many times as
necessary to obtain the position required.
Ease of use and comfort